Question is ⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of, Options are ⇒ (A) minority carriers in source, (B) majority carriers in source, (C) charge on gate electrode, (D) minority carriers in drain, (E) , Leave your comments or Download question paper.

Question is ⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of, Options are ⇒ (A) minority carriers in source, (B) majority carriers in source, (C) charge on gate electrode, (D) minority carriers in drain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an insulated gate FET, the polarity of inversion layer is the same as that of
A.	minority carriers in source [Wrong Answer]
B.	majority carriers in source [Correct Answer]
C.	charge on gate electrode [Wrong Answer]
D.	minority carriers in drain [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If X = 1 in the logic equation [X + Z { Y + (Z + X Y)}] { X + Z (X + Y)} = 1, then
Y = Z
Y = Z
Z = 1
Z = 0

⇒ X COPY is an internal DOS command.
TRUE
FALSE

⇒ For a current transformer, the standard secondary rating is
1 A or 5 A
2.5 A
0.416666666666667
5 A or 10 A

⇒ If each stage has a gain of 10 dB and noise figure of 10 dB, then the overall noise figure of a two stage cascade amplifier will be
10
1.09
1
10.9

⇒ During day time ionosphere consist of
D, E, F₂ layers
D, E, F layers
D, E, F₁, F₂ layer
none

⇒ Consider the following circuit configuration

common Emitter
common Base
emitter follower
emitter follower using Darlington pair.

The correct sequence in increasing order of I/P impedance of these configuration:
2, 1, 4, 3
1, 2, 4, 3
2, 1, 3, 4
1, 2, 3, 4

⇒ Probability density function of thermal noise is
Poisson
Binomial
Gaussian
None of the above

⇒ Measurement of Hall coefficient enables the determination of
recovery time of stored carrier
type of conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
Fermi level and forbidden energy gap

⇒ A 200 Hz sound wave is to be transmitted by a 1000 kHz radio wave using frequency modulation. The instantaneous frequency variation will be
100 times a second
200 times a second
400 times a second
1000 times a second

⇒ To bypass a 100 ohm emitter resistor at
10 μF
100 μF
1000 μF
1 μF

⇒ The communicating capacitor reduces turn on time because
it acts as an open circuit
it allows maximum base circuit to flow
it aids in removing the excess carrier from the base region
none of these

⇒ The addition of impurity in extrinsic semiconductor is about 1 part in 10⁸ parts.
TRUE
FALSE

⇒ A Schottky diode has
no minority carriers and very low voltage drop in forward direction
no minority carriers and very high voltage drop in forward direction
large number of minority carriers and very high voltage drop in forward direction
large number of minority carriers and very low voltage drop in forward direction

⇒

Assertion (A): In circular waveguide the attenuation of TE₀₁ mode decreases as the operating frequency increases.

Reason (R): The wall currents in a circular waveguide in TE_Q1 mode are completely circumferential.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
improved efficiency
better linearity
high power output per transistor
the lower modulating power requirement

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ In 8085, which instructions are useful for writing and using subroutines?
CALL
RET
CALL and RET
none of the above

⇒ Which of the following is used as switch?
J-K flip-flop
Master slave J-K flip-flop
T-flip-flop
D-flip-flop

⇒ If f(t) is an odd func
TRUE
FALSE

⇒ Electromagnetic waves transport
energy only
momentum only
energy as well as momentum
neither energy nor momentum

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The group velocity is
1.8 x 10⁸ m/s
2.6 x 10⁸ m/s
3 x 10⁸ m/s
0.3 x 10⁸ m/s

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ In the circuit, V_s = 10 cos ωt, power drawn by the 4Ω resistor is 8 watt. The power facto
1
0.5
0.85
0

⇒ In a coupled coil the primary has 100 turns and secondary has 200 turns. The primary produces, a flux Φ = e^-t. The coefficient of coupling is 1. The voltages induced in secondary is
200 e^-t V
200 e^t V
200 V
none of the above

⇒ The fluctuation in the received signal strength at the receiver of a random variation in the received signal is known as
fluctuation
fading
absorption
cycling

⇒ The parallel RLC circuit shown in figure is in resonance
I_R < 1 mA
| I_R + I_L | > 1 mA
| I_R + I_L | < 1 mA
| I_L + I_C | > 1 mA

⇒

Assertion (A): Gate triggering is the most commonly used method for triggering of an SCR.

Reason (R): Even a small gate current is sufficient to turn on an SCR.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ While selecting a memory chip the feature which should be examined is
capacity
ac characteristics
dc characteristics
all of the above

⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None

⇒ In force voltage analogy the quantity analogous to spring constant K is
R
C
L
1/C