Question is ⇒ When energy is fed into open wire transmission line the energy may get dissipated due to, Options are ⇒ (A) radiation, (B) conductor heating, (C) dielectric heating, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ When energy is fed into open wire transmission line the energy may get dissipated due to, Options are ⇒ (A) radiation, (B) conductor heating, (C) dielectric heating, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When energy is fed into open wire transmission line the energy may get dissipated due to
A.	radiation [Wrong Answer]
B.	conductor heating [Wrong Answer]
C.	dielectric heating [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The reflection coefficient on a 500 m long transmission line has a phase angle of - 150°. If the operating wavelength is 150 m, what will be the number of voltage maxima on the line?
0
3
6
7

⇒ In a shunt-shunt negative feedback amplifier, as compared to the basic amplifier
both input and output impedances, decrease
input impedance decreases but output impedance increase
I/P impedance increases but O/P impedance decreases
both input and O/P impedance increases

⇒ In a microwave coaxial cable the inner conductor radius is a and inner radius of outside conductor is b. For TE₁₁ mode the cut off wavelength is about
a + b
p(a + b)
pa
pb

⇒ The divergence of a vector is a scalar, while the curl of a vector is another
scalar
vector
unit vector
none of the above

⇒ Padders are used in a receiver to
discard the carrier
facilitate tracking
filter the input signal
suppress noise

⇒ In metals the thermal conductivity K and electrical conductivity σ are related as (K/σT) = L, L is known as
Lattice constant
Lorentz number
Lanevin function
Larmor number

⇒ Resistivity of hard drawn copper is
less than that of annealed copper
more than that of annealed copper
same as that of annealed copper
decreasing when temperature increases

⇒

Assertion (A): An unbiased p-n junction develops a built-in potential at the junction with the n-side positive and the p-side negative.

Reason (R): The p-n junction behaves as a battery and supplies current to a resistance connected across its terminals.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be
1011
110
10
1

⇒

Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 1
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The resistance of voltmeter affects the accuracy of measurement in loss of charge method.
TRUE
FALSE

⇒ A full wave rectifier circuit using centre tapped transformer, the input frequency 50 Hz. The frequency of output is
100 Hz
50 Hz
25 Hz
none of the above

⇒ A full wave bridge rectifier is supplied voltage at 50 Hz. The lowest ripple frequency will be
400 Hz
200 Hz
100 Hz
50 Hz

⇒ If the temperature of an extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density is doubled
the minority carrier density is doubled
the minority carrier density becomes 4 times the original value
both the majority and minority carrier densities double

⇒ Each cell of static RAM contains
4 MOS transistors
4 MOS transistors and 1 capacitor
2 MOS transistors
4 MOS transistors and 2 capacitors

⇒ Which of the following refers to SSB suppressed carrier amplitude modulated system?
A3E
H3E
J3E
C3F

⇒ Choose the correct statement/statements :
In case of an antenna, the antenna resistance and loss resistance are not two different quantities.
The loss resistance includes loss by eddy currents, improper earth connections, insulation leakages, etc., but not I²R losses.
Radiation resistance varies directly as square-root of frequency
None

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ A series RLC circuit is supplied from a variable frequency source. The resonant frequency is ω₀. The voltage across L is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ In 2 out of 5 code, decimal number 8 is
11000
10100
11000
1010

⇒ Shaft encoder is used to measure
angular position
linear position
linear velocity
linear acceleration

⇒

Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The output frequency of a cycloconverter can be changed by changing the firing angle.
TRUE
FALSE

⇒ The impulse response h[n] of a linear time invariant system is given by h[n] = ∪[n + 3 ] + ∪[n - 2] -2∪[n -7]. The above system is
stable but non-casual
stable and casual
casual but unstable
unstable and not casual

⇒ A P-N junction offers
high resistance in forward as well as reverse direction
low resistance in forward as well as reverse direction
conducts in forward direction only
conducts in reverse direction only

⇒ A 6 MHz channel is used by a digital signalling system initializing four-level signals. The maximum possible transmission rate is
6M bands/s
12M bands/s
6 M bits/s
12M bits/s

⇒ Which of the following does not cause losses in optical fibre cables?
Impurities
Microbending
Attenuation in glass
Stepped index operation

⇒ Sound wave travels as
longitudinal waves
transverse waves
both longitudinal and transverse waves
either longitudinal or transverse wave

⇒ In a Darlington pair
the emitter of first transistor drives the base of the second
the base of the first transistor drives the emitter of the second
emitters of the two transistors are connected through a resistor
none of the above

⇒ The range of floating point numbers in Java is
1.4 E - 45 to 3.4 E + 38
3.4 E - 45 to 1.4 E + 38
1.4 E - 38 to 3.4 E + 45
3.4 E - 38 to 1.4 E + 45