Question is ⇒ In ZRC (s) = constant at s = 0, the last element in first Foster cauer realization is, Options are ⇒ (A) R, (B) C, (C) R and C in series, (D) R and C in parallel, (E) , Leave your comments or Download question paper.

Question is ⇒ In ZRC (s) = constant at s = 0, the last element in first Foster cauer realization is, Options are ⇒ (A) R, (B) C, (C) R and C in series, (D) R and C in parallel, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In Z_RC (s) = constant at s = 0, the last element in first Foster cauer realization is
A.	R [Correct Answer]
B.	C [Wrong Answer]
C.	R and C in series [Wrong Answer]
D.	R and C in parallel [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate
12000 bps
1000 bps
6000 bps
3000 bps

⇒ As compared to operating current, the current drawn by a memory chip in stand by mode is
about the same
about one-eighth
about 1 / 64
about 1 / 500

⇒ A thyristor is reverse biased. A positive gate pulse is applied. The thyristor
will be turned on
may or may not turn on
will not turn on
will turn on after sometime

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ In order to protect a MOSFET against damage from any stray voltage at the gate
grounding rings are provided
terminals are shorted
source terminal is earthed during transit
none of these

⇒

Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): In drawing an electric circuit analogous to a mechanical circuit, spring is replaced by capacitance.

Reason (R): The behaviour of a spring and capacitor are similar.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two

⇒ When a current carrying conductor is brought into magnetic field, the force that moves the conductor depends upon
the value of current
the weight of the conductor
the direction of the conductor
none of the above

⇒ In figure, I_D = 4 mA. Then V_{D20 V
10 V
30 V
1 V}

⇒ Two passive elements are connected in series and a dc voltage is applied to the circuit. The time variation of the current is shown in figure. The two elements
one resistance and the other inductance
both resistances
one inductance and the other capacitance
one resistance and the other capacitance

⇒ Highest resistivity of the following is
nichrome
constantan
metal
manganin

⇒ Frequency shift keying is used mostly in
telephony
telegraphy
radio transmission
none of the above

⇒ In a rectifier only a portion of input power is converted into DC power. The rest is AC power.
TRUE
FALSE

⇒ A 256 x 4 EPROM has
8 address pins and 4 data pins
8 address pins and 8 data pins
4 address pins and 8 data pins
4 address pins and 4 data pins

⇒ The current wave shown in figure is applied by a 0.1 F capacitor at t = 0. At t = 0⁺, the voltage across capacito
0
4 V
10 V
20 V

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ In CCD
a small charge is deposited for logical 1
a small charge is deposited for both logical 1 and 0
a small charge is deposited for logical 0 and large charge for logical 1
none of the above

⇒ Characteristic impedance of a coaxial cable is inversely proportional to ∈_r.
TRUE
FALSE

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ If an electron move through a potential difference of 500 V, the energy possesses by it will be
500 ergs
500 joules
500 eV
500 mV

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ If f₁ and f₂ and half-power frequency and f₀ be resonant frequency, the selectivity of R-L-C series circuit is given by
(f₂ - f₁)/2f₀
(f₂ - f₁)/f₀
(f₂ - f₀)/(f₁ - f₀)
(f₂ - f₁)/(f₁ - f₀)

⇒ The characteristic equation of a control system is given as s⁴ + 8s³ + 24s² + 32s + K = 0. What is the range of values of K for this system to be stable?
0 ≤ K < 80
0 ≤ K < 100
0 ≤ K < 2300
0 ≤ K < 600

⇒ The primary reason for the widespread use of Si in semiconductor device technology is
abundance of Si on the surface of earth
larger band gap of Si in comparison to Ge
favourable properties of Silicon-dioxide (SiO₂)
lower melting point

⇒

Assertion (A): A colour TV uses a SAW filter to give stable band pass response and high gain.

Reason (R): Devices using SAW principle are used in many systems.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following devices uses a helix?
Klystron amplifier
Klystron oscillator
TWT
Both (a) and (b)

⇒ A black box has one of the elements our of R, L, C. when a 220 V a supply is connected the current supplied by source is I. when a 0.1 F capacitor is connected in parallel with the box, the current is 2I. The element is
resistance
inductance
0.1 F capacitance
not identifiable on the basis of given data

⇒ The antenna current of an AM transmitter is 8 A, when only the carrier is sent, but it increases to 8.93 A when the carrier is modulated by a single sine wave. Determine the antenna current when the percent of modulation changes to 0.8
9.19 A
9.91 A
10.56 A
8.61 A

⇒ 'WRITE' is a
Word processor
Line editor
Text editor
Column editor