Question is ⇒ In a single phase semiconverter feeding a highly inductive load, the load current is, Options are ⇒ (A) sinusoidal, (B) nearly constant, (C) absolutely constant, (D) rectangular, (E) , Leave your comments or Download question paper.

Question is ⇒ In a single phase semiconverter feeding a highly inductive load, the load current is, Options are ⇒ (A) sinusoidal, (B) nearly constant, (C) absolutely constant, (D) rectangular, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a single phase semiconverter feeding a highly inductive load, the load current is
A.	sinusoidal [Wrong Answer]
B.	nearly constant [Correct Answer]
C.	absolutely constant [Wrong Answer]
D.	rectangular [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a reflex klystron oscillator, repeller electrode is at
low positive potential
high positive potential
negative potential
zero potential

⇒ An infinite ladder is constructed with 1 Ω and 2 Ω resistors shown be
8.18 A
0
0.375
can't determined

⇒ In band III of TV, distant reception (beyond line of sight range) is possible due to
tropospheric bending by refraction
reflection of waves
ionospheric scattering
none of the above

⇒ The nodal method of circuit analysis is based on
KVLs, ohm law
KCLs, ohm law
KCLs, KVL
KCL, KVL, ohms law

⇒ Three phase four wire induction energy meter is used to measure
energy in 3 phase balanced star load
energy in 3 phase balanced delta load
energy in 3 phase unbalanced load
either (a) or (b)

⇒ A single phase semiconverter is feeding a highly inductive load and has freewheeling diode across the load. The waveshapes of output voltage and output current
are similar
are not similar
may be similar or dissimilar
are similar only if firing angle is zero

⇒ Examine the following statements

A small size hydraulic actuator can develop good torque.
It is easy to maintain a hydraulic system leak proof.
Both linear and rotatary hydraulic actuators are available.
Hydraulic power is more easily available than electric power.

Which of the above statements are correct?
all
1 and 2 only
1 and 3 only
2, 3 and 4 only

⇒ An exponential amplifier has diode in feedback path.
TRUE
FALSE

⇒ The disadvantage of transformer coupling in amplifier is
cost of transformer at audio frequencies
size of transformer at audio frequencies
size of transformer at radio frequencies
cost and size of transformer at audio frequencies

⇒ Complex poles give rise to oscillatory terms in the response.
TRUE
FALSE

⇒ The dc output voltage from a power supply
increases with higher values of filter capacitance and decreases with more load current
decreases with higher values of filter capacitance and increases with more load current
decreases with higher values of filter capacitance as well as with more load current
increases with higher values of filter capacitance as well as with more load current

⇒ If the electric field intensity associated with a uniform plane electromagnetic wave travelling in a perfect dielectric medium is given
3.0 x 10⁸ m/sec
2 x 10⁸ m/sec
6.28 x 10⁷ m/sec
2 x 10⁷ m/sec

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
300 Ω
200 Ω
80 Ω
24 Ω

⇒ The most common method for biasing a JFET is
reverse bias
self bias
voltage divider bias
none of the above

⇒ The terms RMS and average values apply only to sine waves.
TRUE
FALSE

⇒ Pre-emphasis circuit is used
after modulation
before modulation
before detection
after detection

⇒ An ac network has a power factor of 0.8 lagging for fundamental frequency. If the applied voltage contains thrid and fifth harmonics, the overall power factor will be
more than 0.8 lagging
0.8 lagging
less than 0.8 lagging
0.8 lagging or less

⇒

Match the following:

	List I (VCR system)		List II (Azimuth angle)
A.	VHS	1.	7°
B.	Video 2000	2.	15°
C.	Betamax	3.	6°

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-1, C-2
A-3, B-2, C-1

⇒ A line has Z₀ = 300 ∠ 0° Ω. If Z_L = 150 ∠ 0° Ω, reflection coefficient is
0.5
0.3333
-0.3333
-0.5

⇒ The V_TH at terminals A and B is equal
0 V
5 V
- 5 V
None of these

⇒ How many cascaded stage of CE amplifiers will result in polarity inversion of the input signal?
Two
Three
Four
None

⇒ High frequency inductors and capacitors are commonly plated with silver. The main purpose of this is to
reduce dc resistance
reduce ac resistance
increase dc resistance
increase ac resistance

⇒ A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at t =
zero
infinity
L/R
R/L

⇒ The minimum number of comparators required to build an 8 bit flash ADC is
8
63
255
256

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ The signumm function written as [sgn(t)] is defined as
sgn(t) = - 1 for t < 0, = 0 for t = 0 and = 1 for t > 0
sgn(t) = 1 for t < 0, = 0 for t = 0 and = - 1 for t > 0
sgn(t) = 0 for t < 0, = 1 for t = 0 and = 0 for t > 0
sgn(t) = 0 for t < 0, = 1 for t³ 0

⇒ The time constant of the network shown in figur
2 RC
5/3 RC
RC/2
None of these

⇒ If f(t) = - f(- t) satisfies Drichlet conditions, then f(t) can be expanded in Fourier series containing
only sine terms
only cosine terms
cosine terms and constant
sine terms and constant

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 10 times that on the moon.
1.73 TC
17.3 GC
17.3 TC
1.73 GC