Question is ⇒ Which one of the following is the correct statement of the system characterized by the equation y(t) = ax(t) + b?, Options are ⇒ (A) linear for any value of b, (B) linear if b > 0, (C) linear if b < 0, (D) non-linear, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following is the correct statement of the system characterized by the equation y(t) = ax(t) + b?, Options are ⇒ (A) linear for any value of b, (B) linear if b > 0, (C) linear if b < 0, (D) non-linear, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following is the correct statement of the system characterized by the equation y(t) = ax(t) + b?
A.	linear for any value of b [Wrong Answer]
B.	linear if b > 0 [Wrong Answer]
C.	linear if b < 0 [Wrong Answer]
D.	non-linear [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit of fi
V_a would always lag V_b
V_a would always lead V_b
V_a and V_b can be in phase
phase angle between V_a and V_b would always be 90°

⇒ The basic shift register operations are
serial in - serial out
serial in - parallel out
parallel in - serial out
all of the above

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ A half adder can be used only for adding
1 s
2 s
4 s
8 s

⇒ In the given figure, of potentiometer V₀ = V_i (R₀/R_i) only
R_L = 0
R_L = ∞
R_L is neither low nor high
R_L is low but not zero

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒ If f is more than f_unity the gain of op-amp becomes less than 1.
TRUE
FALSE

⇒ Figure shows the self bias circuit for CE amplifier and its equivalent circuit. V_BB and R_B respectively
10 V and 4 k ohm
5 V and 4 k ohm
2 V and 4 k ohm
2 V and 10 k ohm

⇒ In the circuit below, the diode is ideal. The voltage V is give
min(V_i, 1)
max(V_i, 1)
min (-V_i, 1)
max (-V_i, 1)

⇒ In a 7 segment display the segments a, c, d, f, g are lit. The decimal number displayed will be
9
5
4
2

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ In figure the rms valu
5
2.5
2.5
50

⇒ The unit for mmf is
A
Wb
T
V

⇒ Which of the following oscillator is generally not used at VHF?
Colpitts oscillator
Clapp oscillator
Armstrong oscillator
Ultra Audio oscillator

⇒ Which addressing mode is suitable only for these instructions in which there is only one operand?
Implicit
Register
Direct
Immediate

⇒ A 4 bit down counter can count from
0000 to 1111
1111 to 0000
000 to 111
111 to 000

⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are
electrons, drift
holes, drift
holes, diffusion
electrons, diffusion

⇒ The series 54 H/74 H denotes
Standard TTL
High speed TTL
Low Power TTL
High Power TTL

⇒

Assertion (A): Double Kelvin's bridge is used to measure low resistances.

Reason (R): In low resistance, the contact and lead resistances are very important.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r^-n is
absolutely integrable
absolutely summable
unity
< 1

⇒ An accelerometer has a seismic mass of 0.05 kg and spring constant of 3 x 10⁵ N/m. If maximum displacement of mass is ± 1 mm, the maximum acceleration which can be measured is
30 m/s²
60 m/s²
90 m/s²
120 m/s²

⇒ Reflex klystron oscillator is essentially a low power device
TRUE
FALSE

⇒ The typical squelch circuit
cuts off IF amplifier when AGC is minimum
cuts off IF amplifier when AGC is maximum
cuts off audio amplifier when carrier is absent
eliminates RF interference when signal is weak

⇒ A UJT exhibits negative resistance characteristics when
Current is less than valley current
Current is less than peak current
Current is more than peak current but less than valley current
None of the above

⇒ The relative permeability of a ferromagnetic material is
1
less than 1
about 10
1000 or more

⇒ In figure, E = 1 V (rms value). The average power is 250 mW. Then phase angle between E and
90°
60°
45°
30°

⇒

Assertion (A): A semiconductor strain gauge is more accurate than a resistance strain gauge.

Reason (R): The gauge factor of a semiconductor strain gauge is about 100 where as the gauge factor of a resistance strain gauge is only about 2.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The minimum gate source voltage that creates the n-type inversion layer is called
cut off voltage
on voltage
threshold voltage
zener voltage

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE