Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | For a n-channel JFET with r_{0} = 10 kW, (V_{Gs}= 0 V, V_{P} = - 6 V)the drain resistance r_{d} at V_{GS}= - 3 V is given by |

A. | 40 kΩ [Correct Answer] |

B. | 2.5 kΩ [Wrong Answer] |

C. | 4.44 kW [Wrong Answer] |

D. | 120 kW [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ According to maximum power transfer theorem, the maximum power is absorbed by one network from another network when

the impedance of one of the networks is half that of the other

the impedance of one is the complex conjugate of the other

the impedance of one is equal to that of the other

none of the above

⇒ Consider the following types of distortions in diode detectors

- Distortion is caused due to the reason that dc and ac load impedances are unequal
- Distortion is caused because ac load impedance has a reactive component at high audio frequencies
- Audio frequency diode current is less than dc current

1, 2 and 3

1 and 2

1 and 3

2 and 3

⇒ For a periodic signal with finite number of discontinuities in each period, at isolated points of discontinuity the series converges to __________ .

difference value of signal on either side of discontinuity

highest value of signal on either side of discontinuity

average value of signal on either side of discontinuity

sum of value of signal on either side of discontinuity

⇒ In envelope detection of an AM waveform

One side band and full-ampiitude carrier are needed

Both side bands and full-amplitude carrier are needed

Only two side bands are needed

Upper side band and part of carrier are needed

⇒ The purpose of earthing electric appliances is

to provide safety against shock

to ensure that appliance works satisfactorily

to ensure that appliance gets full voltage

all of the above

⇒ A uniform plane wave in the free space is normally incident on an infinitely thick dielectric slab (dielectric constant ε

*= 9). The magnitude of the reflection coefficient is*

_{r}0

0.3

0.5

0.8

⇒ High frequency oscillations can be caused by

electric coupling

magnetic coupling

ground loop

all of the above

⇒ Δ

^{2}V = - r/E is known as __________ equation

Poisson

Fourier

Laplace

Maxwell

⇒ An air-filled rectangular waveguide has dimensions 8

*cm*x 10

*cm*. The phase velocity of guided wave at frequency of 3 GH

*z*for TE

_{10}mode is

1.5 x 10

^{8}

*m/s*

5.5 x 10

^{8}

*m/s*

3.46 x 10

^{8}

*m/s*

0.18 x 10

^{7}

*m/s*

⇒ A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are

100 Hz and 50 Hz

50 Hz and 100 Hz

100 Hz each

50 Hz each

⇒ Monostable multivibrator is called one-shot or single-shot circuit because it

can be used once

can be used single and not with other circuits.

always returns by itself to its single stable state

changes to quasistable for a fixed period of time upon receipt of triggering signal.

⇒ The value of current read by ideal ammeter A in figure is __________ amp

0

3

2.5

5

⇒ When a binary adder is used as BCD adder, the sum is

correct when it is < 9

correct when it is > 9

correct when it is < 16

none of these

⇒ When a high voltage reference is required it is advantageous to use two or more zener diodes in series to allow

higher voltage

higher dissipation

lower temperature coefficient

all of the above

⇒ For a quadratic factor in denominator of transfer function the phase angle at corner frequency (in Bode phase angle plot)

is -90°

is +90°

depends on the damping factor

none of the above

⇒ The design of wave filter is based on characteristic impedance which is

pure resistance

pure reactance

pure resistance in pass band and pure reactance in attenuation band

pure reactance in pass band and pure resistance in attenuation band

⇒ When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.

TRUE

FALSE

⇒ A dielectric should have poor heat conductivity.

TRUE

FALSE

⇒ A computer program is used to read M and print the sum 2 + 4 + 6 + 8 +.........+ 2M. If M = 9 , the print out will show the number

9

18

90

100

⇒ Which of these are universal gates?

Only NOR

Only NAND

Both NOR and NAND

NOR, NAND, OR

⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of

minority carriers in source

majority carriers in source

charge on gate electrode

minority carriers in drain

⇒ In microwave communication links, when fading due to rain attenuation occurs then technique adopted for solving the problem would include

antenna replacement and feed correction

amplitude timing and phase correction

polarization shifting and code diversity

path diversity and frequency diversity

⇒ Which one is correct option?

Phase velocity is greater than light velocity

Group velocity is greater than light velocity

Phase velocity is equal to group velocity

Phase velocity is less than light velocity

⇒ Which of the following frequencies cannot be used for reliable beyond-the-horizon terrestrial communications without repeaters?

25 kHz

15 MHz

750 MHz

12 GHz

⇒ In the circuit below, the diode is ideal. The voltage V is give

min(V

_{i}, 1)

max(V

_{i}, 1)

min (-V

_{i}, 1)

max (-V

_{i}, 1)

⇒ The output of a linear system for any input can be computed in which of the following ways?

Only by summation of inpulse response by convolution integral

Only by summation of step response by superposition integral

Neither a nor b

Either (a) or (b)

⇒ The conductivity of a semiconductor crystal due to any current carrier is not proportional to

mobility of the carrier

effective density of states in the conduction band

electronic charge

surface states in the semiconductor

⇒ A microprocessor needs memory chips and input-output chip to form a microcomputer.

TRUE

FALSE

⇒ In which counter does the maximum frequency depend on the modulus?

Synchronous

Ripple

Both synchronous and ripple

Neither synchronous nor ripple

⇒

**Assertion (A):** In circular waveguide the attenuation of TE_{01} mode decreases as the operating frequency increases.

**Reason (R):** The wall currents in a circular waveguide in TE_{Q1} mode are completely circumferential.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct