Question is ⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is, Options are ⇒ (A) 100, (B) 75, (C) 66.6, (D) 50, (E) , Leave your comments or Download question paper.

Question is ⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is, Options are ⇒ (A) 100, (B) 75, (C) 66.6, (D) 50, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The percentage saving in power of 100% modulated suppressed carrier AM signal is
A.	100 [Wrong Answer]
B.	75 [Wrong Answer]
C.	66.6 [Correct Answer]
D.	50 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a transistor with normal bias
the emitter junction has a low resistance
the emitter junction has a very high resistance
the emitter junction supplies majority carries into the base region
none of the above

⇒ A current tracer responds to
steady current only
pulsating current only
both pulsating and steady current
none of the above

⇒ The range of visible light is
300 to 2000 Å
200 - 4000 Å
4000 to 7700 Å
more than 10000 Å

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒ Which of the following statements is not true in regard to storage time of a transistor?
The transistor is in active region
Both junctions are forward-biased
The collector injects electrons or holes into the base region
It is the time taken by the carriers to leave the base region

⇒ For real and odd signals, the Fourier series coefficient a_k is __________ .
purely imaginary and even
purely real and even
purely imaginary and odd
purely real and odd

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ A sinusoidal voltage is written as v = I_m (R² + X_C²)^0.5 sin 314 t. Its peak value and frequency are
I_m and 50
I_m (R₂ + X²_C)^0.5 and 50
0.707 I_m (R₂ + X²_C)^0.5 and 50
2 I_m (R₂ + X²_C)^0.5 and 50

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ADI A4H?
4 AH, 0
4 AH, 1
4 BH, 0
4 BH, 1

⇒ In a computer the instructions, data, intermediate and final results during processing are held in ALU.
TRUE
FALSE

⇒ In a superheterodyne radio receiver
RF amplifier normally operates at 455 kHz above carrier frequency
mixer input must be tuned to the signal frequency
local oscillator operates below signal frequency
local oscillator frequency is double the IF

⇒ With reference to C programming language, which of the following statements are correct?

An identifier may start with an underscore.
An identifier may end with an underscore.
If is a valid identifier.
The number of significant characters in and identifier is implementation dependent.

Select the correct answer from the codes given below:
1 and 2 only
2 and 3 only
1, 2, 3 and 4
3 and 4 only

⇒ The cut off wavelength in circular waveguide
guide diameter
square of guide diameter
cube of guide diameter
square root of guide diameter

⇒ In an ac circuit that delivers constant power at varying p.f., the current is
lowest when p.f. is leading
lowest when p.f. is lagging
lowest when p.f is unity
the same for all power factors

⇒ If a and b are the width and height of rectangular wave-guide the cut off wavelength λ_c for TE₂₀ mode is equal to
a
a + b
a - b
a² + b²

⇒ The induced magnetic dipole moment is independent of the permanent magnetic dipole moment.
TRUE
FALSE

⇒ The circuit given bel
Circuit is band stop with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is band pass with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is oscillator, oscillation at two frequencies 39.7875 Hz to 1592 Hz depending on R₃, R₄, R₅ and R₆
None of these

⇒ A 4 input AND gate is equivalent to
4 switches in parallel
2 switches in series and 2 in parallel
three switches in parallel and one in series
4 switches in series

⇒ Directive gain is
a power ratio
a voltage ratio
a current ratio
a distance ratio

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes

⇒ The correct relation between energy and charge is
Energy = voltage/charge
Charge = Energy x voltage
Energy = voltage (charge)^0.5
Energy = voltage x charge

⇒ Frequency modulation consists in
varying the frequency and amplitude of the carrier in accordance with the instantaneous value of modulating signal
varying the amplitude of the carrier in accordance with the instantaneous value of the modulating voltage
varying the frequency of the carrier voltage in accordance with the instantaneous value of the modulating voltage
vary the frequency of the carrier voltage

⇒ Lines of magnetic field attract each other.
TRUE
FALSE

⇒ A TEM wave is incident normally on a perfect conductor. The E and H fields at boundary will respectively be
minimum and maximum
minimum and minimum
maximum and minimum
maximum and maximum

⇒ The reflection coefficient on a 500 m long transmission line has a phase angle of - 150°. If the operating wavelength is 150 m, what will be the number of voltage maxima on the line?
0
3
6
7

⇒ Modem warfare has changed from large scale clashes of armies to suppression of civilian populations. Chemical agents that do their work silently appear to be suited to such warfare; and regretfully, there exist, people in military establishments who think that chemical agents are useful tools for their cause, which of the following statements best sums up the meaning of the above passage:
Modem warfare has resulted in civil strife.
Chemical agents are useful in modem warfare.
Use of chemical agents in warfare would be undesirable.
People in military establishments like to use chemical agents in war.

⇒ In MTI radar, clutter means
echos from moving targets
echos from stationary targets
atmospheric noise
thermal noise

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒ In the above circuit, if the power dissipated in the 6 Ω resistor is zero then
20 2∠ 45°
20 ∠ 30°
20 ∠ 45°
20 2∠ 30°