Question is ⇒ In 8085 microprocessor, even after a Reset operation which of the following interrupts remains enabled?, Options are ⇒ (A) INTR, (B) RST 5.5, (C) RST 7.5, (D) TRAP, (E) , Leave your comments or Download question paper.

Question is ⇒ In 8085 microprocessor, even after a Reset operation which of the following interrupts remains enabled?, Options are ⇒ (A) INTR, (B) RST 5.5, (C) RST 7.5, (D) TRAP, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 8085 microprocessor, even after a Reset operation which of the following interrupts remains enabled?
A.	INTR [Wrong Answer]
B.	RST 5.5 [Wrong Answer]
C.	RST 7.5 [Wrong Answer]
D.	TRAP [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The forms of IF statements in FORTRAN 77 are called
logical IF and Block IF
logical IF, block IF and arithmetic IF
logic IF, block IF, arithmetic IF and negate IF
logical IF and arithmetic IF

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Consider the following part of a C program float a
2 and 9
2.0 and 9.0
2.0 and 2.0
9.0 and 2.0

⇒ An 8 level encoding scheme is used in a PCM system of 10 kHz channel BW. The channel capacity is
80 kbps
60 kbps
30 kbps
18 kbps

⇒ An iron specimen has µ_r = 1000 when B = 0.3 T. If B = 0.35 T, µ_r
will be 1000
will be less than 1000
will be more than 1000
may be more or less than 1000

⇒

Assertion (A): The root locus of a control system is symmetrical about real axis.

Reason (R): For all polynomials with real coefficients, complex poles always occur in conjugate pairs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4

⇒ Which of the following circuit would be preferred for a 355 KHz IF amplifier?
Resistance loaded
Double tuned transformer
Video amplifier
Class C

⇒ Figure shows four D type FFs are connected as a shift register using an XOR gate. The initial state and 3 subsequent states for 3 clock pulses are also g
0
1111
1001
1000

⇒ AE 139 is a
tunnel diode
germanium power transistor
photoconductive cell
silicon diode

⇒ Consider a multiplexer with X and Y as data inputs and Z as control input. Z = 0 selects input X and Z = 1 selects input Y. What are the connections required to realize the 2-variable Boolean function f = T + R, without using any additional hardware?
R to X, 1 to Y, T to Z
T to X, R to Y, T to Z
T to X, R to Y, 0 to Z
R to X, 0 to Y, T to Z

⇒ For the system of the given figure |G(jω)| = 0 dB at &omeg
0
1 rad/sec.
∞
2.38 rad/sec.

⇒ The sensitivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ In case of probability of the message is 1 to 16 then the information will be
16 bits
8 bits
4 bits
2 bits

⇒ In a varactor diode the increase in width of depletion layer results in
decrease in capacitance
increase in capacitance
no change in capacitance
either (a) or (b)

⇒ An 8-bit microprocessor has 16 bit address bus A₀ - A₁₅. The processor addresses a 1-K byte memory chip as shown. The address range for the chi
(F00F)_H TO (F40E)_H
(F000)_H TO (F3FF)_H
(F100)_H TO (F4FF)_H
(F700)_H TO (FAFF)_H

⇒ Consider the following in C 4.2 and 300
4 and 300 respectively
4.2 and 300.00 respectively
4 and 300.00 respectively

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
TTL
ECL
PMOS
CMOS

⇒ Which of the following is a digital modulation technique?
PCM
PSK
DM
All

⇒ In a transistor push pull amplifier
there is no dc present in the output
there are no even harmonics in the output
both (a) and (b)
neither (a) nor (b)

⇒ Consider the following rules about integer constant in C

An integer constant must have at least one digit.
An integer constant must not have a decimal point.
An integer constant may be positive or negative.
The default sign is positive.
A maximum of one comma or blank is allowed.

Which of the above are correct?
All
1, 2, 3, 4 only
1, 2, 3, 5
2, 3, 4, 5 only

⇒ Some advantages of optical fibre cables are

small diameter
Immunity to cross talk and EM interference
Laser and LED modulation methods lend themselves ideally to digital operation

Which of the above are correct?
1 only
1 and 2
1, 2, 3
2, 3

⇒ The power density spectrum of noise voltage of resistor R can be expressed as
2 kTR
1 kTR
0.5 kTR
0.25 kTR

⇒

Assertion (A): Microprocessor 8085 can address 65536 memory locations.

Reason (R): Microprocessor 8085 has 16 address lines.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In pulse transmitter the ratio of time on to time off is called
efficiency
duty cycle
base
bandwidth

⇒ A 300 V voltmeter has an accuracy of ± 2% of full scale deflection. When the reading is 222 V, the actual voltage
lies between 217.56 and 226.44 V
lies between 217.4 and 226.6 V
lies between 216 and 228 V
is exact 222 V

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long