Question is ⇒ Which one is a linear system?, Options are ⇒ (A) y[n] = x[n] x x[n - 1], (B) y[n] = x[n] + x[n - 10], (C) y[n] = x2[n], (D) (a) and (c), (E) , Leave your comments or Download question paper.

Question is ⇒ Which one is a linear system?, Options are ⇒ (A) y[n] = x[n] x x[n - 1], (B) y[n] = x[n] + x[n - 10], (C) y[n] = x2[n], (D) (a) and (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one is a linear system?
A.	y[n] = x[n] x x[n - 1] [Wrong Answer]
B.	y[n] = x[n] + x[n - 10] [Correct Answer]
C.	y[n] = x²[n] [Wrong Answer]
D.	(a) and (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle a is
0 ≤ a ≤ p
θ ≤ a ≤ p
0 ≤ a ≤ (p - θ)
θ ≤ a ≤ (p + θ)

⇒ A series RLC circuit is at resonance at 200 Hz. If capacitance is increased to four times, the circuit will be in resonance at
200 Hz
400 Hz
100 Hz
800 Hz

⇒ The active elements on the positive and negative plates of lead acid battery are:
lead peroxide and lead
lead and lead peroxide
lead peroxide and lead sulphate
lead and lead

⇒ The input and output of a continuous time system are respectively denoted by x(t) and y(t) Which of the following descriptions corresponds to a causal system?
y(t) = x(t - 2) + x(t + 4)
y(t) = x(t - 4) + x(t + 1)
y(t) = x(t + 4) + x(t - 1)
y(t) = x(t + 5) + x(t + 5)

⇒ A power supply has full-load voltage of 20 V. What will be its no load voltage when its voltage regulation is 100%
0 V
10 V
20 V
40 V

⇒

Match the following:

	List I (F.T and F.S)		List II (Properties)
A.	Fourier Series	1.	Discrete, Periodic
B.	Fourier Transform	2.	Continuous, Periodic
C.	Discrete Time Fourier	3.	Discrete aperiodic
D.	Discrete Fourier Transform	4.	Continuous, aperiodic

A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1
A-1, B-4, C-2, D-3

⇒ Which memory is available in all technologies?
PROM
EEPROM
ROM
EPROM

⇒

Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The term critical frequency denotes
the lowest frequency that is reflected by the ionosphere
the highest frequency that is reflected by the ionosphere at vertical distance
the lowest frequency by which communication is possible between two given points
none of the above

⇒ In the circuit, the value of the voltage source
-22 V
-12 V
+12 V
-10 V

⇒ The mean life time of the minority carriers is in the range of a few
seconds
milli seconds
micro seconds
nano seconds

⇒ Which of the following devices has substrate?
JFET
Depletion Type MOSFET
Enhancement type MOSFET
Both (b) and (c)

⇒ The integral of a unit step function is
an impulse function
a ramp function
a ramp function of slope 1
none of these

⇒ In a varactor diode the increase in width of depletion layer results in
decrease in capacitance
increase in capacitance
no change in capacitance
either (a) or (b)

⇒ Distances near the skip distance should be used for sky-wave propagation
to avoid the Faraday effect
to avoid tilting
to prevent sky-wave and upper ray interference
so as to exceed the critical frequency

⇒ T.V. broadcasting based on
line of sight communication
ionospheric propagation
ground wave
medium wave

⇒ Consider the following stateme
1, 2, 3
1, 3, 4
2, 3, 4
1, 2, 4

⇒ Which of the following is not between F₂ layer and D layer?
E layer
F₁ layer
G region
All of the above

⇒ If V = 100 ∠ 16°, the (V) is
10 ∠ 32°
10 ∠ 8°
10 ∠ 16°
10 ∠ 4°

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ The function shown in figure, can represent a probability density function for A ________
A = 1/4
A = 1/6
A = 1/8
A = 1/2

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after transmission through this circuit?
0.4
0.2
0.27
0.54

⇒ In 8085 microprocessor system, what will be the total delay provided by the following loop.3.154 msec
3.514 msec
2.644 msec
3.166 msec

⇒ Which group of instructions is used to change sequence of operations in a computer program?
Data transfer group
Branch group
Arithmetic group
Logic group

⇒

Assertion (A): Heaviside partial expansion gives a simple procedure to find inverse Laplace transform of the terms having a complex conjugate pair of roots.

Reason (R): If I(s) = P(s)/Q(s) and all roots of Q(s) = 0 are simple, i(t) will have terms with exponentials having real exponents only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In figure I_D = 4 mA. Then V_{GS4.4 V
-4.4 V
0.44 V
-0.44 V}

⇒ If a 'live' conductor of a public supply touches earth metal
supply voltage will increase
supply voltage will decrease
no current will flow
current will flow to earth

⇒ When a communication satellite passes into Earth's shadow, its temperature drops to about __________ ° K.
273
243
170
123

⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
TRUE
FALSE

⇒ Unit of e is __________ .
coulomb/newton-metre
coulomb²/newton-metre
Farad/metre
Farad²/metre