Question is ⇒ For a second order system the damping factor is varied from 0 to 1. The locus of poles is, Options are ⇒ (A) a straight line on imaginary axis, (B) a straight line on real axis, (C) a semi circle, (D) a circle, (E) , Leave your comments or Download question paper.

Question is ⇒ For a second order system the damping factor is varied from 0 to 1. The locus of poles is, Options are ⇒ (A) a straight line on imaginary axis, (B) a straight line on real axis, (C) a semi circle, (D) a circle, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a second order system the damping factor is varied from 0 to 1. The locus of poles is
A.	a straight line on imaginary axis [Wrong Answer]
B.	a straight line on real axis [Wrong Answer]
C.	a semi circle [Correct Answer]
D.	a circle [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	Reflex Klystron	1.	Wideband amplification
B.	TWT	2.	Very low power amplification
C.	Cavity Klystron	3.	Low power FM generation
D.	Maser	4.	Frequency multiplication

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2

⇒ V(t) across R₂ for t > 0 is given
2 - 2e^-2t
2 - e^-2t
2 - e^-t
1 - e^-t

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a stud mounted SCR, the stud is
in thermal contact with heat sink
insulated from heat sink
in electrical and thermal contact with heat sink
in either electrical or thermal contact with heat sink

⇒ If (225)_Y = (165)₈ find value of Y
7
8
9
11

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ In a single phase full wave regulator feeding R-L load, short gate pulse are not suitable.
TRUE
FALSE

⇒ In a 3 phase full converter, the firing angle is less than 60°. The instantaneous output voltage
will have positive part only
will have both positive and negative parts
may have both positive and negative parts
will have negative part if load is inductive

⇒ Which of the following is a valid expression in FORTRAN 77?
B * - 3
B * (- 3)
B * * - 3
B * + 2

⇒ In waveguide Degenerate modes are
two mode having same cut off frequency
two mode having same power
two mode having same phase velocity
it is a hypothetical mode

⇒ The function of a modulator is to
separate two frequencies
extract information from the carrier
amplify the audio frequency signal
impress the information on to a RF carrier

⇒ The network of the given figure
lag network
lead network
lag-lead network
any of the above

⇒ The frame of electric motor is connected to three plates having earthing resistance of 10 Ω, 20 Ω and 30 Ω respectively. The materials of the three plates are copper, aluminium and iron respectively. The percentage of energy dissipated by 10 Ω earthing plate
is more than 50% of total energy
is less than 50% of total energy
depends on the materials of the three plates
may be more or less than 50% of total energy

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ TTL inverter has
one input
two inputs
one or two inputs
three inputs

⇒ In a power amplifier the collector current flows for 270° of the input cycle. The operations is
class A
class B
class AB
class C

⇒

Match the following:

	List I (Transmission system)		List II (Mode)
A.	Rectangular waveguide	1.	TE/TM
B.	Circular waveguide	2.	TEM
C.	Coaxial line	3.	Quasi TEM
D.	Microstrip line

A-1, B-1, C-2, D-3
A-1, B-2, C-2, D-3
A-2, B-2, C-3, D-3
A-3, B-1, C-2, D-2

⇒ ROC of sequence x[n] = (3)ⁿ ∪[n] + (4)ⁿ ∪[- n - 1]
|z| > 4
3 < |z| < 4
|z| < 4
|z| > 3

⇒ A uniform plane wave in the free space is normally incident on an infinitely thick dielectric slab (dielectric constant ε_r = 9). The magnitude of the reflection coefficient is
0
0.3
0.5
0.8

⇒ In figure readings of the two voltmeters shoul
100 V on each meter
200 V on each meter
150 V on V₁ and 50 V on V₂
50 V on V₁ and 150 V on V₂

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ The relative permeability is taken as unity for which of the following?
Air
Cobalt
Vacuum
Bismuth

⇒ Reciprocity theorem is applicable to
circuits with one source
circuits with only one independent source
circuits with any number of sources
circuits with any number of independent sources

⇒ Which of the following is used for generating time varying wave forms?
MOSFET
PIN diode
Tunnel diode
UJT

⇒ DeMorgan's second theorem is
A . A = 0
A = A
A + B = A . B
AB = A + B

⇒ It is required to measure a low magnitude high frequency current. The proper instrument is
moving iron
dynamometer
thermocouple
induction

⇒ Microprocessor 386SX is a 16/32 bit microprocessor. It has
16 bit registers and 32 bit data bus
16 bit registers and 16 bit data bus
32 bit registers and 32 bit data bus
32 bit register and 16 bit data bus

⇒ Which of these devices is used in relaxation oscillator?
UJT
SCR
DIAC
TRIAC

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common-emitter short-circuit current gain is
1
199
99
9.9