Question is ⇒ Which of the following directives in 8085 causes two bytes to be reserved in the memory?, Options are ⇒ (A) D S, (B) D B, (C) D W, (D) E Q U, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following directives in 8085 causes two bytes to be reserved in the memory?, Options are ⇒ (A) D S, (B) D B, (C) D W, (D) E Q U, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following directives in 8085 causes two bytes to be reserved in the memory?
A.	D S [Wrong Answer]
B.	D B [Wrong Answer]
C.	D W [Correct Answer]
D.	E Q U [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about
1000 V
200 V
50 V
1 V

⇒ How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?
0.5 A
1.5 A
0.0833333333333333
0.125

⇒

Assertion (A): Direct coupled amplifiers are rarely used

Reason (R): Direct coupled amplifiers suffer from the disadvantage of drift

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The transient currents are due to
resistance of the circuit
impedance of the circuit
voltage applied to the circuit
changes in stored energy in inductors and capacitors

⇒ The circuit in figure, is to be scaled to an impedance level of 5kΩ and resonant frequency of 5 x 10⁶ rad/sec. The possible combination of R, L,
2.5Ω, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 μF
5 kΩ, 0.1 mH, 0.4 μF

⇒ In the circuit shown in the given figure, the current flowing through resistance of 100 Ω woul
8 mA
10 mA
20 mA
100 mA

⇒ 6 bytes means
6 bits
24 bits
48 bits
96 bits

⇒ Master control facility (MCF) for INSAT-2 series satellites is located at
Madras
New Delhi
Leh
Hassan

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒

Assertion (A): In a power divider S_H = 0, S₂₁ = 0.707 = S₃,

Reason (R): In a power divider the input port (i.e., port 1) is matched and incident power is equally divided in output ports 2 and 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A 1 ms pulse can be stretched to 1 sec pulse by using
an astable multivibrator
a monostable multivibrator
a bistable multivibrator
a Schmitt trigger circuit

⇒ A 3 phase series inverter has
12 thyristors
6 thyristors
3 thyristors
3 or 6 thyristors

⇒ An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is
1/11 kΩ
1/5 kΩ
5 kW
11 kW

⇒ The number of cells in a 4 variable K map is
16
8
4
32

⇒ E_G for silicon is 1.12 eV and that for germanium is 0.72 eV. Therefore, it can be concluded that
the conductivity of silicon will be less than that of germanium at room temperature
the conductivity of silicon will be more than that of germanium at room temperature
the conductivity of two will be same at 60°C
the conductivity of two will be same at 100°C

⇒ An audio signal (say from 50 Hz to 10000 Hz) is frequency translated by a carrier having a frequency of 10⁶ Hz. The values of initial (without frequency translation) and final (after frequency translation) fractional change in frequency from one band edge to the other are
200 and 1.01
200 and 10.01
200 and 100.1
200 and 200

⇒ In sign magnitude numbers,
the leading bit stands for the sign
the leading bit is part of the magnitude
the leading bit is always 0
the leading bit is always 1

⇒ The IF frequencies in a TV receiver
38.9 MHz for video and 33.4 MHz for audio
38.9 MHz for both video and audio
33.4 MHz for both video and audio
33.4 MHz for video and 38.9 MHz for audio

⇒ When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications
22 K, ± 11%, 1/2 Ω
22 K, ± 5.5%, 1/2 Ω
22 K, ± 5.5%, 1/8 Ω
none of these

⇒ A tweeter should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ The materials having low retentivity are suitable for making
temporary smagnets
weak magnets
permanent magnets
both temporary and permanent magnets

⇒ In using mesh current method it is necessary that at least one mesh current links every element.
TRUE
FALSE

⇒ Which of the following periodic waveforms will have only odd harmonics of sinusoidal wavef
1 and 2
1 and 3
1 and 4
2 and 4

⇒ In a thermocouple temperature transducer, the output voltage is usually measured by
high resistance ammeter
high resistance voltmeter
high resistance milli-voltmeter
none of the above

⇒ The primary function of lag compensator is to provide sufficient
gain margin
phase margin
both gain margin and phase margin
either (a) or (b)

⇒

Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The resonant frequency of a series resonant circuit is
arithmetic mean of half power frequencies
independent of inductance of the circuit
independent of capacitance of the circuit
geometric mean of half power frequencies

⇒ Which of the following plot can be directly used to determine β?
V_CE versus i_C for constant I_B
V_BE versus i_B for constant V_CE
V_CB versus i_C for constant I_B
All of the above

⇒ If poles lie in first quadrant, damping ratio is
1
more than 1
less than 1
zero