Question is ⇒ For a core having a relative permeability μr, magnetic dipole moment per unit volume M and field strength H, the flux density B is, Options are ⇒ (A) B = μr (H + M), (B) B = μ0 (H + M), (C) B = μ0μr (H + M), (D) B = μ0μr (H - M), (E) , Leave your comments or Download question paper.

Question is ⇒ For a core having a relative permeability μr, magnetic dipole moment per unit volume M and field strength H, the flux density B is, Options are ⇒ (A) B = μr (H + M), (B) B = μ0 (H + M), (C) B = μ0μr (H + M), (D) B = μ0μr (H - M), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a core having a relative permeability μ_r, magnetic dipole moment per unit volume M and field strength H, the flux density B is
A.	B = μ_r (H + M) [Wrong Answer]
B.	B = μ₀ (H + M) [Correct Answer]
C.	B = μ₀μ_r (H + M) [Wrong Answer]
D.	B = μ₀μ_r (H - M) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
5.85 V
6 V
5 V
10 V

⇒ A binary adder has
one half adder
one half adder and 2 full adders
two half adders
one half adder and many full adders

⇒ If B = 4 + j3, (B)^1/3 =
2 ∠30°
2 ∠36.87°
1.71 ∠12.3°
1.71 ∠30°

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ If the intrinsic resistivity at 300°K is 0.37 ohm-m and the electron and hole mobilities at 300°K are 0.28 and 0.15 m²/volt-sec, then the intrinsic carrier concentration of Germanium is __________ .
2.92 x 10¹⁹/m³
2.92 x 10^-19/m³
1.92 x 10¹⁹/m³
3.92 x 10¹⁹/m³

⇒ 4 bit 2's complement representation of a decimal number is 1000. The number is
8
0
-7
-8

⇒ The number of computer viruses is some thousands.
TRUE
FALSE

⇒ If a signal g(t) has energy E, then the energy of the signal g(2t) is equal to ...
E/2
E/4
E
2E

⇒ In figure the rms valu
5
2.5
2.5
50

⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil
fixed at 0 and 1 respectively
X = 1010.......and Y = 0101........
X = 1010..........and Y = 1010
fixed at 1 and 0 respectively.

⇒ In 8086
the registers SI and DI are used for string operation
the registers CS and DS are used for string operation
the registers SS and ES are used for string operation
the registers SI and SP are used for string operation

⇒ In Bode plots, frequency is plotted on log scale.
TRUE
FALSE

⇒ The voltage of the source in circuit shown __________ if i(t) = - 20e^{-2t46.6 e^-2t
47 e^-2t
50 e^-2t
0}

⇒ A negative feedback can be of
2 types
3 types
4 types
only 1 type

⇒ In a moving iron voltmeter the coil has a resistance of 20 Ω and an inductance of 0.3 H. The swamping resistance in 2000 Ω. To ensure correct reading with dc as well as 50 Hz ac, the value of capacitor to be connected in parallel with swamping resistance should be
0.0125 μF
0.0311 μF
0.0521 μF
0.0622 μF

⇒ Circular polarized waves result when
magnitudes are the same
phases are the same
magnitudes are same and phase difference is 90°
magnitudes are same and phase difference is zero

⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
15.58 x 10⁶
15.58 kHz
1.58 x 10³
None of the above

⇒ A parallel plate capacitor has its length, width and separation doubled. It fringing effects are neglected, to keep the capacitance same, the dielectric constant must be
halved
kept the same
doubled
made 4 times

⇒ Which device has internal positive feedback?
Two cavity klystron amplifier
Multi-cavity klystron amplifier
Reflex klystron amplifier
All of the above

⇒ In the given figure the reflection coefficient at source en
1
-1
42738
-1/3

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the value of propagation constant P will be
15.9 radians/km
31.8 radians/km
63.6 radians/km
105.4 radians/km

⇒

Assertion (A): In Darlington pair, the overall β is product of individual β_s

Reason (R): The voltage gain of a base driven amplifier is equal to ac collector voltage divided by ac base voltage

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In figure the output V₀
2V₁ + V₂ - 2V₃
2(V₁ + V₂) - V₃
V₁ + V₂ + V₃
V₁ + 2V₂ - V₃

⇒ A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make
1200 revolutions
1800 revolutions
2100 revolutions
2400 revolutions

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A signal g(t) = A then g(t) is a
energy signal
power signal
neither energy nor power signal
insufficient data

⇒ Which of the following real variable names is not valid in Fortran?
BETA
ALPHA
A
AB * 2

⇒ If a sample of germanium and a sample of silicon have the same impurity density and are kept at room temperature
both will have equal value of resistivity
both will have equal negative resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than that of germanium

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above