Question is ⇒ The primary constants of a transmission line are, Options are ⇒ (A) R and L, (B) R, L and C, (C) R and C, (D) R, L, G and C, (E) , Leave your comments or Download question paper.

Question is ⇒ The primary constants of a transmission line are, Options are ⇒ (A) R and L, (B) R, L and C, (C) R and C, (D) R, L, G and C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The primary constants of a transmission line are
A.	R and L [Wrong Answer]
B.	R, L and C [Wrong Answer]
C.	R and C [Wrong Answer]
D.	R, L, G and C [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements regarding the class-B power amplifiers (Complementary symmetry type):

The efficiency of the amplifier is higher than that of class-A amplifier
The power output is low
Crossover distortion is present
The standby power dissipation is absent.

Which of the above statements are correct?
1, 2 and 3
1, 2 and 4
1, 3 and 4
2, 3 and 4

⇒

Assertion (A): Chopper always requires forced commutation

Reason (R): Morgan chopper uses a saturable reactor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In 8085 microprocessor, if instruction RST is written in a program then the program will jump to location
0020 H
0024 H
0028 H
002 CH

⇒ A MOSFET has a threshold voltage of 1 V and oxide thickness of 500 x 10^-8 [ε_r = 3.9; ε₀ = 8.85 x 10^-14 F/cm, q = 1.6 x 10^-19 c]. The region under the gate is ion implanted for threshold voltage tailoring. The base and type of impant required to shift threshold voltage to - 1 V are __________ .
8.6 x 10¹¹/cm², p-type
8.6 x 10¹¹/cm², n-type
0.86 x 10⁹/cm², p-type
1.02 x 10¹²/cm², n-type

⇒ In a CE amplifier
both ac and dc load lines have the same slope
the ac load line has more slope than dc load line
the ac load line has less slope than dc load line
the two load lines may have slope more than the other

⇒ An interrupt in which the external device supplies its address as well as the interrupt is known as
vectored interrupt
maskable interrupt
polled interrupt
non-maskable interrupt

⇒ The tuned circuit of the oscillator in a simple AM transmitter employs a 50 H coil and a 1 nanofarad capacitor. If the oscillator output is the carrier frequency will be
448 kHz
555 kHz
625 kHz
712 kHz

⇒ Which of these devices can conduct in both directions?
SCR
SUS
SBS
UJT

⇒ The resistance of a metallic wire would
increase as f increase
decrease as f increase
remains the same at all frequencies
increase with f up to a certain frequency and then decrease

⇒ The impedance of a coil above self-resonant frequency is
inductive
capacitive
resistive
none

⇒ As the frequency is increased, the charging MVAR in a cable
decreases
increases
remain the same
decreases or remains the scheme

⇒ A sample of N type semiconductor has an electron density of 6.25 x 10¹⁸/cm³ at 300 K. If intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density is
10⁶ / cm³
10⁸ / cm³
10¹⁰ / cm³
10¹² / cm³

⇒ Two numbers are 131 ± 5 and 629 ± 3. The sum of the numbers with range of doubt is
760 ± 8
760 ± 2
760 + 8
760 - 8

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ In molecules of ionic crystals, orientation polarization is zero.
TRUE
FALSE

⇒ The minimum sampling frequency in sample/sec. required to reconstruct the following signal from its samples wuthout distor
2 x 10³
4 x 10³
6 x 10³
8 x 10³

⇒ A zero mean white Gaussian noise is passed through an ideal low pass filter of bandwidth 10 kHz. The output of the samples so obtained would be
correlated
statistically independent
uncorrelated
orthogonal

⇒ In the expression A + BC, the total number of minterms will be
2
3
4
5

⇒ The semi-conductor type 2 N 34 indicates
a n-channel MOSFET
a JFET
a diode with two electrodes
a diode with three electrodes

⇒ The log magnitude plot of the given figure is
type 0 system
type 1 system
type 2 system
either type 0 or type 1 system

⇒ If word length is 16 bits the decimal equivalent of largest number which can be stored is
32767
32766
16383
16384

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒ Which of the following identifiers is invalid in Pascal?
BETA
MAX 40
2ND
A MAX

⇒

Match the following:

	List I (Electron spin)		List II (Phenomenon)
A.	↑↑↑↑	1.	Antiferromagnetism
B.	↑↓↑↓	2.	Ferrimagnetism
C.	↑↓↑↓	3.	Ferromagnetism

A-1, B-2, C-3
A-3, B-2, C-1
A-2, B-3, C-1
A-3, B-1, C-2

⇒ Quantization noise occurs in
PAM
DM
PWM
PPM

⇒ In the given figure, if R = X_C, voltage gai
0 dB
3 dB
-3 dB
20 dB

⇒ In end fire array the principle direction of radiation
is perpendicular to the array axis
is perpendicular to the array axis and also to the plane containing the array elements
coincides with the direction of the array
is at 45° to the direction of array axis

⇒ KCL is a statement of principle of conservation of energy.
TRUE
FALSE

⇒ Calculate the electrostatic force of repulsion between two mica particles at a distance of 10^-13 m from each other. Charge on a particle is 3.2 x 10^-19 C. (relative permittivity for mica is 5)
1.843 x 10^-15 N
9.2 x 10^-2 N
14.41 x 10^-9 N
none of these

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What value of feedback will double the gain?
0.005
0.0066
0.01
0.033