Question is ⇒ The audio frequency range is, Options are ⇒ (A) 5 Hz to 1 kHz, (B) 50 Hz to 20 kHz, (C) 16 Hz to 20 kHz, (D) 0 Hz to 20 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ The audio frequency range is, Options are ⇒ (A) 5 Hz to 1 kHz, (B) 50 Hz to 20 kHz, (C) 16 Hz to 20 kHz, (D) 0 Hz to 20 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The audio frequency range is
A.	5 Hz to 1 kHz [Wrong Answer]
B.	50 Hz to 20 kHz [Wrong Answer]
C.	16 Hz to 20 kHz [Correct Answer]
D.	0 Hz to 20 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): An encoder converts key dips to binary code.

Reason (R): An encoder has more inputs than output.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following is also called Non volatile RAM?
Shadow RAM
UVEPROM
EEPROM
Both (b) and (c)

⇒ The minimum decimal equivalent of the number 11C0 is
183
194
268
269

⇒ As temperature increases, the temperature coefficient of metals increases.
TRUE
FALSE

⇒ Which of the following Boolean Expression correctly represents the relation between P, Q, R and M_{1M₁ = (P OR Q) XOR R
M₁ = (P AND Q) XOR R
M₁ = (P NOR Q) XOR R
M₁ = (P XOR Q) XOR R}

⇒ Consider the following ON GO TO statement in Ba
10, 20, 30, 20 respectively
10, 20, 20, 30 respectively
20, 30, 20, 10 respectively
10, 30, 20, 20 respectively

⇒ The power factor of a single phase load can be calculated if instruments available are
one voltmeter, one ammeter
two ammeters
two voltmeters
one voltmeter, one ammeter and one wattmeter

⇒ An RC circuit initially at rest has a step signal. The response V(t) across C is V(t) = 1 - e^-at, If now there is an initial voltage on C of 2 volts for the same step signal, V(t) is now
1 + e ^-at
1 + 2e ^-at
2 - e ^-at
3 - e ^-at

⇒ In a microprocessor system the stack is used for
starting the program return address whenever a subroutine jump instruction is execute
transmitting and receiving input and output data
starting all important CPU register contents whenever an interrupt is to be serviced
storing program instructions for interrupt service routine

⇒ The efficiency of a direct radiating cone type loudspeaker is about
0.05
0.2
0.5
0.8

⇒ Which of the following is a valid integer variable in Fortran 77?
KM
K M - 1
DELHI
318

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒

Assertion (A): In a power divider S_H = 0, S₂₁ = 0.707 = S₃,

Reason (R): In a power divider the input port (i.e., port 1) is matched and incident power is equally divided in output ports 2 and 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ 4 bit 2's complement representation of a decimal number is 1000. The number is
8
0
-7
-8

⇒ The first geostationary satellite was named
Intelsat I
Intelsat II
Intelsat III
Early bird

⇒ A ripple in collector supply voltage of the output stage of amplifier causes noise.
TRUE
FALSE

⇒ The circuit in figure, the switched on at t = 0. After a long time the current through 5 Ω resistanc
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ A failure rate of 0.01 percent in 1000 hours in a memory corresponds to an MTBF of
1000 hours
100000 hours
10 hours
100 hours

⇒ The measure of mismatch between the load and the transmission line is known as
directivity
Gain
standing wave ratio
reflection coefficient

⇒ If a common emitter amplifier with an emitter resistance R_C has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be
50 kΩ
0.98 kΩ
50 Ω
0.98 Ω

⇒ A leakage capacitor can be represented by a capacitance C and resistance R in parallel C.
TRUE
FALSE

⇒ 9's complement of 12₁₀ is
21₁₀
87₁₀
78₁₀
76₁₀

⇒ An ideal Op-amp is an ideal
voltage controlled current source
voltage controlled voltage source
current controlled current source
current controlled voltage source

⇒ Read cycle is always followed by (during instructions execution)
read cycle
write cycle
delete signal
none of these

⇒ Without a spectrum analyser, it is not possible to determine
carrier frequency
antenna pattern
pulse width
spurious signal strength and its location

⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
0.6 Ω
0.06 Ω
0.1 Ω
0.004 Ω

⇒ The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to
any where
a dc ground potential
the most positive potential available in the circuit
the most negative potential available in the circuit

⇒

Match the following:

	List I (Devices)		List II (characteristic)
A.	BJT	1.	Voltage controlled negative resistance
B.	MOSFET	2.	High current gain
C.	Tunnel diode	3.	Voltage regulation
D.	Zener diode	4.	High input impedance

A-1, B-4, C-2, D-3
A-2, B-4, C-1, D-3
A-2, B-3, C-1, D-4
A-1, B-3, C-2, D-4

⇒ For a superconductor, the relative permeability is
zero
high
low
either low or high