Question is ⇒ (11)2 + (11)3 = (11)?, Options are ⇒ (A) 4, (B) 5, (C) 6, (D) not possible, (E) , Leave your comments or Download question paper.

Question is ⇒ (11)2 + (11)3 = (11)?, Options are ⇒ (A) 4, (B) 5, (C) 6, (D) not possible, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	(11)₂ + (11)₃ = (11)_?
A.	4 [Wrong Answer]
B.	5 [Wrong Answer]
C.	6 [Correct Answer]
D.	not possible [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The HV and other voltage supplies for a TV receiver are obtained from IHVT. The full name for this device is
Internal high voltage transformer
Integrated high voltage transformer
Instant high voltage transformer
Interleaved high voltage transformer

⇒ For an n-channel JEFT having drain source voltage constant if the gate source voltage is increased (more negative) pinch off would occur for
high values of drain current
saturation values of drain current
zero drain current
gate current equal to the drain current

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40.12
4.878
2.2

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ Consider the following statements

A 33 MHz 486 has higher MIPS than 33 MHz 386.
A 33 MHz 486 has higher MFLOPS than 33 MHz 386 of these statements.

Both are true
Both are false
1 is true and 2 is false
1 is false and 2 is true

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ In solids the current flow is due to electrons only.
TRUE
FALSE

⇒ Current in a 2H inductance in 10e^-t A. Admittance of the inductor is
-0.5 mho
0.5 mho
5 mho
10 mho

⇒ Which statement is false as regards holes
Holes exist in conductors as well as semiconductors
Holes constitute positive charges
Holes exist only in semiconductors
Holes and electrons recombine

⇒ Which binary subtraction is incorrect?
100101 - 100011 = 000000
10000000 - 01000000 = 1000000
10111110.1 - 101011.11 = 110010.11
11111111 - 1111111 = 10000000

⇒ In an n channel JFET, V_GS = V_GS(off). Then
I_D is zero
I_D may be zero or positive
I_D is positive
I_D may be zero or negative

⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance

⇒ Poor power factor
reduces load handling capability of electrical system
results in more power losses in the electrical system
overloads alternators, transformers and distribution lines
all

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the modulation index is
1
2
3
4

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a radio receiver, if the intermediate frequency is too low
Image-frequency rejection will improve
Selectivity will be too sharp
The frequency selectivity of the local oscillator will have to be lowered
All of the above

⇒ Value of Z_L for maximum power transfe
R
R + jωL
R - jωL
None of these

⇒ When a constant voltage source and constant current source are in series, the current source is ineffective.
TRUE
FALSE

⇒ In cell communication
carrier frequency change
carrier frequency constant
depend upon location
depend upon geographical area

⇒ Which of the following op-amp circuits has zero resistance in the feedback path?
Inverting amplifier
Summing amplifier
Source follower
Integrating amplifier

⇒ As compared to bipolar junction transistor, a FET
is less noisy
has better thermal stability
has higher input resistance
all of the above

⇒ A step down cycloconverter has an input frequency f. If it uses natural commutation, the output frequency
must be a sub-multiple of input frequency
can be any frequency
must be an even sub-multiple of input frequency
must be an odd sub-multiple of input frequency

⇒ Consider the following statements

An iron cored choke is a nonlinear device.
A carbon resistor kept in a sunlight is a time - invariant and passive device.
A dry cell is a time - varying and active device.
An air capacitor is a time - invariant and passive device

Of these statements
1, 2, 3 and 4 are correct
1, 2 and 3 are correct
1, 2 and 4 are correct
2 and 4 are correct

⇒ What will be the propagation constant at 10 MHz?
3.4 radians/km
34.4 radians/km
344 radians/km
3440 radians/km

⇒

Assertion (A): The behaviour of FET is similar to that of a pentode.

Reason (R): FETs and vacuum triode are voltage controlled devices.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If initial value of PROD is zero and a program adds X to PROD, Y times we get the result
X + Y
XY
X / Y
X - Y

⇒ An instruction used to set cany flag in a computer is classified as
data transfer
arithmetic
logical
program control

⇒ A chopper
converts constant voltage dc into ac and then into variable voltage dc
converts constant voltage dc into variable voltage dc directly
converts ac of one frequency into ac of another frequency
converts ac to dc

⇒ A Maxwell's bridge has the unknown inductance in one arm and resistance in the other three arms.
TRUE
FALSE

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate