Question is ⇒ D/A converters are generally, Options are ⇒ (A) weighted resistor network, (B) binary ladder network, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper.

Question is ⇒ D/A converters are generally, Options are ⇒ (A) weighted resistor network, (B) binary ladder network, (C) either (a) or (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	D/A converters are generally
A.	weighted resistor network [Wrong Answer]
B.	binary ladder network [Correct Answer]
C.	either (a) or (b) [Wrong Answer]
D.	neither (a) nor (b) [Wrong Answer]
View Answer 1 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following codes is based on BCD format?
EBCDIC
ASCII
Hollerith
both (a) and (b)

⇒ DeMorgan's first theorem is =
A . A = 0
A = A
A + B = A . B
AB = A + B

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ 100101₂ is equal to decimal number
47
37
21
17

⇒ Consider the following statements as regards BPSK and QPSK:

In BPSK we deal individually with each bit of duration T_b
In QPSK we lump two bits to form a symbol
In both BPSK and QPSK signal changes occur at bit rate
In QPSK the symbol can have any one of four possible values

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3
1, 2, 4
2, 3, 4

⇒ For a low level AM system, the amplifiers modulated stage must be
linear devices
harmonic devices
class C amplifiers
non-linear devices

⇒ TTL logic is preferred to DRL logic because
greater fan-out is possible
greater logic levels are possible
greater fan-in is possible
less power consumption is achieve

⇒

Match the following:

	List I		List II
A.	bit	1.	10
B.	nat	2.	e
C.	decit	3.	2

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-2, C-1
A-2, B-3, C-1

⇒ A two port network is said to be reciprocal if
h₁₂ = - h₂₁
AD - BC = 1
y₁₂ = y₂₁
all

⇒ Volume control found on the front panel of television receivers
a ganged resistor
a variable resistor of logarithmic type
a variable resistor of linear type
a trimmer potentiometer

⇒

Assertion (A): TTL uses multiple emitter transistor.

Reason (R): Multiple emitter transistors with about 60 emitters have been developed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The magnitude plot of a rational transfer function G(s) with real coefficients is shown below. Which of the following compensators has such a magnitude p
Lead compensator
Lag compensator
PID compensator
Lead-lag compensator

⇒ In the op-amp circuit of figure, V_{010 V
-10 V
5 V
-5 V}

⇒ For a periodic signal with finite number of discontinuities in each period, at isolated points of discontinuity the series converges to __________ .
difference value of signal on either side of discontinuity
highest value of signal on either side of discontinuity
average value of signal on either side of discontinuity
sum of value of signal on either side of discontinuity

⇒ A generated voltage is equally dependent on three resistances R₁, R₂, R₃ and its value is V = (R₁R₂)/R₃. If tolerance of each resistor is 0.1%, the maximum error in voltage is
0.003
± 0.3%
0.001
± 0.1%

⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is
ASCII
Excess 3 CODE
Gray CODE
none of these

⇒ ICs are
analog
digital
both analog and digital
mostly analog

⇒ As compared to a full wave diode rectifier circuit using centre tapped transformer, the bridge diode rectifier circuit has the main advantage of
higher current carrying capacity
higher efficiency
lower ripple factor
lower PIV

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ The terminals of a power BJT are called
emitter, base, collector
emitter, base, drain
source, base, drain
source, base, collector

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out
84 W
97.44 W
100 W
77.44 W

⇒ A transistor in CE mode is in saturation region. Then the collector is almost at
ground potential
a potential equal to V_CC
a potential equal to 0.5 V_CC
a potential equal to 2 V_CC

⇒ Consider the following test signal patterns

Ramp
Grill
Grey shades
Sine pulse
Picture line up generating equipment

Which of the above are used in TV studios?
All
1, 2 and 3 only
1, 2 and 5 only
2, 3, 4 and 5 only

⇒ Which wave is also called surface wave?
Ground wave
Sky wave
Space wave
Both (b) and (c)

⇒ Transformer coupling is mostly used in
RF amplifier
audio amplifier
both audio and RF amplifier
none of the above

⇒ In a circular waveguide the dominant mode is
TE₀₁
TE₁₁
TE₂₀
TE₂₁

⇒ The hexadecimal number BBC7 is equivalent to decimal number
49761
46791
47691
49761

⇒ In a solar cell, the photovoltaic voltages is the voltage at which the resultant current is
positive
zero
negative
rated current

⇒ In the case of the circuit shown in the figure, the collector current I_C will be, if β = 100, V_BE = 0.7 V, I_CO = 0.1 βA at 20&d
2.26 mA
1.85 mA
0.357 mA
0.185 mA

⇒ The semi-conductor type 2 N 34 indicates
a n-channel MOSFET
a JFET
a diode with two electrodes
a diode with three electrodes