Question is ⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is, Options are ⇒ (A) sin-1 ξ, (B) cos-1 ξ, (C) tan-1 ξ, (D) cot-1 ξ, (E) , Leave your comments or Download question paper.

Question is ⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is, Options are ⇒ (A) sin-1 ξ, (B) cos-1 ξ, (C) tan-1 ξ, (D) cot-1 ξ, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is
A.	sin^-1 ξ [Wrong Answer]
B.	cos^-1 ξ [Correct Answer]
C.	tan^-1 ξ [Wrong Answer]
D.	cot^-1 ξ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ideal op-amp can amplify dc signals
TRUE
FALSE

⇒ In figure, the time constant for the capacitor chargin
6 μs
10 μs
15 μs
25 μs

⇒ Which one of the following is correct?
Coding reduces the noise in the signal
Coding deliberately introduces redundancy into messages
Coding increases the information rate
Coding increases the channel bandwidth

⇒ In following figure find V_GG by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
0.67 V
6.7 V
7 V
0.3 V

⇒

Assertion (A): A class C amplifier can also be used as frequency multiplier

Reason (R): When narrow current pulses drive a resonant circuit the output can be a near perfect sine wave

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Determine the potential difference between the points A and B in the steady s
40 V
60 V
25 V
75 V

⇒ A FET has
very high input resistance
very low input resistance
high connection emitter junction
forward biased PN junction

⇒ A PC can be upgraded to a multimedia PC by adding CD ROM drive, sound card etc.
TRUE
FALSE

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ IF amplifiers for radio receivers are often tuned to
456 Hz
456 kHz
3456 MHz
456 GHz

⇒ The programming language in which Excel records the macro code is
basic
visual basic
video basic
basic 2

⇒ A disadvantage of microstrip line as the connections of compared to strip line is that former
do not lend themselves to printed circuit
are more likely to radiate
are bulky
are more expensive and complex

⇒ If the mantissa has a sign bit of 0 and the exponent is changed from a negative number to a more positive number the result is
a positive number and closer to zero
a positive number and away from zero
a negative number
a negative number and closer to zero

⇒ The circuits with active pull up are preferred because of their stability for
wired - AND operation
wired - OR operation
bus operated system
reasonable dissipation and speed of operation

⇒ In figure the coordinates of Q point on the load line are (Neglect V_{BEI_C = 10 mA, V_CE = 15 V
I_C = 5 mA, V_CE = 22.5 V
I_C = 5 mA, V_CE = 15 V
I_C = 10 mA, V_CE = 22.5 V}

⇒ In a CRO, the time base signal is applied to
X plates
Y plates
either X or Y plates
alternately X and Y plates

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ Barkhausen criterion of oscillation is
Aβ > 1
Aβ = 1
Aβ = < 1
Aβ ≤ 1

⇒ At T = 0, the resistivity of a perfect single crystal of a metal is
0
low
high
finite

⇒ Typical value of reverse current in a semiconductor diode is
0.0416666666666667
0.1 A
1 μA
0.1 μA

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ If V_r is the reverse voltage across a graded P-N Junction, then the junction capacitance c_j is proportional to
(V_r)²
(V_r)ⁿ
(V_r)^-n
(V_r)^3/2

⇒ According to maximum power transfer theorem, the maximum power is absorbed by one network from another network when
the impedance of one of the networks is half that of the other
the impedance of one is the complex conjugate of the other
the impedance of one is equal to that of the other
none of the above

⇒

Assertion (A): In C arithmetic operations are pemiissible on ints, floats and chars.

Reason (R): In C every arithmetic operator must be written explicitly.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Two sinusoidal voltage sources v₁ = 50 sin (100t) and v₁ = 50 sin (100t + p) are connected in parallel and fed an inductance X_L = 2Ω. The cuirent through X_L is
25 A
about 17.5 A
zero
50 A

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒ The presence of some holes in an intrinsic semiconductor at room temperature is due to
valence electrons
doping
free electrons
thermal energy

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ A notch filter is sometimes used in communication receivers to
reduce receiver gain at some specific frequency
increase receiver gain at some specific frequency
made selectivity more precise
spread the bandwidth