Question is ⇒ In 8085 microprocessor, a RIM instruction is used to, Options are ⇒ (A) disable the interrupts 7.5, 6.5, 5.5, (B) enable the interrupts 7.5, 6.5, 5.5, (C) read in the serial input data, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, a RIM instruction is used to, Options are ⇒ (A) disable the interrupts 7.5, 6.5, 5.5, (B) enable the interrupts 7.5, 6.5, 5.5, (C) read in the serial input data, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, a RIM instruction is used to
A.	disable the interrupts 7.5, 6.5, 5.5 [Wrong Answer]
B.	enable the interrupts 7.5, 6.5, 5.5 [Wrong Answer]
C.	read in the serial input data [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of logic devices required in a Mod-16 synchronous counter are
4
5
6
7

⇒ The given figure shows dB magnitude plots for type 0, type 1 and type 2 systems. Out of t
curves 1, 2, 3 are for type 0, 1, 2 systems respectively
curves 1, 2, 3 are for type 2, 1, 0 systems respectively
curves 1, 2, 3 are for type 1, 0, 2 systems respectively
curves 1, 2, 3 are for type 1, 2, 0 systems respectively

⇒ The simplest method of suppression of unwanted side band in AM is
filter method
phase shift method
third method
both (a) and (b)

⇒ The first geostationary satellite launched in 1965 was called
ANIK
EARLY BIRD (Intelsat-I)
WESTAR
MOLNIYA

⇒ Which curve represents the fidelity curve of a standard recei
Curve A
Curve B
Curve C
Curve D

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. Which of the following frequency is least likely to be present in the output?
1002 kHz
1000 kHz
999.2 kHz
998.0 kHz

⇒

Assertion (A): If minimum phase system has a gain margin of 8 dB and phase margin of 21°, the system is stable.

Reason (R): For a minimum phase system both GM and PM must be positive for the system to be stable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A RADAR can be used to
aim a gun at an aircraft
to direct guided missiles
to search submarines
all of the above

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the radiated power
730 W
73 W
100 W
None

⇒ The function of interface circuit is
to match output conditions of driver with input conditions of load device
to match output conditions of load device with input conditions of driver
both (a) and (b)
neither (a) nor (b)

⇒ In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
0.9
0.495
0.01
0.005

⇒ Higher order TDM levels are obtained by
forming super master groups
using A law
using μ law
dividing pulse width

⇒ In an R-S latch, race condition occurs when
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ The rate at which information can be carried through a communication channel depends on
carrier frequency
bandwidth
transmission loss
transmitted power

⇒ Radar is essentially an echo ranging system
TRUE
FALSE

⇒ In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is
exp (p)
0.5 exp (p)
exp (p) + 1
exp (p) - 1

⇒ A waveguide twist is used to change the plane of polarization.
TRUE
FALSE

⇒ The work function of a photo surface whose threshold wave length is 1200 A, will be
0.103 eV
0.673 eV
1.03 eV
1.27 eV

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒ A transistor is said to be in a quiescent state when
the amplitude of input and output signal is equal
the phase of input and output signal is identical
no signal is applied to the input
the transistor is unbiased

⇒ A 12 kHz pulse wave-form is amplified by a circuit having an Upper cut-off frequency of 1 MHz. The minimum input pulse width that can be accurately reproduced is
83.33 μ sec
1 μ sec
0.1 m sec
3.5 m sec

⇒ The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
sphere
rectangle
square
ellipse

⇒ If f(t) ↔ F(jω), f(- t) ↔
- F(jω)
F(- jω)
F(jω)
0.5 F(jω)

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When P_c is the unmodulated carrier power and P_t is the total power in the modulated wave, then the maximum power in AM wave is
P_t = 1.5 P_c
P_t = 2.5 P_c
P_t = 2
P_t = 22 P_c

⇒ The magnitude plot of a composite signal x(t) = e^2jt + e^3jt is
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ The programming language in which Excel records the macro code is
basic
visual basic
video basic
basic 2