Question is ⇒ The I/P impedance of a short circuited quarter wave long transmission line is, Options are ⇒ (A) purely reactive, (B) purely resistive, (C) depend on the characteristic impedance of the line, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The I/P impedance of a short circuited quarter wave long transmission line is, Options are ⇒ (A) purely reactive, (B) purely resistive, (C) depend on the characteristic impedance of the line, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The I/P impedance of a short circuited quarter wave long transmission line is
A.	purely reactive [Wrong Answer]
B.	purely resistive [Wrong Answer]
C.	depend on the characteristic impedance of the line [Wrong Answer]
D.	none of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A circuit using an op-amp is shown in the given figure. It
voltage series feedback
voltage shunt feedback
current shunt feedback
current series feedback

⇒ Read the following statements about Java

It is well suited to design software which works in conjunction with internet.
It is cross platform language.
Java is close to programming language C, C ++ etc.
It is an object oriented.

Which of the above are correct?
All
1, 2 and 3 only
1, 2 and 4 only
2, 3, 4 only

⇒ Consider the following applications

Switch
Attenuator
Phase shifter
Oscillator

In which of the above can a PIN diode be used?
1 2 3 and 4
1 2 and 3 only
1 and 2 only
2, 3 and 4 only

⇒ Consider the following statements about a moving iron instrument

It is an unpolarised instrument.
It has permanent magnet.
It has a fixed coil.
It has two iron vanes.

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1, 3 and 4 are correct
2, 3, 4 are correct

⇒ Basically a potentiometer is a device for
comparing two votage
measuring a voltage
comparing two currents
measuring a current

⇒

Assertion (A): In AM the amplitude of carrier is made proportional to the instantaneous amplitude of modulating wave

Reason (R): In AM, frequency of side band = frequency carrier ± frequency of modulating wave.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A Hartley oscillator uses
a tapped capacitor
a tapped inductor
a tapped inductor for inductive feedback
none of the above

⇒ The maximum number of alphabets/digits or special symbots for character constants in C is
1
2
4
8

⇒ Resistivity of semiconductors is around 100 Ω-m.
TRUE
FALSE

⇒ An SSB-AM signal cannot be demodulated by
Balanced modulator
Complete phase shift generator
Diode balanced modulator
Product detector

⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
TRUE
FALSE

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒ The hexadecimal number system is
widely used in analyzing and programming microprocessors
an obsolete system no more in use
used in calculators only
none of the above

⇒ A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are
0101 and 5
0101 and 10
1010 and 5
1010 and 10

⇒ Transverse magnetic (TM) waves have
magnetic field component H in the direction of propagation
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ 8 bit data can have 256 numbers ranging from 00000000 to 111 111 11.
TRUE
FALSE

⇒ Two thyristors of the same rating and specifications
will have equal on state voltage drops
will have equal forward blocking voltage for the same current
will have different on state voltage drops
may have equal or different on state voltage drops and equal or different forward blocking voltage's for the same current

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ Three point tracking is achieved with
double conversion
padder capacitor
double spotting
variable selectivity

⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic

⇒ For a half wave rectified voltage, the form factor and peak factor respectively are
1.11 and 2
1.57 and 2
1.11 and 1.11
1.57 and 2

⇒ In a colour TV receiver, the function of comb filter is
to pass only the clusters of monochrome signal energy while blocking chrome signals
to pass only chrome signals and block monochrome signals
to block both monochrome and chrome signals
none of the above

⇒ The most commonly used devices for differencing and amplification, in control systems, are
BJT amplifiers
FET amplifiers
operational amplifiers
either (a) or (b)

⇒ In end fire array the principle direction of radiation
is perpendicular to the array axis
is perpendicular to the array axis and also to the plane containing the array elements
coincides with the direction of the array
is at 45° to the direction of array axis

⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above

⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil
fixed at 0 and 1 respectively
X = 1010.......and Y = 0101........
X = 1010..........and Y = 1010
fixed at 1 and 0 respectively.

⇒ A Weinbridge oscillator is a
VHF oscillator
RF oscillator
microwave oscillator
audio frequency oscillator

⇒ Equal amplitude ac signals are given as inputs to both inverting and given as inputs to both inverting and non-inverting terminals of an op-amp. The output will be zero when the phase difference between inputs is
0°
90°
180°
270°

⇒ During discharging a capacitor through a resistance, voltages across R and C are equal in magnitude.
TRUE
FALSE