Question is ⇒ If CS = A15 A14 A13 is used as chip select logic of a 4 K RAM in 8085 system, its memory range is, Options are ⇒ (A) 3000 H - 3 FFF H, (B) 7000 H - 7 FFFH, (C) 5000 H - 5 FFF H and 6000 H - 6 FFF H, (D) 6000 H - 6 FFF H and 7000 H - 7 FFF H, (E) , Leave your comments or Download question paper.

Question is ⇒ If CS = A15 A14 A13 is used as chip select logic of a 4 K RAM in 8085 system, its memory range is, Options are ⇒ (A) 3000 H - 3 FFF H, (B) 7000 H - 7 FFFH, (C) 5000 H - 5 FFF H and 6000 H - 6 FFF H, (D) 6000 H - 6 FFF H and 7000 H - 7 FFF H, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If CS = A₁₅ A₁₄ A₁₃ is used as chip select logic of a 4 K RAM in 8085 system, its memory range is
A.	3000 H - 3 FFF H [Wrong Answer]
B.	7000 H - 7 FFFH [Wrong Answer]
C.	5000 H - 5 FFF H and 6000 H - 6 FFF H [Wrong Answer]
D.	6000 H - 6 FFF H and 7000 H - 7 FFF H [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using
divide by 5 circuit
divide by 2 circuit
divide by 5 circuit followed by divide by 2 circuit
BCD counter

⇒

Assertion (A): A PROM is a user programmable ROM.

Reason (R): After programming PROM behaves like ROM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above

⇒ Which of the following antennas is λ /4 length?
Dipole
Marconi
Monopole
Parabolic

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒

Assertion (A): A composite video signal has synchronising pulses.

Reason (R): It is necessary to synchronise the scanning process in the transmitter and receiver.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For a 12 pulse operation, the two 6 pulse units are fed by
Y - Y and Y - Y transformers
Δ - Δ and Δ - Δ transformers
Y - Y and Y - Δ transformers
Y - Δ and Y - Δ transformers

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ Load cell uses
piezoelectric crystal
capacitor
mutual inductance
strain gauge

⇒ In the given figure the input frequency is such that R << X_c,
v₀ lags v_i by 90°
v₀ leads v_i by 90°
v₀ and v_i are in phase
either (b) or (c)

⇒ For insulators the energy gap is of the order of
0.1 eV
0.7 eV
1.1 eV to 1.2 eV
5 to 15 eV

⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source

⇒ The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal I_s = cos 6t, the steady state voltage across Z is given in magnitude as u
0.6
0.84
7.2
none

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒

Assertion (A): If contents of F register in 8085 are 01010001, it means S = 0, Z = 1, AC= 1, P = 0 and CY = 1.

Reason (R): When an instruction is called from memory, the op. code of instruction is stored in instruction register.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A telephone channel requires a bandwidth of about
1 kHz
3 kHz
10 kHz
50 kHz

⇒ Selectivity varies with receiving frequency, frequency is raised.
Somewhat better when the receiving frequency is raised
Somewhat better at intermediate frequency
Somewhat worse when the receiving frequency is lowered
Somewhat worse when the receiving frequency is raised

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒ In a single phase full wave regulator feeding R-L load, the minimum firing angle can be zero.
TRUE
FALSE

⇒ A ship-to-ship communication system is plagued by fading. The best solution seems to be the use of
space diversity
frequency diversity
a broad band antenna
a more directional antenna

⇒ Consider the following as regards cumulative disribution function F(x)

0 ≤ F(x) ≤ 1
F(- ∞) = 0
F(∞) = 1
F(x₁) ≤ F(x₂) If x₁ < x₂

Out of above which are correct?
1 and 2 only
1, 2 and 3 only
1, 2, 3 and 4
2 and 4

⇒ Antenna used for direction finding is
long dipole
parabolic
rhombic
helical

⇒ A choke coil has a resistance to reactance ratio of 0.2. The power factor of the choke coil is
less than 0.2 lagging
less than 0.2 leading
about 1
about 0

⇒ The electric field of 2.5 x 10⁷ V/m can give 1 eV energy to condition electron, then in a copper block what will be the mean free path of electron?
5 x 10^-8 m
4 x 10^-7 m
0.4 m
0.5 m

⇒ How is an N-channel junction Field Effect Transistor operated as an amplifier?
With a forward bias gate source junction
With a reverse bias gate-source junction
With a open gate source junction
With a shorted gate source junction

⇒ In an R-C series circuit excited by a voltage E, the charge across capacitor at t = 0⁺ is
0
CE
CE (1 - e^-t/RC)
none of the above

⇒ Which of the following uses a capacitor in the feedback path?
Active low pass filter
Active high pass filter
Both (a) or (b)
Neither (a) nor (b)

⇒ Power transistors are invariably provided with
soldered connections
heat sink
metallic casing
none of the above

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ A series resonant circuit has R = 10 Ω, L = 1 μH and C = 1 mF. If R is increased to 20 Ω the resonant frequency
increases
decreases
remains constant
may increases or decreases