Question is ⇒ Determine the potential difference between the points A and B in the steady s, Options are ⇒ (A) 40 V, (B) 60 V, (C) 25 V, (D) 75 V, (E) , Leave your comments or Download question paper.

Question is ⇒ Determine the potential difference between the points A and B in the steady s, Options are ⇒ (A) 40 V, (B) 60 V, (C) 25 V, (D) 75 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Determine the potential difference between the points A and B in the steady s
A.	40 V [Wrong Answer]
B.	60 V [Wrong Answer]
C.	25 V [Wrong Answer]
D.	75 V [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a one pole active low pass filter, the cut off frequency is f_c. Then
gain decreases at the rate of 20 dB per decade increase in frequency above f_c
gain decreases at the rate of 20 dB per decade decrease in frequency below f_c
gain decreases at the rate of 40 dB per decade increase in frequency above f_c
gain decreases at the rate 40 dB per decade decrease in frequency below f_c

⇒ A Schottky diode has
no minority carriers and very low voltage drop in forward direction
no minority carriers and very high voltage drop in forward direction
large number of minority carriers and very high voltage drop in forward direction
large number of minority carriers and very low voltage drop in forward direction

⇒

Match the following:

	List I		List II
A.	Coastals receiver	1.	VSB
B.	Stereo-multiplexing	2.	Demodulating DSB-SC
C.	TV broad casting	3.	FM radio broad casting
		4.	Slope overload
		5.	Matched filter

A-1, B-3, C-2
A-2, B-3, C-1
A-2, B-1, C-4
A-4, B-3, C-1

⇒ In a JK flip flop output Q_n = 1 and it does not change when clock pulse is applied. The possible combination of J_n and K_n is (X denotes don't care)
X and 0
X and 1
0 and X
1 and X

⇒ The following sequence represents autocorrelation of a real valued signal. The energy of real valued sequence is given by __________ x(n) = {1, _, 3, _, 5, _, 7, _, 9, 10, _, 8, _, 6, _, 4, _, 2
2[1² + 2² + 3² + 4² + 5² + 6² + 7² + 8² + 9²] + 10²
10
10²
2[1² + 2² + 3² + 4² + 5² + 6² + 7² + 8² + 9² + 10²]

⇒ The figures shows the symbo
p channel depletion MOSFET
p channel enhancement MOSFET
complementary MOSFET
p channel JFET

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒ Which of the antenna is best excited by a waveguide?
Horn
Discone
Helical
Biconical

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒ In P-N junction, the region containing the uncompensated acceptor and donor ions is called
transition zone
depletion region
neutral region
active region

⇒ For Disk partitioning th DOS command is
F DISK
H DISK
A DISK
D DISK

⇒ Power received from Sun per m² surface area of a geosynchronous satellite in nearly __________ watt.
100
500
2000
1000

⇒ When large amount of power is required, a push pull amplifier is designed for operation as
class A
class B
class C
class AB

⇒ For the circuit shown in figure low cut-off frequenc
1.59 Hz
159 Hz
1.59 kHz
1.59 MHz

⇒ In a two tone AM system the two modulating frequencies are 2000 p and 4000 p rad/sec. If carrier frequency is 2p x 10⁶ rad/sec the frequencies of upper sidebands are
1.002 MHz and 1.004 MHz
1.001 MHz and 1.002 MHz
1.001 MHz and 1.004 MHz
1.002 MHz and 1.008 MHz

⇒ Two voltages are v₁= 100 sin (ωt + 15°) and v₂ = 60 cosωt, then
v₁ is leading v₂ by 15°
v₁ is leading v₂ by 75°
v₂ is leading v₁ by 75°
v₂ is lagging v₁ by 15°

⇒ A first order system will never be able to give a __________ response.

Band pass
Band reject
All pass

Choose the correct option
1, 2 and 3 are true
1 and 3 are true, 2 is false
1 and 2 are false, 3 is true
1 and 2 are true, 3 is false

⇒

Assertion (A): In an RC coupled amplifier the junction capacitances can be neglected at low frequencies but not at high frequencies

Reason (R): Capacitive reactance is inversely proportional to frequency.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In Gunn diode electrons are transferred from
Ridge guide is essentially a form of capacitively loaded guide
low to high mobility energy bands
valley to domain formation
domain to valley formation

⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
300 Ω
200 Ω
80 Ω
24 Ω

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio

⇒ In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be
100 V
72 V
50 V
38 V

⇒ A variable resistance R and capacitive reactance X_C are fed by an voltage. The current locus is
a semi circle in 4th quadrant
a semi circle in first quadrant
a straight line in 4th quadrant
a straight line first quadrant

⇒ Thermistors are made of
pure metals
pure insulators
tintered mixture of metallic oxides
pure semiconductors

⇒ The audio frequency range is
5 Hz to 1 kHz
50 Hz to 20 kHz
16 Hz to 20 kHz
0 Hz to 20 kHz

⇒ Resistivity of carbon is around
10 to 70 m-ohm-cm
80 to 130 m-ohm-cm
800 to 1300 m-ohm-cm
8000 to 13000 m-ohm-cm

⇒ The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10^-6 N-m on full scale. If B = 1 Wb/m², range of meter is
1 mA
2 mA
3 mA
4 mA

⇒ When a complex voltage wave is applied to a capacitor the resulting current wave is more distorted than the voltage wave.
TRUE
FALSE

⇒ A 4 input AND gate is equivalent to
4 switches in parallel
2 switches in series and 2 in parallel
three switches in parallel and one in series
4 switches in series

⇒ An exponential amplifier has diode in feedback path.
TRUE
FALSE