Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | For TV broadcast, picture signal is modulated in |

A. | SSB [Wrong Answer] |

B. | VSB [Wrong Answer] |

C. | FM [Wrong Answer] |

D. | AM [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The units for apparent power are watts.

TRUE

FALSE

⇒ One limitation of constant

*k*filters is that Z

_{0}is not constant in the pass band.

TRUE

FALSE

⇒ A crowbar circuit is generally needed for protection under fault conditions.

TRUE

FALSE

⇒ The voltage and current distributions on a grounded λ/4 dipole (Marconi antenna) are similar to those of a half wave dipole in space.

TRUE

FALSE

⇒ Quartz crystal has

very small Q

small Q

very high Q

Q less than 1

⇒ The amount of photoelectric emission current depends on the frequency of incident light.

TRUE

FALSE

⇒ In measuring resistance using voltmeter and ammeter, the resistances of voltmeter and ammeter also affect the accuracy of measurement.

TRUE

FALSE

⇒ The ground waves eventually disappear as one moves away from the transmitter because of

tilting

maximum single-hop distance limitation

interference from the sky waves

loss of line-of sight condition

⇒

Match the following:

List I (Laws of Boolean) | List II (Relation algebra) | ||
---|---|---|---|

A. | Distributive law | 1. | x + x = x |

B. | DeMorgans law | 2. | x(y + z) = xy + xz |

C. | Idempotent law | 3. | (x) = x |

D. | Involution law | 4. | (x + y) = xy |

A-1, B-2, C-3, D-4

A-2, B-4, C-1, D-3

A-3, B-4, C-1, D-2

A-4, B-1, C-2, D-3

⇒ A network has only independent current sources and resistance. If values of all resistors are doubled, the values of node voltages

will become half

will remain unchanged

will become double

cannot be determined unless circuit configuration and values of resistors are known

⇒ A step voltages is applied to RLC series circuit having R = 2 Ω, L = 1 H and C = 1 F. The transient current response will be

over damped

critically damped

under damped

any of the above depending the magnitude of voltage

⇒ If V

_{a1}, V

_{a2}, V

_{a0}are the symmetrical components of V

_{a}, then

V

_{a}= V

_{a1}+ V

_{a2}+ V

_{a0}

V

_{a}=

*a*

^{2}V

_{a1}+

*a*V

_{a2}+ V

_{a0}

V

_{a}=

*a*V

_{a1}+

*a*

^{2}V

_{a2}+ V

_{a0}

V

_{a}=

*a*V

_{a0}+

*a*

^{2}V

_{a1}+ V

_{a2}

⇒ In an integral controller

the output is proportional to input

the rate of change of output is proportional to input

the output is proportional to rate of change of input

none of the above

⇒ In a second order system, the time constant t of exponential envelopes depends

only on damping factor

only on natural frequency

both on damping factor and natural frequency

neither on damping factor nor on natural frequency

⇒ The open loop gain of an ideal op-amp is

infinite

very high

neither high nor low

low

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured

at lowest gain crossover frequency

at highest gain crossover frequency

at the gain crossover frequencies

none of the above

⇒ __________ acts as a depolarizer in a dry cell.

ammonium chloride

carbon powder

manganese dioxide

zinc chloride

⇒ Which of these triggering methods for series connected SCRs use LASCR in the gate circuit?

Resistance triggering

Simultaneous triggering

Sequential triggering

Optical triggering

⇒ Unit step is a

energy signal

power signal

neither energy nor power signal

none

⇒ In plotting line spectrum

a graph of complex number F

_{n}versus frequency is plotted

a graph of |F

_{n}| versus frequency is plotted

a graph of the angle of F

_{n}versus frequency is plotted

two graphs viz |F

_{n}| versus frequency and the phase angle of F

*n*versus frequency are plotted

⇒ A lossless transmission line is 50 cm long and operates at a frequency of 500 MHz. Inductance and capacitances present in a line are 0.5 μH/m and 200 pF/m. Phase constant and phase velocity are respectively.

5p, 2p x 10

^{8}m/sec

5p, 10

^{8}m/sec

31.4, 10

^{8}m/sec

31.4, 2p x 10

^{8}m/sec

⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is

8 W

7.5 W

7.1 W

6.8 W

⇒ Thermal noise has a power spectral density which is quite uniform upto frequencies in the order of

100 Hz

10

^{6}Hz

10

^{9}Hz

10

^{13}Hz

⇒ Fourier transform of

*f*(

*t*) =

*j*ω F(

*f*)

2p

*f*F(

*f*)

F'(

*f*)

None

⇒ What is the frequency of audio modulation?

1000 Hz

2000 Hz

3000 Hz

2000 kHz

⇒ (s

*I*- A)

^{-1}is equal to

*adj*(

*sI*- A)/

*det*(

*sI*- A)

*det*(

*sI*- A)/

*adj*(

*sI*- A )

[

*adj*(

*sI*- A)] [

*det*(

*sI*- A)]

none of the above

⇒ MS Excel is an application software for financial planning.

TRUE

FALSE

⇒ A delta modulation system is designed to operate at 3 times the Nyquist rate for a signal with a 3 KHz bandwidth. The quantization step size is 250 mv. The maximum amplitude of a 1 KHz input sinusoidal for which the delta modulator does not show slope overload is :

716.2 mV

500 mV

647.87 mV

400 mV

⇒ If

*p*is the probability of success and

*q*is the probability of failure, then the probability that there are

*r*successes in

*n*trails is

^{n}

*c*

_{r}

*p*

^{r}*q*

^{n}

^{-}

^{r}

^{n}*c*

_{r}

*p*

^{n -}

^{r}*q*

^{r}^{n}

*c*

_{r}

*p*

^{r}*q*

^{n}

^{+}

^{r}

^{n}*c*

_{r}*p*

^{n}*q*

^{n}^{- r}

⇒ The IF frequencies in a TV receiver

38.9 MHz for video and 33.4 MHz for audio

38.9 MHz for both video and audio

33.4 MHz for both video and audio

33.4 MHz for video and 38.9 MHz for audio