Question is ⇒ Figure repres, Options are ⇒ (A) Integrator, (B) Differentiator, (C) High Pass Filter, (D) Band Pass Filter, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure repres, Options are ⇒ (A) Integrator, (B) Differentiator, (C) High Pass Filter, (D) Band Pass Filter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure repres
A.	Integrator [Correct Answer]
B.	Differentiator [Wrong Answer]
C.	High Pass Filter [Wrong Answer]
D.	Band Pass Filter [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
1 V
0.01 V
1 mV
1 μV

⇒ In a semi converter feeding a resistive load, the firing angle is a. Each thyristor conducts for
p radians
(p - a) radians
(p + a) radians
(p - 0.5 a) radians

⇒ A carrier is simultaneously modulated by two sine waves having modulation indices of 0.4 and 0.3. The total modulation index will be
0.1
0.7
0.5
0.35

⇒ KCL is a statement of principle of conservation of energy.
TRUE
FALSE

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop

⇒ In a full bridge inverter, the waveshape of load current depends on
relative values of load parameters R, L and C
relative values of load parameters R and L
relative values of load parameters L and C
gating frequency

⇒ The expression A² + B² - 3 AB when written is Pascal should be written as
A * A + B * B - 3 A * B
A * A + B * B - 3.0 A * B
A * A + B * B - 3.0 * A * B
A * A + B * A - 3 * A * B

⇒ The reverse voltage applied to a varactor diode
is less than avalanche breakdown voltage
is more than avalanche breakdown voltage
may be more or less than a avalanche breakdown voltage
is very high as compared to avalanche breakdown voltage

⇒ Race condition occurs in
synchronous circuit
asynchronous circuit
combinational circuit
all the Digital circuit

⇒ In phase shift keying the input signal is
s_t(t) = A cos ω₀t and s₂(t) = - A cos ω₀t
s₁(t) = s₂(t) = A cos ω₀t
s₁(t) = A cos ω₀t and s₂(t) = A cos (ω₀t + p/2)
s₁(t) = A cos ω₀t and s₂(t) = - A (cos ω₀t + p/2)

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ The number of product terms in the minimized sum of product expression obtained through the following K-map, where d, don't c
2
3
4
5

⇒ The materials which become polarized on the application of mechanical stress are called piezoelectric.
TRUE
FALSE

⇒ Impedance level of Impatt diodes is generally lower than that of Gunn diodes
TRUE
FALSE

⇒ Find the maximum power that can be delivered to a
0.025 W
2.5 W
2.5 W
0.25 W

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE

⇒ The effect of source inductance in a 3 phase fully controlled bridge converter is to
decrease the output voltage
increase the output voltage
decrease the output voltage and increase the output current
increase the output voltage and decrease the output current

⇒ Square law modulators utilise
linear range of V-I characteristics of a diode
linear range of V-I characteristics of a triode
non-linear region of V-I dynamic characteristics of a diode
non-linear region of V-I dynamic characteristics of a triode

⇒ The impulse response h(t) of a linear time-invariant continuous time system is described by h(t) = exp (at) u(t) + exp (βt) u (- t), where u(t) denotes the unit step function, and a and β are constants. This system is stable if
a is positive and β is positive
a is negative and β is negative
a is positive and β is negative
a is negative and β is positive

⇒ The length of character constant P . b b . E . b C . is
9
6
10
7

⇒ A tie set schedule shows
incidence of branches to nodes
incidence of branches to loops
incidence of nodes to loops
none of the above

⇒ In a reactance function
all poles are simple
all poles and zeros are simple
all poles and zeros are simple and lie on jω axis only
all poles and zeros lie on negative real axis

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒ The term efficacy, is defined by
same as efficiency
measure of the ability of a device to produce a desired effect
input/output
(efficiency)²

⇒ A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either short circuited or open circuited

⇒ The counter shown in figure is built using 4 negative edge triggered toggle FFs. The FFs can be set synchronously when R = 0. The combinational logic required to realize a modulo 13 counte
F= Q₄ Q₃ Q₂ Q₁
F= Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ Q₃ Q₂ Q₁

⇒ Which of the following statement is false?
Television signals are propagated as ground waves
Surface waves can propagate on piezoelectric substrates
The skip distance is the maximum distance upto which ionospheric reflection is possible
Tropospheric scatter propagation is always subjects to fading

⇒ In figure, V_C is approximately equa
2 V
4.6 V
8 V
7.6 V

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒ The following components are used to measure power output of a 2 kW TWT amplifier:

TWTA
Low pass/high pass filter
20 dB attenuator
40 dB directional complex with matched load
Power load

What is the correct sequence of connection of these components?
2 - 4 - 1 - 3 - 5
1 - 3 - 4 - 2 - 5
1 - 2 - 4 - 3 - 5
2 - 4 - 1 - 5 - 3