Question is ⇒ In a colour TV receiver, AGC adjusts the gain of, Options are ⇒ (A) RF stage only, (B) IF stage only, (C) RF stage and one or two IF stages, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a colour TV receiver, AGC adjusts the gain of, Options are ⇒ (A) RF stage only, (B) IF stage only, (C) RF stage and one or two IF stages, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a colour TV receiver, AGC adjusts the gain of
A.	RF stage only [Wrong Answer]
B.	IF stage only [Wrong Answer]
C.	RF stage and one or two IF stages [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A dynamometer wattmeter is suitable for both dc and ac.
TRUE
FALSE

⇒ Indicate the false statement: To combat noise
reduce signalling rate
increase transmitted power
use redundancy
increase channel bandwidth

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ As the temperature of a pure silicon specimen is increased
the number of free electrons increases
the number of holes decreases
the number of holes increases
the number of free electrons and holes increases

⇒ In a digital circuit, a clock is a
crystal type
multivibrator
flip-flop
free running multivibrator

⇒

Match the following:

	List I		List II
A.	lag compensation	1.	Exterior of unit circle \|z\| = 1
B.	lead compensation	2.	PD control
C.	stability	3.	Non-minimum phase
D.	Instability	4.	Left half s plane
		5.	PI control

A-2, B-5, C-1, D-3
A-3, B-1, C-2, D-5
A-1, B-2, C-3, D-4
A-5, B-2, C-4, D-1

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In order to enable TRAP interrupt, which of the following instructions are needed?
El only
SIM only
El and SIM both
None

⇒ SCR can be turned on by

applying anode voltage at a sufficient fast rate
applying sufficiently large anode voltage
increasing the temperature of SCR to a sufficiently
applying sufficiently large gate current.

1, 2, 4 only
4 only
1, 2, 3, 4
none

⇒ In a D latch
D drives R and D drives S
D drives S and D drives R
D drives both R and S
D drives both R and S

⇒ FET can used in
buffer amplifier circuits
cascade amplifier circuits
digital circuits
all of the above

⇒ A linear time-invariant, causal continuous time system has a rational transfer function with simple poles at s = - 2 and s = - 4, and one simple zero at s = - 1. A unit step u(t) is applied at the input of the system. At steady state, the output has constant value of 1. The impulse response of this system is
[exp (- 2t) + exp (-4t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t) - exp (-t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t)] u(t)
[-0.5 exp (- 2t) + 1.5 exp (-4t)] u(t)

⇒ The amount of dielectric heating is inversely proportional to frequency.
TRUE
FALSE

⇒ The carriers of n channel JFET are
free electrons and holes
holes
free electrons or holes
free electrons

⇒ Consider the following program in C 1
-1
1.15
-1.15

⇒ Which of the following uses a capacitor in the feedback path?
Active low pass filter
Active high pass filter
Both (a) or (b)
Neither (a) nor (b)

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒ The multiplication of two n bit numbers gives a product of length less than or equal to
n bits
2ⁿ bits
2n bits
2ⁿ - 1 bits

⇒ In figure, the value of R shoul
5 kΩ
50 kΩ
20 kΩ
10 kΩ

⇒ PCM : Quantising Noise :: Transistor :
Partition noise
Shot noise
Whirl
No noise

⇒ Which of the following insulating material is restricted to temperatures below 100°C?
Micanite
Asbestos
Teflon
Polythene

⇒ If a signal f(t/2) has energy is E/n then energy of the signal f(nt) is equal to __________ (n is constant)
E/2n²
2E/n²
E/n²
2En²

⇒ Electrons within a metal have energy levels from zero to Fermi level E_F.
TRUE
FALSE

⇒ One XOR gate can work as
one bit magnitude comparator
two bit magnitude comparator
either (a) or (b)
neither (a) nor (b)

⇒ A copper specimen has resistivity equal to 1.8 x 10^-8 ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be
1.6 x 10^-8 Ω-m
2 x 10^-8 Ω-m
3 x 10^-8 Ω-m
6 x 10^-8 Ω-m

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ Iron has a body centred cubic structure.
TRUE
FALSE

⇒ If f is more than f_unity the gain of op-amp becomes less than 1.
TRUE
FALSE

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800