Question is ⇒ Full duplex operation-permits transmission in both directions at the same time., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Full duplex operation-permits transmission in both directions at the same time., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Full duplex operation-permits transmission in both directions at the same time.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The equivalent circuit of an ideal diode is
a charging condenser
a discharging condenser
a switch
a resistor

⇒ The smallest change in sound intensity that can be detected by human ear is __________ dB.
1
3
10
20

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ Which of the following modes cannot exist in rectangular resonant cavity?
TE₁₁₀
TE₀₁₁
TM₁₁₀
TM₁₁₁

⇒ Two numbers are 131 ± 5 and 629 ± 3. The sum of the numbers with range of doubt is
760 ± 8
760 ± 2
760 + 8
760 - 8

⇒ A transistor amplifier has pole
s₁
s₁ + s₂ + s₃ + s₄
s₁ + s₄
s₄

⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ In a rectangular waveguide there is one half wave variation of electric field across the narrow dimension and two half wave variations of electric field across wider dimension. The dominant mode is
TM₁₂
TE₁₃
TE₂₁
TM₂₅

⇒ In each of circuits below, indicate which diode is conduct
Figure A
Figure B
Figure C
All the three

⇒ Fourier transform of non periodic DT signal is
aperiodic
Periodic
both a and b
None of these

⇒ For broadcasting purpose, full AM signal is preferred to SSB signal because
it requires large bandwidth
generation of full AM is easier
detection of full AM is simpler
none of the above

⇒ In an n type semiconductor
number of free electrons and holes are equal
number of free electrons is much greater than the number of holes
number of free electrons may be equal or less than the number of holes
number of holes is greater than the number of free electrons

⇒

Match the following:

	List I		List II
A.	Total instantaneous value of emitter current	1.	I_E
B.	Quiescent value of emitter current	2.	i_E
C.	Instantaneous value of as component of emitter current	3.	I_e
D.	RMS value of ac component of emitter current	4.	i_e

A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4
A-2, B-3, C-4, D-1

⇒ In a positive edge triggered D flip flop
D input is called direct set
Preset is called direct reset
Present and clear are called direct set and reset respectively
D input overrides other inputs

⇒ Decimal 45.15 when converted into 9's complement will become
54.84
45.48
48.54
45.84

⇒

Assertion (A): The output of an 8 bit ADC is 80 H if input is 2.5 V

Reason (R): ADC has an output range of 00 to FF H if input range is - 5 to + 5 V

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a single phase full wave converter (M - 2 connection) feeding a highly inductive load, the firing angle for each thyristor is a in the respective half cycle. The period of conduction of each thyristor is
p - a
p
p + a
p - 2a

⇒ The effect of the inductance of a coil on a constant direct current is that
it does not effect the constant direct current
it decreases the current
it strengthens the current
it causes a higher voltage drop

⇒ An RC impadence function has a pole at s = 0. The first element in the Foster form of synthesis
is R
may be R and C
is C
is R and C in parallel

⇒ Hay's bridge is suitable for inductances having low L/R ratio.
TRUE
FALSE

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be
0.1
0.05
0.002
0.0001

⇒ Automatic sensitivity control by target voltage control is easily possible in
Vidicon
Plumbicon
New vicon
both (b) and (c)

⇒ The poles with greater displacement from the real axis correspond to
higher frequencies of oscillations
stable response
lower frequencies of oscillations
unbounded output

⇒ Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity
increases
decreases
may increase or decrease
remains the same

⇒ Which converter is used in HVDC transmission?
3 pulse
6 pulse
12 pulse
24 pulse

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then
there will be no oscillations on line
there will be only 1 or 2 oscillations on line
there will be a finite number of oscillations on line
the oscillations will continue indefinitely

⇒ For Disk partitioning th DOS command is
F DISK
H DISK
A DISK
D DISK