Question is ⇒ For stable network the real parts of poles and zeros of driving point functions must be, Options are ⇒ (A) negative, (B) negative or zero, (C) zero, (D) positive, (E) , Leave your comments or Download question paper.

Question is ⇒ For stable network the real parts of poles and zeros of driving point functions must be, Options are ⇒ (A) negative, (B) negative or zero, (C) zero, (D) positive, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For stable network the real parts of poles and zeros of driving point functions must be
A.	negative [Wrong Answer]
B.	negative or zero [Correct Answer]
C.	zero [Wrong Answer]
D.	positive [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure I_D = 4 mA. Then V_{S20 V
4.4 V
0.4 V
0.44 V}

⇒ A gate in which shift register is connected as shown in the figure below. How many clock pulse (after reset to '0') the contents of the shift register are '000' ag
3
6
16
8

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ For a photoengraving the mask used is
master mask
slave mask
working mask
photo mask

⇒ In 8085 microprocessor, which of the following interrupts has the lowest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ The start of modern computer age was started by the event
development of disc drive
development of transistor
development of Hollerith code
design of EVIAC computer

⇒ For aeroplane and navigation frequency band is
VLF
UHF
VHF
EHF

⇒ In colour television V and U signals are
same as I and Q signal
same as R - Y and B - Y
modified I and Q signal
modified R - Y and B - Y

⇒ Which of the following is the digital system?
PWM
PAM
PPM
PCM

⇒ Energy density function is always
even
odd
neither even nor odd
both (a) and (b)

⇒ What is the period of the sinusoidal signal x(n) = 5 cos [0.2 pn]?
10
5
1
0

⇒ The distance between maxima and minima of a standing wave is
λ/4
λ/2
λ
2λ

⇒ The transfer function of a controller is given as K_p + K_d.s where K_p and K_d are constants. What type of controller is this?
Proportional
Proportional plus integral
Proportional plus derivative
Integral plus derivative

⇒ An integrating amplifier has resistance in feedback path.
TRUE
FALSE

⇒ Consider the following stateme
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ In an RC impedance function
the highest critical frequency is a pole
the highest critical frequency is a zero
the highest critical frequency is a pole or zero
the highest critical frequency is a pole at s = 0

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ In integral cycle control of ac regulators, the period of integral cycle control, i.e., (m + n) T should be
less than mechanical or thermal time constant of the system
more than the mechanical or thermal time constant of the system
more or less than the mechanical or thermal time constant
very high

⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil
fixed at 0 and 1 respectively
X = 1010.......and Y = 0101........
X = 1010..........and Y = 1010
fixed at 1 and 0 respectively.

⇒ For real values of x, the minimum value of the function f(x) exp (x) + exp (- x) is
2
1
0.5
0

⇒ The number of p-n junctions in a semiconductor diode are
0
1
2
1 or 2

⇒ Which of the following is high frequency transmission line?
An impedance transformer
Frequency compensator
Flying resistor
None of the above

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒

Assertion (A): Silicon is less sensitive to changes in temperature than germanium.

Reason (R): Cut in voltage in silicon is less than that in germanium.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A stationary process has
all statistical properties independent of time
all statistical properties dependent of time
zero variance
ensemble average equal to time average

⇒ A circuit has two branches 1 and 2 in parallel. If |Q₁| = 8 KVAR and |Q₂| = 6 KVAR, the magnitude of total kvar drawn form supply will be
14 KVAR
2 KVAR
zero
14 or 2 KVAR

⇒ In figure the approximate voltage
base and emitter are - 8 V and - 7.3 V
base and collector are - 8 V and - 5 V
collector and emitter are - 5 V and - 7.3 V
base, emitter and collector are - 8, - 7.3 and - 5 V

⇒ A coil has a resistance of 2 Ω and inductance of 0.1 mH. The applied voltages is suddenly increased from 10 V to 20 V. After steady state condition have reached, the current is
0.0833333333333333
more than 2 A but less than 4 A
0.166666666666667
more than 4 A

⇒ The colour code on a carbon resistor is yellow-violet-orange. The value of resistance is
17000 Ω
27000 Ω
37000 Ω
47000 Ω