Question is ⇒ A current is flowing through a conductor with non-uniform area of cross-section. Then, Options are ⇒ (A) current will be different at different cross-sections., (B) current will be the same at all the cross-sections., (C) current will be different but current density will be same at all the cross-sections, (D) current will be the same but current density will be different at different cross-sections., (E) , Leave your comments or Download question paper.

Question is ⇒ A current is flowing through a conductor with non-uniform area of cross-section. Then, Options are ⇒ (A) current will be different at different cross-sections., (B) current will be the same at all the cross-sections., (C) current will be different but current density will be same at all the cross-sections, (D) current will be the same but current density will be different at different cross-sections., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A current is flowing through a conductor with non-uniform area of cross-section. Then
A.	current will be different at different cross-sections. [Wrong Answer]
B.	current will be the same at all the cross-sections. [Wrong Answer]
C.	current will be different but current density will be same at all the cross-sections [Wrong Answer]
D.	current will be the same but current density will be different at different cross-sections. [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ During day time ionosphere consist of
D, E, F₂ layers
D, E, F layers
D, E, F₁, F₂ layer
none

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒

Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors

Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In figure, capacitor is uncharged. The switch is closed at t = 0 at t = 0⁺ di/dt100 A/s
-100 A/s
1000 A/s
-1000 A/s

⇒ When the height of a vertical earthed antenna is less than λ/4
the base input impedance will be capacitive
the base input impedance will be purely resistive
the base input impedance will be inductive
the base input impedance will be negligibly small

⇒ In a resistance loaded amplifier, the gain decreases at high frequencies because
decreasing reactance of the stray C_T
increasing reactance of the stray C_T
increasing reactance of C_T
decreasing reactance of C_T

⇒ In 8086 a word OA 50 FH is stored in 02 and 03 memory locations. Then
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 02
OFH is stored at location 03 and 0 A 5 at location 02 and address of word in 02
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 03
OFH is stored at location 03 and 0 A 5 at location 02 and address of word is 03

⇒ For a FM wave carrier modulating frequency is 10 kHz and bandwidth is 2 MHz. If the modulating signal amplitude is doubled, the bandwidth will be
0.5 MHz
1 MHz
2 MHz
4 MHz

⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low

⇒ Fundamental mode is another name for
level operation
pulse operation
clock operation
none of these

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ The boolean expression for shaded area in the given figur
AB + AC
ABC + ABC
ABC + ABC
None of these

⇒ In every practical oscillator, the loop gain is slightly larger than unity and the amplitude of the oscillations is limited by the
magnitude of the loop gain
onset if non-linearity
magnitude of gain of the amplifier
feedback transmission factor

⇒ The light output of LED varies as (current)ⁿ. The value of n is about
0.5
1
1.3
2.1

⇒ Which of the following is a circularly polarized antenna?
Rhombic
Circular loop
Helical
Yagi

⇒ Which of the following is same in AM and FM receivers?
Demodulator
AGC
IF amplifier
All of the above

⇒ The numerical value of directivity of current element of half-wave dipole is 1.76 and 2.15 dB respectively. The directive gain of half-wave dipole over current element will be
3.91 dB
1.95 dB
0.39 dB
0.195 dB

⇒ Which are of the following oscillators is well suited for the generation of wide range audio-frequency sine waves?
RC phase-shift oscillator
Wien-bridge oscillator
Colpitts oscillator
Hartley oscillator

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ The characteristic equation of flip-flop gives the next state Q_{N + 1} in terms of present state Q_N and the inputs. Which one of the following is the characteristic equation of J - K flip-flop?
Q_N+1 = JQ_N + KQ_N
Q_N+1 = J + KQ_N
Q_N+1 = KQ_N + JQ_N
Q_N+1 = K + JQ_N

⇒ Homodyne detection means
coherent detection
non-coherent detection
asynchronous detection
none of the above

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ The Truth Table shown is f
CMO
counter
flip-flop
half adder

⇒ A geostationary satellite
is located at a height of 358, 00 km
appears stationary over earth's magnetic pole
is motionless in space but keeps spinning
orbits the earth within a 24 hour period

⇒ Some of MOS families are PMOS, NMOS, CMOS. The family dominating the LSI field where low power consumption is necessary is
NMOS
CMOS
PMOS
both NMOS and CMOS

⇒ In radar system if the antenna diameter is increased by a factor of 4, the minimum range will increased by a factor of
1
2
22
4

⇒ In 8085 microprocessor, what is the memory word size?
6 bits
8 bits
12 bits
16 bits

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math