Question is ⇒ Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r-n is, Options are ⇒ (A) absolutely integrable, (B) absolutely summable, (C) unity, (D) < 1, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r-n is, Options are ⇒ (A) absolutely integrable, (B) absolutely summable, (C) unity, (D) < 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r^-n is
A.	absolutely integrable [Wrong Answer]
B.	absolutely summable [Correct Answer]
C.	unity [Wrong Answer]
D.	< 1 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements:

Taking 2's complement is equivalent to sign change.
In the 2's complement representation the most significant bit (MSB) is zero for a positive number.
In a 4 bit binary representation of a binary number A, A + 1's complement of A = 2⁴.

Which of the above statements are correct?
1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ ∇² is
vector
scalar
depend on direction
none

⇒ The poles of an RC function
are simple and lie or negative real axis
are simple and lie on ω axis
must be complex conjugate
may be anywhere on s plane

⇒ Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than
50 A
37.5 A
25 A
40 A

⇒ During forward blocking state of SCR, the voltage and current respectively are
high and high
low and low
high and low
low and high

⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of
f times/sec
0.5 f times/sec
0.25 f times/sec
2 f times/sec

⇒ Figure represen
Diode rectifier
Schottky diode
Varistor
None of the above

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒

Assertion (A): Thevenin's theorem and Norton's theorem are dual of each other.

Reason (R): Voltage source can be converted into current source and vice versa.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A reflex klystron oscillator is a
low power device
high power device
high efficiency device
both (a) and (b)

⇒ Calculate i(t) for t ≥ 0, assuming the switch has been in position A for a long time at t = 0, the switch is moved to positio
1 + e^{-5 x 10³t}
e^{-5 x 10³t}
1.11 e^{-5 x 10³t}
1.11 (1 - e^{-5 x 10³t})

⇒ In a forward biased p-n junction current enters p material as hole current and leaves n material as electron current of the same magnitude.
TRUE
FALSE

⇒ When Z₁ << Z, The circuit of figure work
inverting amplifier
Schmitt trigger
non-inverting amplifier
source follower

⇒ Gain of an antenna with a circular aperture of diameter 4 meter at frequency of 10 GHz, with directivity 60
60
100
30
90

⇒ In following figure find V_DSQ by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
4 V
- 6 V
- 10 V
6 V

⇒ Consider the following DO statement in FORTRAN 77 7
6
1
8

⇒ For telegraphy the most commonly used modulation system is
FSK
two tone modulation
PCM
single tone modulation

⇒ R, L and C are in parallel. The circuit is switched on to a constant current source I at t = 0. At t = ∞ the current through inductance is I.
TRUE
FALSE

⇒ An op-amp integrating circuit uses
an inductor
a capacitor
both inductor and capacitor
none of the above

⇒ The current flow in a semiconductor is due to
holes
electrons
holes and electrons
holes, electrons and ions

⇒

Match the following:

	List I		List II
A.	lag compensation	1.	Exterior of unit circle \|z\| = 1
B.	lead compensation	2.	PD control
C.	stability	3.	Non-minimum phase
D.	Instability	4.	Left half s plane
		5.	PI control

A-2, B-5, C-1, D-3
A-3, B-1, C-2, D-5
A-1, B-2, C-3, D-4
A-5, B-2, C-4, D-1

⇒ Value of 'K' for the system for which the system is stab
K < 1
K > 1
K < 2
K > 2

⇒ Characteristic wave impedance is
ε/μ
(ε/μ)^1/2
E_x/H_y
H_y/E_x

⇒ Secondary emission is always decremental.
TRUE
FALSE

⇒ In a bipolar transistor, the base collector junction has
forward bias
reverse bias
zero bias
zero or forward bias

⇒ A transistor is operated as non-saturated switch to eliminate
turn on time
turn off time
storage time
delay time

⇒ In a 3 input NAND gate, the number of states in which output is 1 equals
8
1
6
5

⇒ If E is energy level of electron and E_F is Fermi level, then
all quantum states with E less than E_F will be occupied at T = 0
all quantum states with E less than E_F will be empty at T = 0
some quantum states with E less than E_F will be occupied at T = 0
none of the above

⇒ The circuit of figure is used to measure the value R_x. Ammeter resistance R_a = 0.1 Ω voltmeter resistance R_v = 5000 Ω. It R_x1 and R_x2, are the measured values of R_x with switch in position 1 and 2, the mean of R_x1, and R_x2,
9.98 Ω
10 Ω
10.04 Ω
10.1 Ω