Question is ⇒ Which of these is the most recent display device?, Options are ⇒ (A) LED, (B) LCD, (C) VF, (D) (a) and (c), (E) , Leave your comments or Download question paper.

Question is ⇒ Which of these is the most recent display device?, Options are ⇒ (A) LED, (B) LCD, (C) VF, (D) (a) and (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of these is the most recent display device?
A.	LED [Wrong Answer]
B.	LCD [Wrong Answer]
C.	VF [Correct Answer]
D.	(a) and (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In open circuit impedance parameters, the independent variables are
I₁ and I₂
V₁ and V₂
V₁ and I₁
V₂ and I₂

⇒ For a transistor the normal collector voltage is 12 V. If actually it is found to be + 28 V, the trouble could be
R_L is open
R_E is open
C_E is shorted
C_E is open

⇒ In a purely capacitive circuit, the current __________ the voltage by __________ .
lags, 0°
leads, 90°
lags, 90°
lags, 45°

⇒ A plane EM wave is travelling in an unbound loss less dielectric having μ_y = 1 and ε_y = 4, the time average Poynting vector of the wave is 5 W/m³ . The phase velocity v_p (assuming velocity of light as 3 x 10⁸ m/sec) is
1.5 x 10⁸ m/sec
3 x 10⁸ m/sec
2.5 x 10⁸ m/sec
0.5 x 10⁸ m/sec

⇒ Which one is not a valid subscripted variable?
KET(2^* J, 3^* 1 - 4)
MET(J + 2, K - 4)
A (2 I)
VEL(I)

⇒ RMS value is always higher than average value.
TRUE
FALSE

⇒

Match the following:

	List I (Symbol in java)		List II (Meaning)
A.	&	1.	Logical AND
B.	ˆ	2.	AND
C.	\| \|	3.	XOR
D.	& &	4.	Logical OR

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-4, B-2, C-3, D-1
A-2, B-3, C-4, D-1

⇒ Consider following statements :

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

statement (1) is true and (2) is false
statement (1) and (2) both are true
statement (1) is false and (2) is true
statement (1) and (2) both are false

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after transmission through this circuit?
0.4
0.2
0.27
0.54

⇒

Match the following:

	List I		List II
A.	200 MHz	1.	SHF
B.	20 GHz	2.	UHF
C.	500 kHz	3.	VHF
D.	500 MHz	4.	MF

A-3, B-1, C-4, D-2
A-3, B-2, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ The quiescent collector current I_C, and collector to emitter voltage V_CE in a CE connection are the values when
ac signal is zero
ac signal is low
ac signal is negative
either (a) or (b)

⇒ In figure, capacitor is uncharged. The switch is closed at t = 0 at t = 0⁺ di/dt100 A/s
-100 A/s
1000 A/s
-1000 A/s

⇒ In a purely resistive circuit the instantaneous power varies from zero to maximum twice in each cycle.
TRUE
FALSE

⇒ The maximum counting range of a four stage counter using IC 74193 is
0 to 1023
0 to 4093
0 to 65535
0 to 131071

⇒ A 200 turn coil has a self inductance of 10 mH. If the number of turns is doubled, all other quantities remaining the same, the self inductance will be
2.5 mH
5 mH
20 mH
40 mH

⇒ Unit step is a
energy signal
power signal
neither energy nor power signal
none

⇒ Robotic manipulator arms mostly use
hydraulic actuator
pneumatic actuator
electric motor actuator
none of the above

⇒ In terms of classical representation of electrons
an atom is essentially empty
an atom is essentially full
an atom may be essentially empty or full depending on the material
an atom may be essentially empty or full depending on temperature

⇒ The critical frequency of 'F' layer is greater than 30 MHz.
TRUE
FALSE

⇒ For an ideal noise free transistor amplifier the noise factor is
zero
zero dB
1 dB
depends on other factors

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ For a wave v = V _1m sin (ωt + θ₁ ) - V_3m sin (3ωt + θ₃), the rms value is (0.5 V²_1m + 0.5 V²_3m)^0.5
TRUE
FALSE

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
23 dB
25 dB
46 dB
50 dB

⇒ If the open-loop transfer function is a ratio of a numerator polynomial of degree 'm' and a denominator polynomial of degree 'n', then the integer (n - m) represents the number of:
breakaway points
unstable poles
separate root loci
asymptotes

⇒ Which component is allowed to pass through it by a choke filter?
Dc
Ac
Both dc and ac
Only high frequency ac

⇒ Find equivalent resistance. Each resistance is l &Om
5/12 Ω
5/6 Ω
6/5 Ω
6/10 Ω

⇒ Which mode is usually preferred for cascading?
CE
CB
CC
Any of the above

⇒ Higher order TDM levels are obtained by
forming super master groups
using A law
using μ law
dividing pulse width

⇒ Read the following statements about TWT
It uses thermionic emission.
It uses an attenuater.
It is inherently a resonant device.
It has broad bandwidth.
Which of the above are correct?
1, 2, 3 and 4
1, 2 and 3
1, 3 and 4
1, 2 and 4

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math