Question is ⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 10 GHz is about, Options are ⇒ (A) 100°, (B) 50°, (C) 5°, (D) 1°, (E) , Leave your comments or Download question paper.

Question is ⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 10 GHz is about, Options are ⇒ (A) 100°, (B) 50°, (C) 5°, (D) 1°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The width of a radio beam from a 1 m diameter parabolic antenna at 10 GHz is about
A.	100° [Wrong Answer]
B.	50° [Wrong Answer]
C.	5° [Correct Answer]
D.	1° [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0

⇒ An intrinsic silicon sample has 1 million free electrons at room temperature. As the temperature is increased
the number of free electrons increases
the number of free electrons increases but the number of holes decreases
the number of free electrons and holes increase by the same amount
the number of free electrons and holes increase but not by the same amount

⇒ To increase Q factor of a coil, the wire should be
long
thin
thick
long and thin

⇒

Assertion (A): 1C 74181 is an ALU in TTL 7400 series.

Reason (R): 1C 74181 can accept two 4 bit words and can perform any one of possible 16 arithmetic or logic operations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ 8255 A has three 8 bit ports A, B, C for peripheral data transfer. For programming 8255 A, these ports are grouped as
Port A with Port B
Port A with 4 most significant ports of C, port B with 4 least significant ports of C
Port A with Port C
none of the above

⇒ A direct radiating cone type loudspeaker attenuates :
medium range frequencies
very low frequencies
high frequencies
very low and high frequencies

⇒ Eddy current loss is proportional to
f and B²_m
f² and B²_m
f² and B_m
f and B_m

⇒ For the network of figure, z_{115/3 Ω
3/2 Ω
2 Ω
2/3 Ω}

⇒ While forming Routh's array, the situation of a row of zeros indicates that the system
has symmetrically located roots
is not sensitive to variations in gain
is stable
is unstable

⇒ What will be the propagation constant at 10 MHz?
3.4 radians/km
34.4 radians/km
344 radians/km
3440 radians/km

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is
100
50
10
5

⇒ Consider the draw backs

Slope overload
Serration noise
Granular noise

Which of these draw backs does Delta modulation have?
1 and 2 only
2 and 3 only
1 and 3 only
1, 2, 3

⇒ The stack pointer holds the address of the desired memory location.
TRUE
FALSE

⇒ In rectifier circuits, ripple factor RF and form factor FF are related as
RF = (FF² - 1)^0.5
RF = FF
RF = FF - 1
RF = (FF - 1)^0.5

⇒

Assertion (A): A BJT can be used as a switch.

Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which amplifier has a voltage gain of less than 1?
Common emitter
Common collector
Common base
Both CB and CC

⇒ Which of the following is a valid real constant?
1281
1281
KM
11821

⇒ How can the bandwidth of a control system be increased?
By the use of phase lead network
By the use of phase lag network
By the use of both phase-lag and phase-lead network
By the use of cascaded amplifiers in the system

⇒ Consider the following instruction of 8085 μp :

MOV M, A
AODC
MVI A, FF
CMP M

Which of these cause change in the status of flag(s)?
1 and 2
1, 2 and 3
3 and 4
2 and 4

⇒ Self bias is an example of __________ feedback that tends to stabilize the drain current against changes in temperature and JFET replacement.
variable
low
negative
positive

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......

⇒ Which of the following is a valid logical expression in Pascal?
2.5 : = A
(A + B) < < (C + D)
A = < B
A > = B

⇒ A wave is frequency modulated with an index of 0.1 and its frequency is multiplied by 8 times, the modulation index is
not changed
decreased 8 times
increased 4 times
increased 8 times

⇒ The given figure shows log magnitude versus ω plots of a system for different values of gain. For this sy
curve 1 shows highest gain margin and curve 2 shows poorest gain margin
gain margins shown by the three curves are equal
curve 1 shows poorest gain margin and curve 3 shows highest gain margin
curve 3 shows poorest gain margin while curve 1 shows highest gain margin

⇒ The collector voltage V_C of the circuit shown in the given figure aside is approxima
2 V
4.6 V
8 V
8.6 V

⇒ Fill in the suitable word in the blanks is the following questions. The electron in the outermost orbit is called __________ electron.
valence
covalent
acceptor
donor

⇒ Wired AND connection can be used in TTL with totem pole output.
TRUE
FALSE

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation