Question is ⇒ An electron (charge -e) is rotating in a circular orbit of radius R, around a proton with charge +e at a constant angular velocity ω. The orbital magnetic dipole moment is, Options are ⇒ (A) 0.5 eω R2, (B) eω R2, (C) 2 eω R2, (D) 0.5 eω R3, (E) , Leave your comments or Download question paper.

Question is ⇒ An electron (charge -e) is rotating in a circular orbit of radius R, around a proton with charge +e at a constant angular velocity ω. The orbital magnetic dipole moment is, Options are ⇒ (A) 0.5 eω R2, (B) eω R2, (C) 2 eω R2, (D) 0.5 eω R3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An electron (charge -e) is rotating in a circular orbit of radius R, around a proton with charge +e at a constant angular velocity ω. The orbital magnetic dipole moment is
A.	0.5 eω R² [Correct Answer]
B.	eω R² [Wrong Answer]
C.	2 eω R² [Wrong Answer]
D.	0.5 eω R³ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one is true for writing array variable in Pascal?
The general form of an array variable is an integer or a real variable name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The general form of an array variable must be an integer name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The subscripts in array variable must be separated by dots
The subscripts must be enclosed within parenthesis

⇒ What is the length of SP (Stack pointer) of 8085 μp?
6 bits
8 bits
12 bits
16 bits

⇒ Resonant circuits are used in
audio amplifiers
RF amplifiers
both audio and RF amplifiers
none of the above

⇒ End fire coupler is formed
when two equal radiators are operated in phase quadrature at a distance of λ/4 apart
when two equal radiators are operated in parallel at a distance of λ/4 apart
when two equal radiators are operated in phase quadrature at a distance of λ/2 apart
none of the above

⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ As compared to tuned radio frequency receivers which of the following is the advantage of using superheterodyne receivers?
High gain and better sensitivity
Better selectivity at high frequencies
Stability
Noise suppression

⇒ When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is
zero
constant
alternating
distorted

⇒ The increase in intensity of trace in a CRO causes a change in
beam current
frequency of time base
gain of Y amplifier
accelerating voltage

⇒ An FM signal is modulated by an 8 kHz sine wave and has maximum and minimum frequencies of 100.05 MHz and 99.95 MHz respectively. Its deviation frequency is
100 kHz
100 MHz
500 kHz
108 kHz

⇒ A p matching network for coupling the transmitter output of the antenna is shown in figu
minimum D.C. plate current
maximum D.C. plate current
maximum RF antenna current
specified value of the D.C. plate current

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒

Match the following:

	List I		List II
A.	Reactance theorem	1.	Foster
B.	Driving point impedance	2.	Bartlett
C.	Continued fraction expansion	3.	Cauer
D.	Bisection Theorem	4.	Positive real function

A-1, B-4, C-3, D-2
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ When the mains supply is switched off the contents of primary computer memory are lost.
TRUE
FALSE

⇒ In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
TRUE
FALSE

⇒ For the control system in the given figure, the value of K for critical dampin
1
5.125
6.831
10

⇒ In the given figure, if R = X_C, voltage gai
0 dB
3 dB
-3 dB
20 dB

⇒ If one wants to design a binary counter, preferred type of flip-flop is
D-type
SR type
Latch
JK type

⇒ Which of the following term applies to troposcatter propagation?
SIDs
Faraday rotation
Atmospheric storms
Fading

⇒ Which of the following values represents the open loop gain of typical op-amp?
100
10000
100000
1000000

⇒ When a p-n junction is forward biased. The width of depletion layer decreases.
TRUE
FALSE

⇒ 39.12₁₀ = __________ ₁₀
10111.0001111
100011.0001111
100001.0001111
1111.0001111

⇒ If an admittance Y(s) has a term Ks, the realization would give
an inductance of value K
a resistance of value K
a capacitance of value K
either (a) or(c)

⇒ The early effect in a BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ Let JCOKE = 20 and LPEPSI =15. Consider the statement 25
23
15
17

⇒

Assertion (A): In a CRT, grid is kept at negative potential with respect to cathode.

Reason (R): The function of grid in an electronic tube is to control the number of electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Match the following:

	List I (Electron spin)		List II (Phenomenon)
A.	↑↑↑↑	1.	Antiferromagnetism
B.	↑↓↑↓	2.	Ferrimagnetism
C.	↑↓↑↓	3.	Ferromagnetism

A-1, B-2, C-3
A-3, B-2, C-1
A-2, B-3, C-1
A-3, B-1, C-2

⇒ The INTELSAT-IV satellite launched in 1974 had two earth coverage antenna and two narrower-angle antennas subtending 4.5°. The signal from narrow-angle antenna was stronger than that from earth- coverage antenna by a factor of
17.34/4.5
17.34 x 4.5
(17.34/4.5)²
(17.34/4.5)⁴

⇒ Consider the following Statements regarding resistance strain gauge

The gauge factor is in the range of 2 to 5.
The resistance changes due to change in specific resistance with strain.
The resistance increases with increase in temperature.

Of the above statements, which are correct?
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ Which one of the following power amplifier has the maximum efficiency?
Class A
Class B
Class AB
Class C