Question is ⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is, Options are ⇒ (A) 108 W, (B) 1080 W, (C) 10800 W, (D) 108000 W, (E) , Leave your comments or Download question paper.

Question is ⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is, Options are ⇒ (A) 108 W, (B) 1080 W, (C) 10800 W, (D) 108000 W, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is
A.	108 W [Wrong Answer]
B.	1080 W [Wrong Answer]
C.	10800 W [Correct Answer]
D.	108000 W [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8085 microprocessor, how many interrupt control lines are there?
6
8
12
16

⇒ The radiation pattern of loop antenna is
circle
semicircle
elliptical
cardoid or Limacon

⇒ As compared to their values in free space
velocity of electric wave in dielectric is smaller but wave length of electric wave is more
both velocity and wave length of electric wave in dielectric are higher
both velocity and wave length of electric wave in dielectric are smaller
wave length of electric wave is less but velocity is more in dielectric

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ In a system using QASK and 4 bits to form a symbol, the required bandwidth is
same as BPSK
half of that in BPSK
one-fourth of that in BPSK
none of the above

⇒ A series resonant circuit is fed by a voltage having rms value V. At resonance, the voltage across inductance V_L and voltage across capacitance V_C are related as
V_L > V_C
V_L < V_C
V_L = V_C
V_L = 0.5 V_C

⇒ In a square law modulator, the carrier frequency should be __________ times than the highest modulating frequency.
1
2
4
3

⇒ A variable reluctance tachometer has 180 teeth on rotor. The speed of shaft on which it is mounted in 1200 rpm. The frequency of output pulses is
1800 per second
3600 per second
4800 per second
5600 per second

⇒ When a wave is incident from the more dense into a less dense medium at an angle equal to or exceeding the critical angle, the wave suffers total internal __________ .
reflection
refraction
transmission
none of the above

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ Which one of the following is a D to A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ Loading of a line means
increasing inductance of line
increasing distributed inductance of line
decreasing distributed inductance of line
decreasing inductance of line

⇒ In amplitude modulation, the magnitude of side bands is
ma/2 times the carrier amplitude, E_c
ma times the carrier amplitude, E_c
2ma times the carrier amplitude, E_c
4ma times the carrier amplitude, E_c

⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
-90°
0°
90°
-180°

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ .
maskable, non-maskable
maskable, maskable
non-maskable, non-maskable
non-maskable, maskable

⇒ Which of the following does not use the principle of change in inductance?
LVDT
Inductance displacement transducer
Strain gauge
Reluctance pick up

⇒ A virtual ground is a ground for
voltage
current
both voltage and current
voltage but not for current

⇒ A UPS contains
rectifier
inverter
either rectifier or inverter
both rectifier and inverter

⇒

Match the following:

	List I		List II
A.	IF amplifier	1.	Amplifier frequencies in the range of 100 kHz to 5 MHz.
B.	RF amplifier	2.	Current in the output flows only during a portion of the positive half of the input cycle
C.	AF amplifier	3.	Amplifier frequencies in the range of 0 Hz to 5 MHz
D.	Class operation	4.	Amplifier frequencies in the frequency range of 40 Hz to 15 kHz.

A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2
A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4

⇒ In every practical oscillator, the loop gain is slightly larger than unity and the amplitude of the oscillations is limited by the
magnitude of the loop gain
onset if non-linearity
magnitude of gain of the amplifier
feedback transmission factor

⇒

Match the following:

	List I		List II
A.	CLP	1.	Displays DOS version being used
B.	MSAV	2.	Partitions hard disk
C.	F DISK	3.	Anti-virus program
D.	VER	4.	Cleans screen

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-3, C-4, D-1
A-2, B-1, C-4, D-3

⇒ ∈_r is determined by the atomic structure of the dielectric.
TRUE
FALSE

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ Circuit shown in the figur
astable multivibrator
monostable multivibrator
VCO
ramp Generator

⇒ In what range should Re(s) remains so that Laplace transform of the function e^{(a + 2)t + 5} exists?
Re(s) > a + 2
Re(s) > a + 7
Re(s) < a
Re(s) > a + 5

⇒ In a bridge inverter
an output transformer is essential
an output transformer is not essential
an output transformer cannot be connected
an output transformer, if used, can improve the efficiency of the circuit

⇒ If we connect two silicon unilateral switches in anti- parallel we get
SCR
SBS
SCS
UJT

⇒ For a Mod 64 parallel counter we need
6 flip flops
6 flip flops and 2 AND gates
6 flip flops and 4 AND gates
none of the above

⇒ DS directive in 8085
forces the assembler to reserve one byte of memory
forces the assembler to reserve a specified number of bytes in the memory
forces the assembler to reserve a specified number of consecutive bytes in the memory
none of the above