Question is ⇒ The counter in the given figur, Options are ⇒ (A) Mod 3, (B) Mod 6, (C) Mod 8, (D) Mod 7, (E) , Leave your comments or Download question paper.

Question is ⇒ The counter in the given figur, Options are ⇒ (A) Mod 3, (B) Mod 6, (C) Mod 8, (D) Mod 7, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The counter in the given figur
A.	Mod 3 [Wrong Answer]
B.	Mod 6 [Correct Answer]
C.	Mod 8 [Wrong Answer]
D.	Mod 7 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ End fire array has a dipole spacing of λ/2.
TRUE
FALSE

⇒ For a Gaussian process, auto-correlation sequence also implies that
statistical independence
statistical dependence
ergodic process
all

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ The use of thermocouple meters for ac measurement leads to a scale which is
linear
square law
logarithmic
exponential

⇒ In a four variable Karnaugh map, eight adjacent cells give a
two variable term
single variable term
three variable term
four variable term

⇒ In a modulator it is found that the amplitude spectrum consists a component at f_c, the carrier frequency and one component each at f_c - f_s and f_c + f_s where f_s is the modulating signal frequency. Then the modulator used is
AM
AM or MBFM with modulation index 0.5
FM
PAM

⇒ The highest modulation frequencies typically used in FM broadcast is
5 kHz
10 kHz
15 kHz
25 kHz

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒ As per temperature limits, the number of categories of solid dielectrics are
7
6
8
5

⇒

Assertion (A): When a zener diode breakdown, occurs the voltage across it is constant.

Reason (R): The upper limit of zener current is determined by power handling capacity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is a microwave power amplifier?
Gunn diode
Reflex klystron
Magnetron
Travelling wave tube

⇒ For an npn transistor connected as shown in the figure V_BE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10^-13A, the emitter curr
30 mA
39 mA
49 mA
20 mA

⇒ Which of the following can be used for measuring capacitance?
De sauty bridge
Maxwell's bridge
Anderson bridge
Hay's bridge

⇒ A CB amplifier has r_e = 6 Ω, R_L = 600 Ω and a = 0.98. The voltage gain is
100
600 x 0.98
98
6

⇒ Binary multiplication 1 x 0 =
1
0
10
11

⇒ Consider the following stateme
1, 2, 3
1, 3, 4
2, 3, 4
1, 2, 4

⇒ In a two phase servomotor the voltages applied to the two stator windings
are equal in magnitude and are in phase
are unequal in magnitude but are in phase
are equal in magnitude but have a phase difference of 90°
are unequal in magnitude and have a phase difference of 90°

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒

Match the following:

	List I (Modulation )		List II (Modulation Index)
A.	DSBFC	1.	μ > 1
B.	DSBSC	2.	μ > 0
C.	SSB	3.	∞
		4.	μ, any value

A-2, B-2, C-3
A-1, B-3, C-3
A-4, B-2, C-1
A-2, B-3, C-1

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ A capacitor used for power factor correction in single- phase circuit decreases
the power factor
the line current
both the line current and the power factor
the line current and increases power factor

⇒ Typical values of current gains for CE, CB and CC amplifiers are
120, 120 and 1 respectively
120, 1 and 120 respectively
1, 120 and 120 respectively
1, 1 and 120 respectively

⇒ RESET OUT signal when high indicates that
program counter etc. are being set
program counter etc. are being reset
either (a) or (b)
none of the above

⇒ To evaluate X = (A + B + 1.2) * (A + B - C) the sequence of operation is
+ + + - * =
* + + + - =
+ + - * + =
- + + + * =

⇒ A disadvantage of microstrip line as the connections of compared to strip line is that former
do not lend themselves to printed circuit
are more likely to radiate
are bulky
are more expensive and complex

⇒ An average response rectifier type electronic voltameter has a d.c. voltage of 10 V applied to it. What is the meter reading?
7.1 V
10 V
11.1 V
22.2 V

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒

Match the following:

	List I (Bits operator in C)		List II (Meaning)
A.	˜	1.	Bitwise XOR
B.	&	2.	Bitwise AND
C.	\|	3.	Bitwise OR
D.	U	4.	One's complement

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-3, C-1, D-4
A-4, B-2, C-3, D-1

⇒ Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
71.68 m²
716 m²
7.16 m²
71.6 m²

⇒ In a CE transistor amplifier, when collector-emitter voltage increases
the instantaneous operating point moves up the load line
the instantaneous operating point moves down the line
load current increases
none of the above