Question is ⇒ The more negative gate voltage, the conductive channel becomes, Options are ⇒ (A) narrower, (B) wider, (C) thicker, (D) linear, (E) , Leave your comments or Download question paper.

Question is ⇒ The more negative gate voltage, the conductive channel becomes, Options are ⇒ (A) narrower, (B) wider, (C) thicker, (D) linear, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The more negative gate voltage, the conductive channel becomes
A.	narrower [Correct Answer]
B.	wider [Wrong Answer]
C.	thicker [Wrong Answer]
D.	linear [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements

Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
Ridge wave guide has higher conductor losser than a rectangular waveguide.
Ridge guide has higher conductor losser than a rectangular waveguide.

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
2 and 3 only
All

⇒ Which of the following is invalid integer variable name in Fortran?
IAEG
I 124
AILG
MI AC

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ Which of the following is not a key word in C?
pop
for
if
union

⇒ In a digital system, the maximum clock frequency that can be used with Master/Slave Clocked flip-flops having total propagation delay of 200 μsec is
20 MHz
50 MHz
100 MHz
200 MHz

⇒ Typical size of digital IC is about
1″ x 1″
2″ x 2″
0.1″ x 0.1″
0.001″ x 0.001″

⇒ Consider the amplitude modulated (AM) signal A_c cos ω_ct + 2 cos ω_mt cos ω_ct For demodulating the signal using envelope detector, the minimum value of A_c should be
2
1
0.5
0

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ A piece of copper and another piece of Germanium are cooled from 30°C to 80 K. The resistance of
copper decreases and germanium increases
both decreases
both increases
copper increases and germanium decreases

⇒ For the circuit in figure, fed by a unit step voltage, v_{c1 - e^-t/RC
e^-t/RC
e^t/RC
1}

⇒ It is required to increase the maximum range of a radar by a factor of two. The peak power transmitted in the radar system has to be increased by a factor of
2
4
8
16

⇒ Impedance inversion may be obtained with
a short circuited stub
a quarter wave line
an open circuited stub
a half wave line

⇒ When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is
zero
constant
alternating
distorted

⇒ When a substance is repelled by a magnetic field it is known as
ferromagnetic
antiferromagnetic
diamagnetic
paramagnetic

⇒ In a low level amplitude modulated system, the amplifier modulated stage must be
class C
linear
non linear
harmonic

⇒ At millimeter wavelength the favoured mode in circular wave guide is
TE₀₁
TE₁₁
TE₂₀
TE₂₁

⇒ Which of the following material has nearly zero temperature-coefficient of resistance?
Carbon
Porcelain
Copper
Manganin

⇒ In ferromagnetic materials
the atomic magnetic moments are antiparallel and unequal
the atomic magnetic moments are parallel
the constituent is iron only
one of the constituents is iron

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ The ac motor used in servo applications is
single phase induction motor
two phase induction motor
3 phase induction motor
synchronous motor

⇒ In a FET, g_m varies as
I_DS
I_DS2
1/IDS
I_DS

⇒ The basic shift register operations are
serial in - serial out
serial in - parallel out
parallel in - serial out
all of the above

⇒ For the transport lag G(jω) = e^-jωT, the polar plot is
a semi circle
a circle
a unit circle
none of the above

⇒

P(s) = s⁴ + s³ + 2s² + 4s + 3
Q(s) = s⁴ + 2s³ + s

Which one of the following statements in correct for above P(s) and Q(s) polynomials?
Both P(s) and Q(s) are Hurwitz
Both P(s) and Q(s) are non-Hurwitz
P(s) is Hurwitz but Q(s) is non-Hurwitz
P(s) is non-Hurwitz but Q(s) is Hurwitz

⇒ For real and odd signals, the Fourier series coefficient a_k is __________ .
purely imaginary and even
purely real and even
purely imaginary and odd
purely real and odd

⇒ In a CE amplifier the dc load line is the same as ac load line when
ac collector resistance and dc collector resistance are equal
ac collector resistance and dc emitter resistance are equal
ac collector resistance is very high
ac collector resistance is one half of dc collector resistance

⇒ In figure the effective resistance faced by voltage source
1 Ω
2 Ω
3 Ω
3.3 Ω

⇒ RAMs can be built with bipolar or CMOS transistor RAMs that are not possible with bipolar transistors are
SRAM
SRAM, DRAM
DRAM
PROM

⇒ Which of the following is not a valid variable in FORTRAN 77?
BRG
VS
VS 3A
3 VSA

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5