Question is ⇒ The circuit in the figure is has two CMOS-NOR gates. This circuit functions, Options are ⇒ (A) flip-flop, (B) schmitt trigger, (C) monostable multivibrator, (D) astable multivibrator, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit in the figure is has two CMOS-NOR gates. This circuit functions, Options are ⇒ (A) flip-flop, (B) schmitt trigger, (C) monostable multivibrator, (D) astable multivibrator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit in the figure is has two CMOS-NOR gates. This circuit functions
A.	flip-flop [Wrong Answer]
B.	schmitt trigger [Wrong Answer]
C.	monostable multivibrator [Correct Answer]
D.	astable multivibrator [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following impedance inversion is obtained?
Short-circuited stub
A quarter wave line
Balun transformer
A half wave line

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ In a NAND SR latch S = R = 1. Then
Q = 1, Q = 0
Q = 0, Q = 1
both Q and Q will be same as before
the latch will be set

⇒ Surface impedance at high frequencies is a consideration for
good conductors
semiconductors
dielectrics
ferrites

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ A microwave link uses only line-of-sight propagation.
TRUE
FALSE

⇒ A discrete time linear shift-invariant system has an impulse response h[n] with h[0] = 1, h[1] = - 1, h[2] - 2, and zero otherwise. The system is given an input sequence x[n] with x[0] - x[2] - 1, and zero otherwise. The number of nonzero samples in the output sequence y[n], and the value of y[2] are, respectively
5, 2
6, 2
6, 1
5, 3

⇒ Programs like compilers, assemblers etc. are stored in a mircocomputer in
registers
cache memory
primary memory
mass storage

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the speed is 1440 rpm. At 25 Hz, the speed is likely to be
about 1350 rpm
about 720 rpm
about 360 rpm
either (b) or (c)

⇒ In a common Emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche breakdown of Base emitter junction
collector to Base Breakdown voltage with emitter open (βV_CBO)
collector Emitter Breakdown voltage with base open (βV_CBO)
zener breakdown voltage of the emitter base Junction

⇒ If any term in the first column of a Routh array becomes zero, then
Routh criterion cannot be used to determine stability
Routh criterion can be used by substituting a small positive number for zero and completing the array
Routh criterion can be used by substituting a big positive number for zero and completing the array
Routh criterion can be used by substituting a small negative number for zero and completing the array

⇒ A semi converter operates in two quadrants.
TRUE
FALSE

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ While AM has __________ frequencies, FM has __________ number of sidebands.
2, 3
3, 3
3, 5
3, infinite

⇒ The output of a linear system for any input can be computed in which of the following ways?
Only by summation of inpulse response by convolution integral
Only by summation of step response by superposition integral
Neither a nor b
Either (a) or (b)

⇒ The maximum theoretical efficiency for class A amplifier is
0.125
0.25
0.5
0.75

⇒ A digital frequency counter can be converted to DVM by addition of a suitable
voltage controlled oscillator
D/A converter
power amplifier
operational amplifier

⇒ The virtual height of an ionospheric layer is __________ true height
equal to
less than
higher than
no relation

⇒ In Pascal the repeat and while loops will terminate
only when the logical expression controlling the loop becomes true for both repeat and while loops
only when the logical expression controlling the loop becomes false for both repeat and while loops
only when the logical expression controlling the loop becomes true for repeat loop and false for while loop
only when the logical expression controlling the loop becomes false for repeat loop and true for while loop

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ At any point on the v-i characteristics of a semiconductor diode, the slope of v-i characteristics is called
resistance of diode
conductance of diode
incremental resistance of diode
incremental conductance of diode

⇒ The total number of leads in SUS, SBS and SCS respectively are
3, 3, 4,
3, 3, 3
2, 3, 3
3, 3, 5

⇒ If V_a1, V_a2, V_a0 are the symmetrical components of V_a, then
V_a = V_a1 + V_a2 + V_a0
V_a = a²V_a1 + aV_a2 + V_a0
V_a = aV_a1 + a²V_a2 + V_a0
V_a = aV_a0 + a²V_a1 + V_a2

⇒ The combination of registers in 8085 is B-C, D-E, H-L only.
TRUE
FALSE

⇒ Secondary emission results
when temperature of metals is raised to a level above the crystallization temperature
when metals are subjected to strong magnetic fields
when light rays fall on the metal surface
when a high velocity beam of electrons strikes as metal surface

⇒ Which one of the following is true?
Alternating voltage and current contain odd and even harmonics
The inductance in a circuit reduces the effect of harmonics and makes current wave more sinusoidal than voltage wave
Alternating voltage and current waveforms, in general, do not contain odd harmonics
Inductance of a circuit does not alter wave shape at all

⇒ A series R, L, C circuit has R = 2Ω, L = 1H, C = 1 μF. It is connected to an ac variable frequency source of peak voltage 10 V. At resonance the power supplied by the source will be
50 Ω
25 Ω
12.5 Ω
6.25 Ω

⇒ BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are
a, b, d
a, b, c
all
a, b, g, c, d

⇒ The sensitivity of a potentiometer can be increased by
increasing the length of wire
decreasing the length of wire
increasing the current in the wire
decreasing the current in the wire