Question is ⇒ The skin depth of copper is found to be 66 mm at 1 MHz at a certain temperature. At the same temperature and at 2 MHz, the skin depth would be approximately, Options are ⇒ (A) 47 μm, (B) 33 μm, (C) 92 μm, (D) 1.22 μm, (E) , Leave your comments or Download question paper.

Question is ⇒ The skin depth of copper is found to be 66 mm at 1 MHz at a certain temperature. At the same temperature and at 2 MHz, the skin depth would be approximately, Options are ⇒ (A) 47 μm, (B) 33 μm, (C) 92 μm, (D) 1.22 μm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The skin depth of copper is found to be 66 mm at 1 MHz at a certain temperature. At the same temperature and at 2 MHz, the skin depth would be approximately
A.	47 μm [Correct Answer]
B.	33 μm [Wrong Answer]
C.	92 μm [Wrong Answer]
D.	1.22 μm [Wrong Answer]
View Answer 1 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following as regards cumulative disribution function F(x)

0 ≤ F(x) ≤ 1
F(- ∞) = 0
F(∞) = 1
F(x₁) ≤ F(x₂) If x₁ < x₂

Out of above which are correct?
1 and 2 only
1, 2 and 3 only
1, 2, 3 and 4
2 and 4

⇒ For the K map in the given figure, the simplified expressio
x_l x₂ x₄ + x₂ x₄ + x₁ x₃
x₂ x₄ + x₂ x₄ + x₁ x₃
x₁ x₂ x₄ + x_l x₂ + x₃ x₄ + x₂x₄
x₁ x₂ + x₂ x₃ + x₃x₄

⇒ The modulating frequency in frequency modulation is increased from 10 kHz to 30 kHz. The bandwidth is increased by
6
1/6 times
increase by 30 kHz
increase by 20 kHz

⇒ Which of the following is present in both TRF receiver and superheterodyne receiver?
Detector
Mixer
IF amplifier
Local oscillator

⇒ The colour code on a carbon resistor is green-blue-yellow. The tolerance is
± 5%
± 10%
± 20%
± 30%

⇒ With increase in temperature, the electrical conductivity would
increase in metals as well as in intrinsic semiconductor
increase in metals but decrease in intrinsic semiconductor
decrease in metals but increase in intrinsic semiconductor
decrease in metals as well as in intrinsic semiconductor

⇒ A 75 ohm line is first short terminated and minima locations are noted. Then the short is replaced by resistive load and minima location are again noted. If minima location are not altered and VSWR is 3, the value of resistive load is
25 Ω
50 Ω
225 Ω
250 Ω

⇒ The symbol in figure is
UJT
PUT
SCS
SBS

⇒ In an ordinary thyristor
turn on and turn off times are equal
turn on time is more than turn off time
turn off time is more than turn on time
turn on time may be equal, less than or more than turn off time

⇒ By placing an inverter between both inputs of an S-R flip-flop, the resulting flip-flop becomes
J-K flip-flop
D-flip-flop
T-flip-flop
Master salve JK flip-flop

⇒ As temperature increases the number of free electrons and holes in an intrinsic semiconductor
increases
decreases
remains the same
may increase or decrease

⇒ The receiver of a pulsed RADAR can detect signal power in the order of
1 W
0.1 W
10^-5 W
10^-12 W

⇒ In 8085, usually the vector location and the next two memory location contain a JMP instruction. This allows the programs to branch to
a longer subroutine
a shorter subroutine
a subroutine free path
none of the above

⇒ The hexadecimal number 'A0' has the decimal value
80
256
100
160

⇒ In which condition does BJT behave like a closed switch?
Cut off
Saturation
Forward active
Reverse active

⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ
0.99 V
0.9 V
0.1 V
0

⇒ The permanent magnet field system of brushless dc servo- motor is generally on
stator
rotor
partly on stator and partly on rotor
either (a) or (b)

⇒ As frequency is increased, the skin effect
increases
decreases
remains the same
either (b) or (c)

⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
TRUE
FALSE

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ A single phase step up cycloconverter changes 50 Hz to 100 Hz. Then one half wave of input will give rise to
one half wave of output
one full wave of output
two full waves of output
either (b) or (c)

⇒ A quantization error is an essential aspect of ADC
TRUE
FALSE

⇒ Read the following statements about Excel

It supports many arithmetic functions like SUM, ABS, EXP, INT, MOD etc.
It supports many trigonometric functions.
It supports IRR function to calculate interest rate.
It supports PV function to calculate the present value of future receipts.

Which of the above are correct?
All
1, 2 and 3 only
1, and 2 only
1 only

⇒ If we need a low noise device, we should use
BJT
FET
thyristor
UJT

⇒ Hall coefficient is reciprocal of charge density.
TRUE
FALSE

⇒ The number of address lines in EPROM 4096 x 8 is
2
4
8
12

⇒ If the mantissa of a digital computer is 37 bit long then the accuracy of the digital computer will be of
37 decimal places
23 decimal places
11 decimal places
accuracy is independent of the length to mantissa

⇒ An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about
20 μV
5μV
14.14 μV
10 μV

⇒ A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be
38.5 W
400 W
512.5 W
615.5 W

⇒ The advantage of FET over BJT is
high input impedance
lower noise
no thermal runaway
all of the above