Question is ⇒ The chemical properties of atoms are determined by all the electrons and their configuration., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ The chemical properties of atoms are determined by all the electrons and their configuration., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The chemical properties of atoms are determined by all the electrons and their configuration.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the given fi
42737
42739
2
1

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ Which materials find application in MASER?
Diamagnetic
Paramagnetic
Ferromagnetic
Ferrimagnetic

⇒

Assertion (A): A parallel resonant circuit is also called anti-resonant circuit.

Reason (R): In a parallel resonant circuit impedance is maximum at resonance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following statements are executable in FORTRAN 77?
Arithmetic IF
Assign
Call
All of the above

⇒ The angle subtended by earth at geostationary communication satellite is
17.34°
51.4°
120°
60°

⇒ In a microwave coaxial cable the inner conductor radius is a and inner radius of outside conductor is b. For TE₁₁ mode the cut off wavelength is about
a + b
p(a + b)
pa
pb

⇒ Which of the following introduces mode partition noise?
Coaxial line
Waveguide
Fibre transmission line
Both coaxial line and waveguide

⇒ Which of the following circuit cannot be used to demodulate SSB?
Phase discriminator
Produce detector
Balanced modulator
Beat frequency oscillator

⇒ In a junction transistor, the collector cut-off current 'I_CB0' reduces considerably by doping the
emitter with high level of impurity
emitter with low level of impurity
collector with high level of impurity
collector with low level of impurity

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
5 Hz
10 kHz
1 MHz
100 MHz

⇒ A full wave rectifier using centre tapped transformer and a bridge rectifier use similar diodes and have equal no load output voltage. Under equal load conditions
Output voltage of bridge rectifier
Output voltage of bridge rectifier will be more than that of other
Output voltage of both will be exactly equal
Output voltage of any one may be more than that of other

⇒ A capacitor with initial charge q₀ at t = 0⁺ acts as
current source
voltage source
short-circuit
open-circuit

⇒ Electrical contact materials used in switches, brushes and relays must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point

⇒ A universal shift register can shift
from left to right
from right to left
both from left to right and right to left
none of the above

⇒ Which of the following is not a data base function?
DAVERAGE
MAX
DCOUNT
DSTDEV

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation

⇒ Which is most important subsystem for recovering and reconstructing signal in a TDM system?
Envelope detector followed by a low pass filter
Synchronization ckt for proper timing
Bandpass filter to segregate channels
Coherent detector to ensure frequency and phase connection

⇒ The signal cos ω_ct + 0.5 cos ω_mt sin ω_ct is
FM only
AM only
both AM & FM
neither AM nor FM

⇒ The noise temperature of sky is about __________ °K.
100
273
0
30

⇒ The minimum gate source voltage that creates the n-type inversion layer is called
cut off voltage
on voltage
threshold voltage
zener voltage

⇒ In FORTRAN 77 IFIX (-73.2) gives the value
73
-73
-7
-73.2

⇒ Figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output
0
1
AB
AB

⇒ If short-circuited and open circuited impedances are 5 ohms and 20 ohms, then characteristic impedance is
1 ohms
10 ohms
25 ohms
100 ohms

⇒ The signumm function written as [sgn(t)] is defined as
sgn(t) = - 1 for t < 0, = 0 for t = 0 and = 1 for t > 0
sgn(t) = 1 for t < 0, = 0 for t = 0 and = - 1 for t > 0
sgn(t) = 0 for t < 0, = 1 for t = 0 and = 0 for t > 0
sgn(t) = 0 for t < 0, = 1 for t³ 0

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ On which of the following effect do thermocouples work?
Thomson effect
Seeback effect
Peltier effect
Joule effect

⇒ Which of the following statements is/are true for a good conductor of electricity?

Its conductivity decreases with increasing temperature.
Number of free electrons is around 10²⁸ m^-3.
Its conductivity decreases with addition of impurities.
It is a good conductor of heat also.

1, 2, 3 and 4
1 only
2 and 3 only
3 and 4 only

⇒ By the use of which of the following the PPM can be converted to PWM?
A stable multivibrator
Integrator
Monostable multivibrator
Bistable Multivibrator

⇒

Assertion (A): In loss of charge method, it is preferable to use an electronic voltmeter.

Reason (R): The resistance of electronic voltmeter is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true