Question is ⇒ Induction wattmeter can be used in, Options are ⇒ (A) ac circuit only, (B) dc circuit only, (C) both ac and dc circuit, (D) ac 3 phase only, (E) , Leave your comments or Download question paper.

Question is ⇒ Induction wattmeter can be used in, Options are ⇒ (A) ac circuit only, (B) dc circuit only, (C) both ac and dc circuit, (D) ac 3 phase only, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Induction wattmeter can be used in
A.	ac circuit only [Correct Answer]
B.	dc circuit only [Wrong Answer]
C.	both ac and dc circuit [Wrong Answer]
D.	ac 3 phase only [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is
83.33 μ sec
1 μ sec
0.1 m sec
3.5 m sec

⇒ For a superconductor, the relative permeability is
zero
high
low
either low or high

⇒ In a lag network the input frequency is 100 f_c where f_c is critical frequency. The voltage gain is
0 dB
-20 dB
-40 dB
-60 dB

⇒ The normalised form of 0.0152 x 10¹⁸ is
0.152 x 10¹⁷
1.52 x 10¹⁶
15.2 x 10¹⁵
152 x 10¹⁴

⇒ Which of the following is the least important consideration while selecting a logic technology?
Power dissipation
Noise immunity
Number of pins
Cost

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ A mod-10 counter can divide the clock frequency by a factor of
10
20
210
102

⇒ In a colour TV receiver, PAL Dematrix consists of
chroma detector to separate the three primary colours
delay line and PAL matrix to give U and V signals
delay line and PAL matrix to give RGB colours
none of the above

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ The AM, PM, and TV broadcast frequencies are
of the same order as microwave range
much lower than microwave range
much higher than microwave range
either (a) or (c)

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ In a receiver, at higher frequencies
tracking will be improved
tracking will be poor
selectivity will be poor
image frequency rejection will be poor

⇒ A dc separately excited motor has a constant field current. The armature is fed from a single phase supply through a semi-converter. When a = 0, speed is 600 rpm. If a = 90°, the speed is likely to be
about 300 rpm
about 150 rpm
about 75 rpm
about zero

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ In a thyristors are i = kv^a. The value of a is
about 0.5
about 2
about 5
about 20

⇒ A band limited signal is sampled at the Nyquist rate. The signal can be recovered by passing the samples through
an RC filter
an envelope detector
a PPL
an ideal low pass filter with the appropriate bandwidth

⇒ Z_L = 200 Ω and it is desired that Z_i = 50 Ω The quarter wave transformer should have a characteristic impedance of
100 Ω
40 Ω
10000 Ω
4 Ω

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ The circuit shown depic
voltage series negative feedback
voltage shunt negative feedback
current series negative feedback
current shunt negative feedback

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ The loss of charge method can be used to measure
resistance of shunt
insulation resistance of cable
resistance of shunt winding
both (b) and (c)

⇒ The advantages of flash memory over EEPROM are
higher density
lower cost
both higher density and lower cost
none of the above

⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE

⇒ A sample of N type semiconductor has an electron density of 6.25 x 10¹⁸/cm³ at 300 K. If intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density is
10⁶ / cm³
10⁸ / cm³
10¹⁰ / cm³
10¹² / cm³

⇒ If f(t) is an even function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ The function Y = A B C + AB C + A B C + A BC is to be realized using discrete gates. The inputs available are A, B, C. We need a total of
8 gates
6 gates
10 gates
5 gates

⇒ For a transistor amplifier with self biasing network, the following components are used. R₁ = 4 kΩ, R₂ = 4 kΩ, R_C = 1 kΩ. The approximate value of the stability factor 'S' will be
4
3
2
1.5

⇒ Which of the following radio waves are not reflected by ionosphere?
Waves above 1 kHz
Waves above 1 MHz
Waves above 10 MHz
Waves above 30 MHz

⇒ Frequency band used for radar is generally
VLF
VHF
UHF
EHF

⇒ A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is
1.39 V
0.75 V
13.9 V
7.45 V