Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In figure the trace on the CRO wil |

A. | half rectifier wave [Wrong Answer] |

B. | clamped wave [Wrong Answer] |

C. | no trace at all [Correct Answer] |

D. | either (a) or (b) [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is

0.76, 0.24

0.95, 0.3

0.24, 076

0.3, 0.95

⇒ A dynamometer wattmeter is connected in ac circuit. The reading will be

V-A product

average power

peak power

instantaneous power

⇒ In an idealized half wave rectified system the average and r.m.s. values of voltage are __________ respectively.

2V

_{m}/p, V

_{m}/2

V

_{m}/p, V

_{m}/2

V

_{m}/p, V

_{m}/2

V

_{m}.p, V

_{m}/2

⇒ The given characteristic polynomial

*s*

^{4}+

*s*

^{3}+ 2

*s*

^{2}+ 2

*s*+ 3 = 0 has

zero root in RHS of

*s*-plane

one root in RHS of

*s*-plane

two roots in RHS of

*s*-plane

three roots in RHS of

*s*-plane

⇒ A signal is

*x*+

*f*(

*t*) where

*x*is constant and

*f*(

*t*) is a power signal with zero mean value. The power of the signal is

*x*

^{2}

*x*

^{2}+

*f*

^{2}(

*t*)

more than

*x*

^{2}+

*f*

^{2}(

*t*)

less than

*x*

^{2}+

*f*

^{2}(

*t*)

⇒ An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about

20 μV

5μV

14.14 μV

10 μV

⇒ Out of SAM and RAM

access time in both does not depend on address location

in SAM access time depends on address location but not in RAM

in RAM access time depends on address location but not in SAM

in both the access time depends on storage location

⇒ If both the emitter base and the collector base junctions of a bipolar transistor are forward biased, the transistor is in the

active region

saturated region

cut off region

inverse mode

⇒ An enhancement mode MOSFET is off when the gate voltage is

zero

negative

less than threshold value

none of the above

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode

increases

decreases

first increase, then decreases

first decreases then increases

⇒ At millimeter wavelength the favoured mode in circular wave guide is

TE

_{01}

TE

_{11}

TE

_{20}

TE

_{21 }

⇒ Find the maximum power that can be delivered to a

0.025 W

2.5 W

2.5 W

0.25 W

⇒ The output of a diode detector contains

D.C. voltage

modulating signal

RF ripple

all of the above

⇒ The operator precedence in Java is in the order

arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.

increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.

comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.

arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ Consider the following in object oriented programming

- An object is a self contained element of a computer program which represents a related group of interests.
- Each object has a specific role in a program.
- All objects can work with other objects in defined ways.
- Objects are also called instances

All

1, 2 and 3 only

1 and 2 only

1, 2 and 4 only

⇒ The dual of quantity charge is

current

Voltage

flux

*d*Φ/

*dt*

⇒ Henry is equivalent to

Volts/Ampere

Weber/Volt

Weber/Ampere

Weber/Ampere

^{2}

⇒ Fibers have numerical aperture (

*NA*) in the range of 0.15 to 0.4 Fibers with higher

*NA*value would have

reduced losses

high bandwidth

reduced losses and low bandwidth

more losses and low bandwidth

⇒ If quadratic equation

*x*

^{2}- 1000

*x*+ 25 = 0 is solved using floating point arithmetic with 4 digit mantissa, the roots are

.1000 E 4 and .1000 E 4 respectively

.0000 E 4 and .0000 E 4 respectively

.1000 E 4 and .0000 E 4 respectively

None of the above

⇒ Diamagnetic materials do not have permanent magnetic dipoles.

TRUE

FALSE

⇒ The polar plot of G(

*j*ω) = 1/

*j*ω is

positive imaginary axis

positive real axis

negative imaginary axis

negative real axis

⇒ Laplace transform of a unit doublet U

_{-2}(

*t*) is

1/

*s*

*s*

0

1

⇒ Highest value of Autocorrelation of a function 100 cos 50 p

*t*is

50

100

zero

100/p

⇒ A linear discrete time system has the char. equation

*z*

^{3}- 0.81

*z*= 0, the system is

stable

marginally stable

unstable

stability cannot be assessed from the given information

⇒ A white noise

*X*(

*t*) with two-sided power spectral density 1 x 10

^{-10}W/Hz is input to a filter whose magnitude squared response is shown be

5 x 10

^{-7}W

1 x 10

^{-6}W

2 x 10

^{-6}W

5 x 10

^{-6}W

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be

2097152 bits

648 bits

786432 bits

144 bits

⇒ The parameter β of a BJT change by 300%. If self bias is used in the amplifier using this BJT, the quiescent value of I

_{C}and V

_{CE}remain almost the same.

TRUE

FALSE

⇒ In AM, if modulation index is more than 100%, then

bandwidth increases

the wave gets distorted

power of the wave increases

efficiency of transmission increases

⇒ If there are no permanent dipoles in a dielectric material, the dielectric constant is independent of temperature.

TRUE

FALSE

⇒ When the light falling on a photodiode increases, the reverse minority current

increases

increases or decreases

decreases

remains the same