Question is ⇒ In figure, the switch S is initially open and steady state conditions are reached. At <i>t</i> = 0 switch is closed. The initial current through 2C capacito, Options are ⇒ (A) zero, (B) 0.0416666666666667, (C) 0.0833333333333333, (D) 0.125, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, the switch S is initially open and steady state conditions are reached. At <i>t</i> = 0 switch is closed. The initial current through 2C capacito, Options are ⇒ (A) zero, (B) 0.0416666666666667, (C) 0.0833333333333333, (D) 0.125, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, the switch S is initially open and steady state conditions are reached. At t = 0 switch is closed. The initial current through 2C capacito
A.	zero [Wrong Answer]
B.	0.0416666666666667 [Correct Answer]
C.	0.0833333333333333 [Wrong Answer]
D.	0.125 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of following is correct condition to check the stability of sysytem in terms of impulse response?
Σ(x(n)) < ∞
Σx(n) < 0
Σx(n) = 0
Σx(n) = ∞

⇒ Short circuit is the dual of open circuit.
TRUE
FALSE

⇒ A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) wh
-6
zero
2
-4

⇒ What does the B register contain after the first MOV B, A has been executed?
40 H
60 H
80 H
80 D

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒ An amplifier has input impedance of 4 kΩ and output impedance of 80 kΩ. It is used in negative feedback circuit with 10% feedback. If open loop gain is 90, the closed loop input and output impedances are
40 kΩ and 8 kΩ respectively
4 kΩ and 80 kΩ respectively
0.4 kΩ and 800 kΩ respectively
8 kΩ and 160 kΩ respectively

⇒ The absorption of radio waves by the atmosphere depends on
the polarization of the waves
the polarization of the atmosphere
frequency of the waves
their distance from the transmitter

⇒ The emitter follower is widely used in electronic instrument because
its voltage gain is less than unity
its voltage gain is very high
its O/P Impedance is low and input impedance is high
its O/P Impedance is high and I/P impedance is low

⇒ A cascade amplifier will have higher cut off frequency
equal to that of single stage amplifier
less than that of single stage amplifier
more than that of single stage amplifier
none of these

⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors

⇒ When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications
22 K, ± 11%, 1/2 Ω
22 K, ± 5.5%, 1/2 Ω
22 K, ± 5.5%, 1/8 Ω
none of these

⇒ The Hall constant in Si bar is given by 5 x 10³ cm³/ coulomb, the hole concentration in the bar is given by
10⁵/cm³
1.25 x 10¹⁵/cm³
1.5 x 10¹⁵/cm³
1.6 x 10¹⁵/cm³

⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒ What will be the maximum conversion time in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
108 sec
63 μ sec
40 sec
80 μ sec

⇒ Electric lines of force do not cross each other because
the lines of force mutually repel each other
the lines of force emanate from a point charge
the tangent to the line of force gives the direction of E and if they cross two tangents for E which is not possible
none of the above

⇒ A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage
220 V
200 V
198 V
0 volts

⇒ Which of the following is type declaration statement in C?
int bar
s = s + 1
king = horse + 1
prin = prin * prin

⇒ In an FM system, when the AF is 500 Hz and the AF voltage is 2.4 V, the deviation is 4.8 kHz. If the AF voltage is now increased to 7.2 V, the new deviation will be
4.8 kHz
9.6 kHz
14.4 kHz
28.8 kHz

⇒ A + A . B =
B
A . B
A
A or B

⇒ The current in a p-n junction diode with V volts applied in p region relative to n region (where I₀ is reverse saturation current, m is ideality factor, k is Boltzmann's constant, T is absolute temp and q is charge on electron) is
I₀ (e^-qV/mkT - 1)
I₀ e^-qV/mkT
I₀ (e^qV/mkT)
I₀ (e^qV/mkT - 1)

⇒ If f(t) = - f(- t) and f(t) satisfies Dirichlet conditions, then f(t) can be expanded in Fourier series having
sine terms only
cosine terms only
cosine and constant terms
sine and constant term

⇒ A parity detector can detect
single error only
single error or odd number of errors
two errors
single or two errors

⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm

⇒ The selectivity of most receivers is determined largely by
sensitivity
characteristics of IF section
antenna direction
all of the above

⇒ In TTL the transistors are driven into and out of saturation.
TRUE
FALSE

⇒ A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of
1 mV
2 mV
1.414 mV
4 mV

⇒ In a vacuum triode μ = r_pg_m.
TRUE
FALSE

⇒ In a 7 segment display the segments a, c, d, f, g are lit. The decimal number displayed will be
9
5
4
2

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp
2
2.5
3
4

⇒ F₂ layer of atmosphere extends from
250 km to 400 km
150 km to 250 km
50 km to 150 km
15 km to 50 km