Question is ⇒ The radio receivers mostly used now a days are, Options are ⇒ (A) TRF receivers, (B) super heterodyne receivers, (C) CW receivers, (D) pulsed receivers, (E) , Leave your comments or Download question paper.

Question is ⇒ The radio receivers mostly used now a days are, Options are ⇒ (A) TRF receivers, (B) super heterodyne receivers, (C) CW receivers, (D) pulsed receivers, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The radio receivers mostly used now a days are
A.	TRF receivers [Wrong Answer]
B.	super heterodyne receivers [Correct Answer]
C.	CW receivers [Wrong Answer]
D.	pulsed receivers [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The advantage of using dual slope ADC in digital voltmeter is that
its conversion time is small
its accuracy is high
its output is in BCD
it does not require a comparator

⇒ A chopper cannot be line commutated.
TRUE
FALSE

⇒ A low ratio of the A.C. load impedance of a diode detector results in
diagonal clipping
poor AGC operation
poor AF response
negative peak clipping

⇒ A memory chip has 65536 cells in it. Then
time required to access cell is same as that to access cell 65536
time required to access cell is less than that required to access cell 65536
time required to access cell is more than that required to access cell 65536
either (a) or (b)

⇒ For infinite value of SWR on a transmission line, the line be terminated with impedance as
an open-circuit
a short-circuit
a pure resistance
all of the above

⇒ In figure, the switch has been in closed position for a long time. At t = 0, the switch is opened. At t = 0⁺, the current R_{10.333333333333333
0.166666666666667
0.25
0.0833333333333333}

⇒ In the circuit, V_s = 10 cos ωt, power drawn by the 4Ω resistor is 8 watt. The power facto
1
0.5
0.85
0

⇒ The multivibrator circuit that has a typical application of converting sinusoidal input into a square wave output is
emitter coupled binary
Schmitt trigger
monoshot multivibrator
free-running multivibrator

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Bitwise inclusive OR
B.	&	2.	Bitwise AND
C.	\| \|	3.	Logical AND
D.	\|	4.	Logical OR

A-1, B-2, C-3, D-4
A-3, B-2, C-4, D-1
A-2, B-3, C-1, D-4
A-1, B-4, C-2, D-3

⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)

⇒ If the diameter of a wire is doubled, its current carrying capacity becomes
one-fourth
half
twice
four times

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Assignment
B.	\| \|	2.	Logical AND
C.	=	3.	Logical OR

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ In oscillators class C operation is preferred because
is most efficient
has frequency stability
gives larger output
it produces nearly square waves

⇒ The high voltage level of a digital signal in positive logic is
1
0
either 1 or 0
-1

⇒ In FM noise can be decreased by a feature that AM does not have
increasing deviation
decreasing deviation
reducing modulation index
increasing modulation index

⇒ The function of duplexer in a RADAR is
to permit the use of same antenna for transmission and reception
to provide gain to the transmitted power
to amplify the received signal
both (b) and (c)

⇒ For the system in the given figure, the gain margi
0
low
+ ∞
none of the above

⇒ For a = - 1, find the value of V_{2∞
0
V₁
none of the above}

⇒ The Ebers-moll equation for I_E in CB configuration is given by
I_E = a_nI_CI_EC0
I_E = a_II_C + I_C0
I_E = a_nI_C + I_C0(e^qVEB/KT-1)
I_E = a_II_C + I_E0(e^qV_EB/KT - 1)

⇒ Which of the following characters is allowed in variable names in C?
comma
dot
blank
underscore

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called
saturation point
cut off point
Q point
operating point

⇒ A wire is carrying current I. The field intensity H at a distance r from the wire
is directed towards wire
is directed away from wire
is tangential every where to a circle of radius r
none of the above

⇒ In TV broadcast, UHF range is
606 - 790 MHz
100 - 150 MHz
41 - 68 MHz
174 - 230 MHz

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ A leaky dielectric has ∈_r = ∈_r^' - j∈_r^". If a field E is applied, the current component in phase with E is proportional to ∈_r^".
TRUE
FALSE

⇒ In the given figure, A = B = 1 and C = D = 0. Then
1
0
either 1 or 0
indeterminate

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒ For a series R-L-C circuit, the characteristic equation is given
critically damped
underdamped
undamped
overdamped