Question is ⇒ With respect to the differential amplifier configuration shown below, the differential gain Ad will, Options are ⇒ (A) 273.63, (B) 213.63, (C) 113.63, (D) 233.63, (E) , Leave your comments or Download question paper.

Question is ⇒ With respect to the differential amplifier configuration shown below, the differential gain Ad will, Options are ⇒ (A) 273.63, (B) 213.63, (C) 113.63, (D) 233.63, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	With respect to the differential amplifier configuration shown below, the differential gain A_d will
A.	273.63 [Wrong Answer]
B.	213.63 [Correct Answer]
C.	113.63 [Wrong Answer]
D.	233.63 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Values of V_T at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒ In figure, thyristor Th is in off state. When thyristor is turned on, the peak thyristor current can
0.208333333333333
0.416666666666667
15 A
20 A

⇒ The following k-map implem
BCD to Decimal Decoder
Decimal to BCD Encoder
1 of 10 Decoder
(a) and (c)

⇒ For the two ports in figure, y₁₁ = 8 mho, y₁₂ = y₂₁ = -6 mho and y₂₂ = 6 mho. The values of Y_A, Y_B, Y_C respectively
2, 6, 6 mho
2, 6, 0 mho
2, 0, 6 mho
2, 6, 8 mho

⇒ The output y(t) of a continuous-time system S for the input x(t) is given
S is linear and time-invariant
S is linear and time-varying
S is non-linear and time-invariant
S is non-linear and time-varying

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T²I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	M^-1L^-2T⁴I²
D.	Reluctance	4.	ML²T^-3I^-2

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-4, B-2, C-3, D-1
A-2, B-4, C-3, D-1

⇒ An exponential amplifier has diode in feedback path.
TRUE
FALSE

⇒

Assertion (A): A graph is planar if it has a dual.

Reason (R): The dual of a graph can be found by window dot method.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒ The value of current at resonance in series R-L-C circuit is affected by the value of
C
L
R
all of the above

⇒ Which of the following is not correct in respect of electrostatic instrument?
It is essentially a voltmeter
It is suitable for only high voltages
It has a uniform scale
It can be used for both ac and dc

⇒ For a full wave bridge rectifier supplied with 50 Hz a.c., the lowest ripple frequency will be
50 Hz
100 Hz
200 Hz
400 Hz

⇒ Which of the following lines behaves as infinite line?
a line terminated in inductance
a line terminated in capacitance
a short line
a line terminated in z₀

⇒ For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average valu
70.7 V
63.7 V
54 V
15 V

⇒

Assertion (A): It is not desirable to drive a transistor into hard saturation in high speed switching circuits.

Reason (R): It may not be possible to bring it back to cutoff state, if it is driven into hard saturation.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function

⇒ The dielectric losses do not depend on frequency.
TRUE
FALSE

⇒ The rate at which information can be carried through a communication channel depends on
carrier frequency
bandwidth
transmission loss
transmitted power

⇒ The time constant of a series RL circuit is
LR
L/R
R/L
e^-R/L

⇒

Assertion (A): In C arithmetic operations are pemiissible on ints, floats and chars.

Reason (R): In C every arithmetic operator must be written explicitly.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The correct relation between joules and calories is
calories = joules/4.156
joules = calories/4.156
calories = joules x 10⁷/4.156
joules = calories x 10⁷/4.156

⇒ The dc output voltage of the circui
4.3 V
1.369 V
3.87 V
1.94 V

⇒ The theoretical maximum efficiency of a half wave diode rectifier is
0.406
0.5
0.812
slightly less than 100%

⇒

Match the following:

	List I		List II
A.	Ring modulator	1.	Clock recovery
B.	VCO	2.	Demodulation of FM
C.	Foster Seeley discriminator	3.	Frequency conversion
D.	Mixer	4.	Summing of two points
		5.	Generation of FM
		6.	Generation of DSB-SC

A-1, B-3, C-2, D-4
A-6, B-5, C-2, D-3
A-6, B-1, C-3, D-2
A-5, B-6, C-1, D-3

⇒

Assertion (A): Damping in a vibration galvanometer is small.

Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The expression for satellite link frequencies such as 4/6 GHz denotes that
4 GHz is the up-link and 6 GHz is the down-link frequency
4 GHz is the down-link and 6 GHz is the up-link frequency
the system operates at a mean frequency of 5 GHz
one frequency is used as a back up for the other

⇒ The scale of moving iron instrument is linear.
TRUE
FALSE