Question is ⇒ The statement <code>IMPLICIT INTEGER (A - F)</code> in FORTRAN identifies, Options are ⇒ (A) all variable names which begin with A, B, C, D, E or F as being of integer type, (B) all character names which begin with A, B, C, D, E, or F as being of integer type, (C) all variable names which begin with A and have 6 characters, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The statement <code>IMPLICIT INTEGER (A - F)</code> in FORTRAN identifies, Options are ⇒ (A) all variable names which begin with A, B, C, D, E or F as being of integer type, (B) all character names which begin with A, B, C, D, E, or F as being of integer type, (C) all variable names which begin with A and have 6 characters, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The statement `IMPLICIT INTEGER (A - F)` in FORTRAN identifies
A.	all variable names which begin with A, B, C, D, E or F as being of integer type [Correct Answer]
B.	all character names which begin with A, B, C, D, E, or F as being of integer type [Wrong Answer]
C.	all variable names which begin with A and have 6 characters [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following are useful in comparing the noise performance of receivers?

Input noise voltage
Noise figure
Noise resistance
Noise temperature

Select answer as per the following codes:
1, 2 and 3
1, 3 and 4
2, 3, 4
1, 2, 4

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800

⇒

Assertion (A): CRT is the most important component of a CRO.

Reason (R): When an electron beam strikes the screen of CRT, a spot of light is produced.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ Consider the following DO statement in Fortran 77 1
10
3
4

⇒ At room temperature the current in an intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ Figure shows a self bias circuit for FET amplifier, I_D = 4 mA. Then I_{S4 mA
2 mA
0.4 mA
0.2 mA}

⇒ A phase shifting transformer is used in conjunction with
DC slide wire potentiometer
Crompton potentiometer
AC coordinate potentiometer
Drysdale potentiometer

⇒ Friction forces acts in a direction
opposite to that of velocity
same as that of velocity
at right angle to that of velocity
partly opposite and partly at right angle to the direction of velocity

⇒ Which of the following is equivalent to AND-OR realization?
NAND-NOR
NOR-NOR
NOR-NAND
NAND-NAND

⇒ Which of the following instruments has non-linear scale?

Moving coil instrument
Moving iron instrument
Electrostatic instrument
Rectifier instrument

Select the answer as per following codes
2 only
2 and 3 only
2, 3 and 1
1, 2, 3 and 4

⇒ For a Gaussian process, auto-correlation also implies
statistical dependence
statistical independence
ergodic process
none of the above

⇒

Assertion (A): In a circuit using FET, gate is approximately at dc ground

Reason (R): Self bias stabilizes the quiescent operating point against changes in JFET parameters

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage
220 V
200 V
198 V
0 volts

⇒ If f(t) is an even function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ For the wave shown in figure, the average valu
7.07 A
0.208333333333333
2.5 A
0.5 A

⇒ Consider the following about 'return' statement in C

On executing the return statement, it immediately transfers the control back to the calling program.
There is no restriction on the number of 'return' statements present in a function.
The 'return' statement must be present at the end of called function.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In Z_RC (s) = 0 at s = ∞, the last element in first Cauer form is
R
C
R and C in series
R and C in parallel

⇒ In a certain network not containing any dependent sources, number of nodes = 4 and number of branches is equal to 6.
4
2
3
5

⇒ - ve feedback in an amplifier
reduces gain
increase frequency and phase distortion
reduce bandwidth
increase noise

⇒ The function f(x - v_ot) represent which of the following?
A stationary wave
A wave motion in forward direction
A wave motion in reverse direction
None of the above

⇒ The Z-inverse of the given Z-transform is _______
unit step
unit ramp
unit impulse
unit parabola

⇒ Free electrons exist in
first band
second band
third band
conduction band

⇒ In a digital system there are three inputs ABC. Output should be high when atleast two inputs are high. Then output =
AB + BC + AC
ABC + ABC + A BC + ABC
AB + BC + AC
AB + BC + AC

⇒ On which bands, do the optical fibers operate?

Ultra violet band
Ultra high frequency band
Visible light band
Infrared band

Select the correct answer from the codes given below:
1 only
1 and 2 only
1, 2 and only
1, 3 and 4

⇒ In amplitude modulation, carrier signals A cos ωt has its amplitude A modulated in proportion with message bearing (low frequency) signal m(t). The magnitude of m(t) is chosen to be __________ .
less than 1
less than or equal to 1
more than 1
none of these

⇒ A microprocessor with a 16-bit address bus is used in a linear memory selection configuration (i.e., Address bus lines are directly used as chip selects of memory chips) with 4 memory chips. The maximum addressable memory space is
64 K
16 K
8 K
4 K

⇒ A single phase full converter gives maximum and minimum output voltage at firing angles of
0 and 180° respectively
180° and 0° respectively
0 and 90° respectively
90° and 0° respectively

⇒ Find the FSV (full scale voltage) in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
0.1 V
7 V
8 V