Question is ⇒ In a D-type latch EN = 1, D = 1, the O/P is, Options are ⇒ (A) 1, (B) 0, (C) don't care, (D) blocked, (E) , Leave your comments or Download question paper.

Question is ⇒ In a D-type latch EN = 1, D = 1, the O/P is, Options are ⇒ (A) 1, (B) 0, (C) don't care, (D) blocked, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a D-type latch EN = 1, D = 1, the O/P is
A.	1 [Correct Answer]
B.	0 [Wrong Answer]
C.	don't care [Wrong Answer]
D.	blocked [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ Which of the following array names in Fortran 77 is invalid?
A(6)
A(R)
A(I)
A(N)

⇒ A microstrip line has dielectric having relative permittivity ∈_r. The effective dielectric constant is
more than ∈_r
equal to 1
less than ∈_r
either a or b

⇒

Match the following:

	List I (Form)		List II (Network)
A.	Cauer I	1.	L in series arm and C in shunt arm of ladder
B.	Cauer II	2.	C in series arm and L in shunt arm of ladder
C.	Foster I	3.	Series combination of L and C in parallel
D.	Foster II	4.	Parallel combination of L and C in series

A-1, B-2, C-3, D-4
A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4

⇒ The intrinsic resistivity of silicon at 300 K is about
1 Ω-cm
400 Ω-cm
10000 Ω-cm
230000 Ω-cm

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ Greatest mobility can be expected in case of
holes
protons
electrons
negative ions

⇒ Point out the false statement
impulse noise voltage does not depend on bandwidth
thermal noise is independent of frequency at which it is measured
industrial noise is mostly of impulse type
space noise is observable at frequencies in the range of 8 MHz and higher

⇒ Consider the following statements as regards SAW filter

The centre frequency is determined by the pitch of IDT comb shaped electrodes
The response can be modified shaping the overlap of comb electrodes
The response is maximum when acoustic wave has its wavelength equal to pitch
When a number of identical electrodes are arranged at the same pitch, the frequency characteristics of the filter is expressed by (sin x)/x

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3 only
1, 2, 4 only
2, 3, 4 only

⇒ A capacitor does not allow sudden changes
in currents
in voltage
in both current and voltage
neither of two

⇒ Fourier transform pair are
autocorrelation and power spectral density
autocorrelation and convoloution
convolution and power spectral density
autocorrelation and energy

⇒ The unit of displacement density is
volt/metre
ampere/metre²
coulombs/metre
coulombs/metre²

⇒ A seven bit code (even parity) 1111101 may have error. The correct code is
1111101
1111111
101011
1100011

⇒ Which circuit has its output signal from, the emitter?
Common base
Common emitter
Emitter follower
None of the above

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz

⇒ In broadside array
the principle direction radiation is perpendicular to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and perpendicular to the plane containing the array elements
the principle direction radiation is perpendicular to the array axis and parallel to the plane containing the array elements

⇒

Assertion (A): If an atom of polarizability a is placed in homogeneous field E, the energy stored is 0.5 aE².

Reason (R): Capacitance of an isolated conducting sphere R in vacuum is 4 p∈₀ R farads.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
remain same
become half
become doubled
become four times

⇒ The converter whose conversion time is independent of number of bits is
dual stope
counter type
parallel conversion
successive approximation

⇒ Find E at P(1, 1, 1) caused by four identical 3 nC point charges located at P₁(1, 1, 0), P₂(- 1, 1, 0), P₃(- 1, - 1, 0) P₄(1, - 1, 0)
21.58a_x + 21.58a_y + 12a_z V/m
6.82a_x + 6.82a_y + 32.89a_z V/m
-6.82a_x - 6.82a_y - 32.89a_z V/m
-21.58a_x - 21.58a_y - 12az V/m

⇒ The logic realized by the circuit shown in fi
F = A ⊙ C
F = A ⊕ C
F = B ⊙ C
F = B ⊕ C

⇒

Assertion (A): The maximum efficiency of a class B push pull amplifier is 78.5%

Reason (R): A current mirror uses a compensating diode in parallel with the emitter diode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The orientation polarization is

directly proportional to temperature
inversely proportional to temperature
inversely proportional to square of permanent dipole moment
directly proportional to square of permanent dipole moment.

Which of the above are correct?
1 and 3 only
2 and 3 only
1 and 4 only
2 and 4 only

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒

Assertion (A): TWT uses a focussing mechanism to prevent the electron beam from spreading.

Reason (R): In a TWT the electron beam has to travel a much longer distance than in klystron.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I		List II
A.	CLP	1.	Displays DOS version being used
B.	MSAV	2.	Partitions hard disk
C.	F DISK	3.	Anti-virus program
D.	VER	4.	Cleans screen

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-3, C-4, D-1
A-2, B-1, C-4, D-3

⇒ The current wave in figure is passed through 3 H inductor. The voltage across inductance during the period 2 < t < 3 second
12 V
- 12 V
6 V
- 6 V

⇒ Time rate of change in heat energy is analogous to
voltage
charge
current
voltage gradient

⇒ Bellows converts
pressure difference into displacement
pressure difference into voltage
displacement into pressure difference
either (a) or (c)

⇒

Assertion (A): CMOS devices have very high speed.

Reason (R): CMOS devices have very small physical size and simple geometry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true