Question is ⇒ A tachometer has a sensitivity of 4 V/1000 <i>rpm</i>. Express the gain constant of the tachometer in the units volts/(rad/sec)., Options are ⇒ (A) 0.0489, (B) 0.0381, (C) 2, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ A tachometer has a sensitivity of 4 V/1000 <i>rpm</i>. Express the gain constant of the tachometer in the units volts/(rad/sec)., Options are ⇒ (A) 0.0489, (B) 0.0381, (C) 2, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A tachometer has a sensitivity of 4 V/1000 rpm. Express the gain constant of the tachometer in the units volts/(rad/sec).
A.	0.0489 [Wrong Answer]
B.	0.0381 [Correct Answer]
C.	2 [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ MS outlook is a software for DTP.
TRUE
FALSE

⇒ If a 'live' conductor of a public supply touches earth metal
supply voltage will increase
supply voltage will decrease
no current will flow
current will flow to earth

⇒ The simplest mixer circuit for public address system uses
fixed resistances
variable resistances
inductances
capacitances

⇒

Assertion (A): C has a large number of library functions classified as arithmetic functions, data conversion functions, character classified functions, string manipulation functions, searching and sorting functions etc.

Reason (R): 8086 uses a segment : offset addressing scheme.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a TWT the phase velocity of the axial component of the field on the slow wave structure is kept
equal to velocity of electron
slightly less than velocity of electron
slightly more than velocity of electron
equal to velocity of light in free space

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ In integral cycle control of ac regulator, the input power factor is equal to
duty cycle a
a²
a
(a)^1/3

⇒ Which language has a preprocessor?
Fortran 77
Pascal
C
None of the above

⇒ For an N bit ADC, the percentage resolution is [1/2^N - 1)] 100.
TRUE
FALSE

⇒ The effective length of antenna is different from actual length due to
top loading
end effects
both (a) and (b)
none of the above

⇒

Assertion (A): A dynamic RAM chip has much smaller cell than a static RAM chip.

Reason (R): In dynamic RAM one bit of information is stored as the charge on a capacitor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Gain of an antenna with a circular aperture of diameter 4 meter at frequency of 10 GHz, with directivity 60
60
100
30
90

⇒ 50 independent low pass signals of bandwidth W, 2W, 3W, W, 2W, 3W, W, 2W, 3W Hz are to be time division multiplexer on a common channel using PAM. To achieve this, the minimum transmission capacity of the channel should be __________ .
1 Hz
12 Hz
3 Hz
6 Hz

⇒ A function table is required in very large numbers the memory most switched for this purpose would be
ROM
PROM
EPROM
EAROM

⇒ The inductance of a coil can be increased by
choosing core material having high relative permeability
decreasing diameter of the former
decreasing the number of turns
increasing core length

⇒ The reflection coefficient on a 500 m long transmission line has a phase angle of - 150°. If the operating wavelength is 150 m, what will be the number of voltage maxima on the line?
0
3
6
7

⇒ In a rectifier circuit the filter capacitance is increased. Then the ripple will
increase
decrease
remain the same
either (a) or (b)

⇒ The current i(t) through a 10 Ω resistor in series with an inductance is given by i(t) = 3 + 4 sin (100t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W respectively
35 A, 350 W respectively
5 A, 250 W respectively
11 A, 1210 W respectively

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ Debye temperature of metals is
about 10 K
about 200 K
about 600 K
about 2 K

⇒ In the series circuit shown in figure, for series resonance, the value of the coupling coefficient, K wil
0.25
0.5
0.1
1

⇒ In low power factor wattmeter, the pressure coil is connected
to the supply side of current coil
to the load side of current coil
in either (a) or (b)
across the mains

⇒ Magnetic deflection sensitivity is defined as
deflection/flux density
(deflection/flux density)^0.5
(Deflection)^0.5/flux density
none of the above

⇒ In 8085
the upper 8 address bits appear on address bus and lower 8 bits on address data bus
the lower 8 address bits appear on address bus and the upper 8 address bits appear on address data bus
either upper or lower 8 address bits may appear at address bus
either upper or lower 8 address bits may appear at address data bus

⇒ In a full wave rectifier, the current in each of the diodes flows for
the complete cycle of the input signal
half cycle of the input signal
less than half cycle of the input signal
one-fourth cycle of the input signal

⇒ Kirchoff's laws are applicable to
steady state conditions only
transient conditions only
both steady state and transient condition
both steady state and transient condition but with some constraints

⇒ Which of the following amplifier circuit using junction transistor has the best gain?
Common base
Common emitter
Common collector
All have the same gain

⇒ Spontaneous magnetisation is characteristic of ferromagnetic materials.
TRUE
FALSE

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The quantization step is :
1 x 10^-9 V
5 x 10^-9 V
2.5 x 10^-9 V
0.5 x 10^-9 V

⇒ A signal is x + f(t) where x is constant and f(t) is a power signal with zero mean value. The power of the signal is
x²
x² + f²(t)
more than x² + f²(t)
less than x² + f²(t)