Question is ⇒ In the given figure, the input frequency is such that R = XC., Options are ⇒ (A) v0 lags vi by 45°, (B) v0 lags vi by 90°, (C) v0 leads vi by 45°, (D) v0 leads vi by 90°, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure, the input frequency is such that R = XC., Options are ⇒ (A) v0 lags vi by 45°, (B) v0 lags vi by 90°, (C) v0 leads vi by 45°, (D) v0 leads vi by 90°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure, the input frequency is such that R = X_C.
A.	v₀ lags v_i by 45° [Correct Answer]
B.	v₀ lags v_i by 90° [Wrong Answer]
C.	v₀ leads v_i by 45° [Wrong Answer]
D.	v₀ leads v_i by 90° [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statement is incorrect?
UJT is a 3-terminal diode having two unequally doped regions
A UJT can be triggered by any one of its three terminals
The bi-directional switching characteristics of a diac are symmetrical
As compared to JFETs, MOSFETs generate less noise in high gain amplifiers

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ Highest value of Autocorrelation of a function 100 cos 50 pt is
50
100
zero
100/p

⇒ A circular waveguide carries TE₁₁ mode whose radial electric-field is given
10 cm
3p cm
2p cm
8 cm

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be
0.1
0.05
0.002
0.0001

⇒ P flag is for parity.
TRUE
FALSE

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?
0.0125
0.025
-0.0125
-0.025

⇒ For a transistor to have-a larger β it must have and a
close to zero
close to 0.5
close to unity
nearly infinite

⇒ In a telephone system, the grade of service means
the quality of sound reception at the receiver telephone
the probability that a called for connection is established
the type of wires cables used for the system
none of the above

⇒ It f(t) is an odd function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ In an SCR, the anode current consists of
only holes
only electrons
both electrons and holes
either electrons or holes

⇒ A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are
100 Hz and 50 Hz
50 Hz and 100 Hz
100 Hz each
50 Hz each

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒ Which of the following flip-flop is used as a latch?
J K flip-flop
R S flip-flop
T flip-flop
D flip-flop

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is
0.25
0.5
0.75
1

⇒ For the logic circuit of the given figure the simplified Boolean expression
A ⊕ B
A + B
AB
A + B

⇒ If the potential functions V₁ and V₂ satisfy Laplace's equation within a closed region and assume the same values on its surface, then which of the following is correct?
V₁ and V₂ are identical
V₁ is inversely proportional to V₂
V₁ has the same direction as V₂
V₁ has the same magnitude as V₂ but has different direction

⇒ N-channel FETs are superior to p-channel FETs because
mobility of electrons is smaller than that of holes
mobility of electrons is greater than that of holes
they consume less power
they have high switching time

⇒ Dielectric constant and conductivity of rocky soil and flat sandy soil are around
10 and 20 mho/cm respectively
20 and 10 mho/cm respectively
2 and 5 mho/cm respectively
0.5 and 2 mho/cm respectively

⇒ The total bandwidth needed for an AM signal at 55.25 MHz with 0.5 MHz video modulation is
0.25 MHz
0.5 MHz
1 MHz
10 MHz

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒ A function f(t) = k is
stable
marginal stable
unstable
none

⇒ Consider the following statements about Yagi Uda antenna

It is unidirectional
Its gain is about 7 dB
It is used at VLF
The optimum separation is 0.11

Which of the above are correct?
1 and 2 only
1, 2, 4 only
1, 2, 3, 4
1 and 4 only

⇒ For the logic circuit of the given figure the simplified Boolean expressio
Y = AB + A C
Y = (AB) (A C)
Y = ABC
Y = A B + A C

⇒ In communication receivers the fidelity is provided by
audio stage
detector range
mixer stage
all of the above

⇒ In telephone systems, load is expressed in the unit of
erlangs
decibels
bells
watts

⇒ In sinusoidal PWM for inverters the width of different pulses are not the same.
TRUE
FALSE

⇒

Match the following:

	List I (Properties)		List II (Relations)
A.	Linear but NOT time-invariant	1.	y(t) = t²x(t)
B.	Time-invariant but NOT linear	2.	y(t) = t \|x(t)\|
C.	Linear and time invariant	3.	y(t) = \|x(t)\|
		4.	y(t) = x(t - 5)

A-1, B-3, C-4
A-2, B-3, C-4
A-3, B-1, C-2
A-1, B-2, C-3