Question is ⇒ A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ ., Options are ⇒ (A) 16 μs, (B) 15 ms, (C) 6.5 ms, (D) 66 ms, (E) , Leave your comments or Download question paper.

Question is ⇒ A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ ., Options are ⇒ (A) 16 μs, (B) 15 ms, (C) 6.5 ms, (D) 66 ms, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ .
A.	16 μs [Wrong Answer]
B.	15 ms [Wrong Answer]
C.	6.5 ms [Correct Answer]
D.	66 ms [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The geostationary communication satellite APPLE is parked in the equatorial orbit at
102° E longitude over Sumatra
90° E longitude over Bangladesh
74° E longitude over India
67° E longitude over Pakistan

⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields

⇒ The usable bandwidth of ridge wave guide
is lower than that of rectangular waveguide
is higher than that of rectangular waveguide
is almost same as that of rectangular waveguide
is very small as compared to that of rectangular waveguide

⇒ As per Hall effect, if any specimen carrying a current I is applied in a transverse magnetic field B, then an electric field E is induced in the specimen in the direction.
parallel to I
perpendicular to B and parallel to I
parallel to I and B
perpendicular to both I and B

⇒ In a push pull circuit
each transistor conducts for 180°
each transistor conducts for more than 180° but less than 360°
each transistor conducts for less than 180°
the period of conduction of each transistor depends on circuit configuration

⇒ V MOS have the advantage of
faster switching
no thermal run away
both (a) and (b)
none of the above

⇒ The threshold voltage of a MOSFET can be lowered by

using thin gate oxide
reducing the substrate concentration
increasing the substrate concentration.

Of the above statement
3 alone is correct
1 and 2 are correct
1 and 3 are correct
2 alone is correct

⇒ Which of these commutation methods uses an external pulse for commutation?
Class A
Class C
Class E
Class F

⇒ The minimum height of outer atmosphere is
100 km
150 km
200 km
400 km

⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ

⇒ When two 16-input multiplexers drive a 2-input MUX, what is the result?
2-input MUX
4-input MUX
16-input MUX
32 input MUX

⇒ The filter in figure, uses ideal op-amp. I
low pass filter
high pass filter
band pass filter
band stop filter

⇒ The ac collector current is nearly equal to
ac base current
ac signal current
ac supply current
ac emitter current

⇒ One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
improved efficiency
better linearity
high power output per transistor
the lower modulating power requirement

⇒ If noise margin is high, there is lesser chance of false operation.
TRUE
FALSE

⇒ Which of the following is a false statement about Armstrong modulation system?
The system is basically phase, not frequency, modulation
AFC is not needed, as a crystal oscillator is used
Equalization is unnecessary
Frequency multiplication must be used

⇒ In figure, the switch is initially open. At t = 0 switch is closed. v_c (0⁺) and i_L (0⁺)
60 V and - 0.3 A
150 V and zero
zero and 0.3 A
90 V and - 0.3 A

⇒ A 1 MHz sinusoidal carrier is amplitude modulated by a symmetrical square wave of period 100 μ sec. Which of the following frequencies will not be in the modulated signal?
990 kHz
1010 kHz
1020 kHz
1030 kHz

⇒ In P-N junction, the region containing the uncompensated acceptor and donor ions is called
transition zone
depletion region
neutral region
active region

⇒ Which of the following codes is based on BCD format?
EBCDIC
ASCII
Hollerith
both (a) and (b)

⇒ The r_e model equivalent circuit shown in figure is
CE amplifier
CC amplifier
CB amplifier
None of the above

⇒ If initial value of PROD is zero and a program adds X to PROD, Y times we get the result
X + Y
XY
X / Y
X - Y

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ A 256 x 4 EPROM has
8 address pins and 4 data pins
8 address pins and 8 data pins
4 address pins and 8 data pins
4 address pins and 4 data pins

⇒ A coil of resistance R and inductance L has a capacitor C in parallel with it. The source frequency is adjusted to a value equal to resonant frequency. Another capacitor C is added in parallel with the above circuit, the source current will
increase
decrease
remain the same
may increase or decrease

⇒ The factor n in the equation for calculating current for a silicon diode is
1
2
2.5
2 for low levels of current and 1 for high levels of current

⇒ The h parameter equivalent to ac resistance r_e is
h_ib
h_fe
h_ob
h_rb

⇒ An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be
50 A
25 A
less than 50 A but more than 25 A
less than 25 A

⇒ In the circuit shown, all the transmission line sections are lossless. The Voltage Standing Wave Ration (VSWR) on the 60W lin
1
1.64
2.5
3

⇒ Which one of following is a stataic system?
y(n) = x(n) - x(n - 1)
y(n) = x(2n) - x(2n-1)
y(n) = x(n - 1)
y(n) = e^x(n)