Question is ⇒ The time constant of the capacitance circuit is defined as the time during which voltage, Options are ⇒ (A) falls to 36.8% of its final steady value, (B) rises to 38.6% of its final steady value, (C) rises to 63.2% of its final steady value., (D) none of the above., (E) , Leave your comments or Download question paper.

Question is ⇒ The time constant of the capacitance circuit is defined as the time during which voltage, Options are ⇒ (A) falls to 36.8% of its final steady value, (B) rises to 38.6% of its final steady value, (C) rises to 63.2% of its final steady value., (D) none of the above., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The time constant of the capacitance circuit is defined as the time during which voltage
A.	falls to 36.8% of its final steady value [Wrong Answer]
B.	rises to 38.6% of its final steady value [Wrong Answer]
C.	rises to 63.2% of its final steady value. [Correct Answer]
D.	none of the above. [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 4 : 1 multiplexer requires __________ data select line.
1
2
3
4

⇒ A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is
83.33 μ sec
1 μ sec
0.1 m sec
3.5 m sec

⇒ Which of the following voltmeters would you use for measuring voltage across 20 kΩ resistance?
Voltmeter having a resistance of 5 kΩ
Voltmeter having a sensitivity of 1 kW/V
Voltmeter having sensitivity of 10 kW/V
None of the above

⇒ Transit time is considered as significant at
HF
MF
LF
all of the above

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In common base configuration, the input characteristics of bipolar junction transistor are drawn between
V_EB and I_E
V_CB and I_C
I_C and V_CE
I_E and V_CE

⇒ The following statements are true with respect to "Cascode Amplifier".

The reduction in h₁₂ and Miller capacitance result in negligible reverse internal feedback.
A's is large loads cannot be connected.
As a narrow band amplifier, it provides small range of c_μ is reduced.
As a narrow band amplifier it provides small range of frequencies parameters the effect of c_μ reduces.

only 1
only 1 and 4
only 2 and 4
only 1 and 3

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ In a colour TV receiver the bandwidth of RF amplifier is
exactly equal to channel width
a little less than channel width
a little more than channel width
either (a) or (b)

⇒ Two resistances R₁ = 18.7 Ω. and R₂ = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is
22.324 Ω
22.32 Ω
22.3 Ω
22 Ω

⇒ Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?
Differentiating amplifier
Integrating amplifier
Logarithmic amplifier
Exponential amplifier

⇒ In a radio receiver the input from local oscillator is fed to
RF amplifier
mixer
IF amplifier
detector

⇒ Nibble is
a string of 4 bits
a string of 8 bits
a string of 16 bit
a string of 64 bits

⇒ Which has the highest power dissipation per gate?
ECL
TTL
CMOS
PMOS

⇒ - 56 is not a valid real constant in Fortran.
TRUE
FALSE

⇒ The given figure shows a K-map for a Boolean function. The number of essential prime implicant
4
5
6
8

⇒ An excitation is applied to a system at t = T, and its response is zero for -∞ < t < T, such a system is
non-causal system
Stable system
causal system
unstable system

⇒ In a 3 phase semiconverter, the output voltage becomes discontinuous for
firing angle > 30°
firing angle > 60°
firing angle > 90°
firing angle > 120°

⇒ Which of the following contributes to harmonics distortion in amplifiers?
Positive feedback
Presence of noise
Defective active device
Non-linearity in active device

⇒ The stationary process has
all the statistical Properties dependent on time.
all the statistical Properties independent of time.
aime average is equal to ensemble average.
zero variance.

⇒ If a RAM has 34 bits in its MAR and 16 bits in its MDR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ A class C amplifier uses
high Q tuned circuit
low Q tuned circuit
untuned circuit
either (b) or (c)

⇒ Antenna used for direction finding is
long dipole
parabolic
rhombic
helical

⇒ With 2's complement representation, the range of values that can be represented on the data bus of an 8 bit microprocessor is given by
-128 to 127
-128 to +128
-127 to 128
-256 to 256

⇒ The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about
1 μs
10 μs
100 μs
none of the above

⇒ The input impedance for a half dipole if radii of both the antenna is 4 and 8 meter respectively
600 Ω
100 Ω
657 Ω
650 Ω

⇒ A fully charged mobile phone with a 12 V battery is good for a 20 minute talktime. Assume that, during the talk time, the battery delivers a constant current of 2 A and its voltage drops linearly from 12 V to 10 V as shown in the figure. How much energy does the battery deliver during this talk t
220 J
12 kJ
13.2 kJ
14.4 kJ

⇒ If V = 100 ∠ 16°, the (V) is
10 ∠ 32°
10 ∠ 8°
10 ∠ 16°
10 ∠ 4°

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ In the case of a 70-MHz IF carrier for a transponder bandwidth of 36 MHz, energy must lie between MHz.
34 and 106
52 and 88
106 and 142
34 and 142