Question is ⇒ A quarter wave line short circuited at load end behaves as, Options are ⇒ (A) an inductance, (B) an inductance and capacitance in series, (C) a capacitance, (D) an inductance and capacitance in parallel, (E) , Leave your comments or Download question paper.

Question is ⇒ A quarter wave line short circuited at load end behaves as, Options are ⇒ (A) an inductance, (B) an inductance and capacitance in series, (C) a capacitance, (D) an inductance and capacitance in parallel, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A quarter wave line short circuited at load end behaves as
A.	an inductance [Wrong Answer]
B.	an inductance and capacitance in series [Wrong Answer]
C.	a capacitance [Wrong Answer]
D.	an inductance and capacitance in parallel [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Performance of a PIN diode switch is represented by
insertion loss when switch is off
insertion loss when switch is on
insertion loss when switch is on and isolation loss when switch is off
insertion loss when switch is off and isolation loss when switch is on

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode

⇒ The average noise temperature of Earth, as viewed from space, is __________ °K.
254
303
100
500

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒ The eign values of n x n matrix A are the root of the characteristic equation 1λI - AI = 0
TRUE
FALSE

⇒ The breakdown voltage in a zener diode
is almost constant
is very small
may destroy the diode
decreases with increase in current

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Both X and Y plates of a CRO are excited by ac signals. The display is an ellipse which makes one rotation in 5 seconds. This means that
the frequency of one input is 5 times that of other
the difference between the frequencies of the two signals is one fifth of hertz
the difference between the frequencies of the two signals is 5 Hz
either (a) or (c)

⇒ A woofer should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ A single phase energy meter operates on induction principle.
TRUE
FALSE

⇒ Boolean expression for the output of XNOR (Equivalent) logic gate with inputs A and B is
AB + AB
AB + AB
(A + B). (A + B)
(A + B). (A + B)

⇒ In a rare gas, the molecules of some atoms have an excess positive or negative charge. The electric field tends to shift positive ions relative to negative ions. This is known as ionic polarization.
TRUE
FALSE

⇒ A carry look ahead adder is frequently used for addition because
it costs less
it is faster
it is more accurate
is uses fewer gates

⇒ The Thevenin equivalent circuit to the left of AB has R_{eq2 Ω
4 Ω
1 Ω
3 Ω}

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ Gain of isotropic antenna is
10 dB
0 dB
∞
1 dB

⇒ Consider the following operation in a computer

Multiplication of scalar
Iversion of matrix
Printing a line of 120 characters on a printer

Which of the above is a subroutine?
1 and 2 only
1 and 3 only
1, 2 and 3
2 only

⇒ In a fascimile reproduction time to scan one line is 2 ms. If it has 4% blanking, the visible trace time is
1.92 ms
2.08 ms
50 ms
0.08 ms

⇒ The iron core of a coil is removed so that it becomes an air cored coil. Its inductance will
increase
decrease
remain the same
may increase or decrease

⇒ In 8085, Whenever a signal is received at TRAP terminal its program execution is transferred to a subroutine on address __________ .
0000 H
0024 H
002 CH
provided by the address generation logic

⇒ A 4 : 1 multiplexer requires __________ data select line.
1
2
3
4

⇒ Two voltages are -5 V and -10 V. In positive logic
-5 V is 1 and -10 V is 0
-10 V is 1 and -5 V is 0
-5 V is 1 in some circuits and 0 in others
-10 V is 1 in some circuits and 0 in others

⇒ A perfect conductor is a perfect absorber of electromagnetic waves.
TRUE
FALSE

⇒ Which of the following is necessary transistor action?
The base region must be very wide
The base region must be very narrow
The base region must be made of some insulating material
The collector region must be heavily doped

⇒ When a power diode is conducting, the voltage drop across it is about
I V
5 V
20 V
50 V

⇒ In case of surface waves the field strength at a point is directly proportional to
antenna height
wave frequency
current of the antenna
distance of the point from the antenna

⇒ In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is
zero
45°
90°
180°

⇒ If operator 'a' = 1 ∠120° then (1 + a + a²) =
-a
-a²
1
0

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒ A capacitor having capacitance C is raised to voltage V. The energy stored will be
CV²
V²/C
0.5 V²C
0.5 C²V