Question is ⇒ Which interrupts are masked?, Options are ⇒ (A) 5.5, (B) 6.5, (C) 7.5, (D) None, (E) , Leave your comments or Download question paper.

Question is ⇒ Which interrupts are masked?, Options are ⇒ (A) 5.5, (B) 6.5, (C) 7.5, (D) None, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which interrupts are masked?
A.	5.5 [Wrong Answer]
B.	6.5 [Correct Answer]
C.	7.5 [Wrong Answer]
D.	None [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a low level amplitude modulated system, the amplifier modulated stage must be
class C
linear
non linear
harmonic

⇒ The circuit in the figure is has two CMOS-NOR gates. This circuit functions
flip-flop
schmitt trigger
monostable multivibrator
astable multivibrator

⇒ A function f(t) = k is
stable
marginal stable
unstable
none

⇒ The receiver of a pulsed RADAR can detect signal power in the order of
1 W
0.1 W
10^-5 W
10^-12 W

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒ Choose proper substitutes for x and y to make the following statement corr
x : Reverse, y : Reverse
x : Reverse, y : forward
x : Forward, y : Reverse
x : forward, y : forward

⇒ A planar array radar uses a high gain planar array antenna.
TRUE
FALSE

⇒ A carrier is modulated by two modulating waves A and B having modulation indices of 0.6 and 0.8 respectively. The overall modulation index is
1
0.7
0.2
1.4

⇒ The drift velocity of electrons and holes is proportional to electric field strength.
TRUE
FALSE

⇒ In a ripple counter,
whenever a flip flop sets to 1, the next higher FF toggles
whenever a flip flop sets to 0, the next higher FF remains unchanged
whenever a flip flop sets to 1, the next higher FF faces race condition
whenever a flip flop sets to 0, the next higher FF faces race condition

⇒

Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The area of an impulse is
1
0
∞
any finite value

⇒ Which of the following is not a valid real constant?
-73.1
10251,3
10.23
-5.7381

⇒ Consider the following statements for a driving point function F(jω):

Re F(jω) is an even function of ω and is 0 or positive for all values of ω.
Im F(jω) is an even function of ω and is 0 or positive for all values of ω.
Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.
Re F(s) = 0 for Re s = 0.

Which one of the statements given above is/are correct?
1 only
1 and 4
2, 2 and 4
4 only

⇒ If p is the probability of success and q is the probability of failure, then the probability that there are r successes in n trails is
ⁿc_r p^r qⁿ ^- ^r
ⁿc_r p^{n -} ^r q^r
ⁿc_r p^r qⁿ ⁺ ^r
ⁿc_r pⁿ qⁿ ^{- r}

⇒ Multiplex techniques are used for
low density communications
low density point-to-point communications
high-density point-to-point communications
all of the above

⇒

Assertion (A): Ferrites are very useful at very high frequencies.

Reason (R): Ferrites have high permeability and high resistivity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The effect of the inductance of a coil on a constant direct current is that
it does not effect the constant direct current
it decreases the current
it strengthens the current
it causes a higher voltage drop

⇒ In FM reception, amplitude disturbances due to static change
reduce the signal frequencies
increase the signal frequencies
disturb the signal frequencies
do not affect the signal frequencies

⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling

⇒

Assertion (A): A low power factor wattmeter has special constructional features to ensure accurate measurement.

Reason (R): Extension of wattmeter range in dc circuit can be easily done by using current and potential transformer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If f_s be the signal frequency and f_i be the intermediate frequency then image frequency is given by
f_s + f_i
f_s ± f_i
f_s ± 2f_i
f_s + 2f_i

⇒ μ₀ = 8.85 x 10^-12F/m.
TRUE
FALSE

⇒ The absorption of radio waves by the atmosphere depends on
the polarization of the waves
the polarization of the atmosphere
frequency of the waves
their distance from the transmitter

⇒ Let the initial contents of ACC and CY in 8085 be

CY = 1
ACC = 10000001

After the instruction RAL is executed twice the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000111
1 and 00000111
0 and 00000011

⇒ If PRIN = 200.0 and BINT = 0.0525 the result of expression INCOME = PRIN * (1 + BINT) will be
210
210.5
210.5
210.5

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation in parameters of active device.

Reason (R): A large negative value of feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to the feedback factor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Transit time is considered as significant at
HF
MF
LF
all of the above

⇒ The noise figure of FET circuit is
independent of the quiescent point
dependent on the quiescent point only
dependent on the triggering mechanism
independent of all above

⇒ In fibre optics the use is made of thin glass fibres for efficient transmission of light.
TRUE
FALSE